Bidding Equipment Sample Clauses

Bidding Equipment. Bidding of trucks, unless mutually agreed otherwise, is subject to seniority and shall be posted for bid. Posting shall be at a conspicuous place so that all eligible employees will receive notice of the truck available for bid, and such posting of bids shall be made not more than once each year unless mutually agreed. Trucks shall be put up for bid once each year. The date for the yearly general bid shall be mutually agreed by the Local Union and the Employer involved. When new trucks are added to the fleet, they shall be open for bid on a seniority basis unless mutually agreed otherwise. When there is a permanent change in the mating of a truck and trailer it will be rebid. Disputes under this Section are subject to the grievance machinery.
Sample 1
AutoNDA by SimpleDocs
Bidding Equipment. Bidding of trucks, unless mutually agreed otherwise, is subject to seniority and shall be posted for bid. Posting shall be at a conspic- uous place so that all eligible employees will receive notice of the truck available for bid, and such posting of bids shall be made not more than once each year unless mutually agreed. Trucks shall be put up for bid once each year. The date for the yearly general bid shall be mutually agreed by the Local Union and the Employer in- volved. When new trucks are added to the fleet, they shall be open for bid on a seniority basis unless mutually agreed otherwise. When
Sample 1

Related to Bidding Equipment

  • New Equipment Where new types of equipment and/or operations, for which rates of pay are not established by this Agreement, are put into use after the ratification date of this Agreement within operations covered by this Agreement, rates governing such operations shall be subject to negotiations between the parties. This paragraph shall apply to all new types of equipment including office and clerical equipment. In the event agreement cannot be reached within sixty (60) days after the date such equipment is put into use, the matter may be submit- xxx to the National Grievance Committee for final disposition. Rates agreed upon or awarded shall be effective as of the date equipment is put to use.

  • Monitoring Equipment 2.2.1 24-hour TSP air quality monitoring was performed using High Volume Sampler (HVS) located at each designated monitoring station. The HVS meets all the requirements of the Project Specific EM&A Manual. Portable direct reading dust meters were used to carry out the 1-hour TSP monitoring. Brand and model of the equipment is given in Table 2.1.

  • Additional Equipment Additional Equipment may from time to time be added as the subject matter of this Agreement as agreed on by the parties. Any additional property will be added in an amendment describing the property, the monthly rental, security deposit, and stipulated loss value of the additional Equipment. All amendments must be in writing and signed by both parties. Other than by this amendment procedure, this Agreement may not be amended, modified, or altered in any manner except in writing signed by both parties.

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • Rental Equipment 7.1 We will at all times own all Rental Equipment supplied to you. You will not let, sell, charge, assign, sub-license or allow a third party to use the Rental Equipment nor remove any labels, and shall not prejudice our rights in the Rental Equipment in any way. We may replace the Rental Equipment from time to time either with your prior consent or provided that the replacement Rental Equipment is of a specification that is at least equal to the Rental Equipment originally supplied and such change does not materially disrupt the provision of the Services.

Time is Money Join Law Insider Premium to draft better contracts faster.