Examination of work before covering up In respect of the work which the Authority’s Engineer is entitled to examine, inspect, measure and/or test before it is covered up or put out of view or any part of the work is placed thereon, the Contractor shall give notice to the Authority’s Engineer whenever any such work is ready and before it is covered up. The Authority’s Engineer shall then either carry out the examination, inspection or testing without unreasonable delay, or promptly give notice to the Contractor that the Authority’s Engineer does not require to do so. Provided, however, that if any work is of a continuous nature where it is not possible or prudent to keep it uncovered or incomplete, the Contractor shall notify the schedule of carrying out such work to give sufficient opportunity, not being less than 3 (three) business days’ notice, to the Authority’s Engineer to conduct its inspection, measurement or test while the work is continuing. Provided further that in the event the Contractor receives no response from the Authority’s Engineer within a period of 3 (three) business days from the date on which the Contractor’s notice hereunder is delivered to the Authority’s Engineer, the Contractor shall be entitled to assume that the Authority’s Engineer would not undertake the said inspection.
What Will Happen After We Receive Your Letter When we receive your letter, we must do two things:
Happen After We Receive Your Letter When we receive your letter, we must do two things:
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Requirement to Commence Work The Contractor shall under all circumstances commence work under this Contract no later than ten days after the Proceed Order Date of the Proceed Order.
Prevailing Wage Requirements California Labor Code and/ or Resolutions of the San Xxxx City Council require the payment of not less than the general prevailing rate of per diem wages and rates for holiday and overtime and adherence to all labor standards and regulations. The General Prevailing Wage Rates may be adjusted throughout the term of this Agreement. Notwithstanding any other provision of this Agreement, Contractor shall not be entitled to any adjustment in compensation rates in the event there are adjustments to the General Prevailing Wage Rates.
Requirement to Work Reasonable Overtime The Employer may require any Employee to work reasonable overtime at overtime rates and such an Employee shall work overtime in accordance with the requirement.
Teacher Work Day The term of contract for employees shall be one hundred ninety (190) days (maximum one hundred eighty (180) student days). Any extension of the term of contract shall be paid in full day increments and be paid at the rate of one-one hundred ninetieth (1/190) of the regular salary of the employee. The maximum daily hours of work for employees shall be 465 continuous minutes and shall include a minimum of thirty (30) minutes continuous, duty-free lunch period. No more than 375 minutes shall be student contact time. The teaching staff will receive one full day at the end of each quarter to be used in preparation of grades for report cards and conferences. The hours of work for all professional employees shall be 8:00 a.m. to 3:30 p.m., four (4) days a week, with the exception of days on which staff meetings are held, grades are prepared, and staff in- service days. Sixty (60) minutes will be used for collaboration on Wednesday mornings from 7:00 a.m. to 8:00 a.m. The hours of work for all professional employees on Wednesdays shall be 7:00 a.m. to 3:30 p.m., with the exception of days on which staff meetings are held, grades are prepared, and staff in-service days. Assignment of students for a new school year to classrooms and schedules shall be done in a fair and equitable manner to promote a variety of strengths, needs and equal numbers of each classroom. The Administration shall make reasonable effort to ensure that assignments are made collaboratively, considering such issues as special needs, behavior, attendance and academic levels. Collaborative input may include regular and special education staff, para-educators, teaching specialist and administrators. In the event of a change in the student day, the Association will be informed of such change and given an opportunity to respond, provided, however, that exceptions to this section may occur in the event of emergencies or acts of God. The District shall make every reasonable effort to increase the amount of collaboration time available to professional employees within the normal work day. Xxx Xxxxxxxx shall make every reasonable effort to ensure equitable workload distribution and student contact time amongst staff members.
CHILD AND DEPENDENT ADULT/ELDER ABUSE REPORTING CONTRACTOR shall establish a procedure acceptable to ADMINISTRATOR to ensure that all employees, agents, subcontractors, and all other individuals performing services under this Agreement report child abuse or neglect to one of the agencies specified in Penal Code Section 11165.9 and dependent adult or elder abuse as defined in Section 15610.07 of the WIC to one of the agencies specified in WIC Section 15630. CONTRACTOR shall require such employees, agents, subcontractors, and all other individuals performing services under this Agreement to sign a statement acknowledging the child abuse reporting requirements set forth in Sections 11166 and 11166.05 of the Penal Code and the dependent adult and elder abuse reporting requirements, as set forth in Section 15630 of the WIC, and shall comply with the provisions of these code sections, as they now exist or as they may hereafter be amended.
Discussions Before Termination (a) Where an employer has made a definite decision that the employer no longer wishes the job the employee has been doing done by anyone and this is not due to the ordinary and customary turnover of labour and that decision may lead to termination of employment, the employer shall hold discussions with the employees directly affected and with his/her union, where applicable.
