Bridge Design Hydraulic Study / Location Hydraulic Study Sample Clauses

Bridge Design Hydraulic Study / Location Hydraulic Study. This task covers the work for the hydraulic subconsultant to prepare the final pre- and post-project hydraulic modeling, with an emphasis on identifying the post-project bridge hydraulics within the Folsom South Canal and Buffalo Creek. Final anticipated scour depths will be reported to the bridge design team to aid in the design of bridge abutments and foundations. Bridge hydraulics will be summarized in a formal Bridge Design Hydraulics Study (BDHS). Building off the information gathered during the PA&ED phase, the hydraulic subconsultant will prepare a draft and final LHS that summarizes the impacts (if any) due to the encroachment and places the overall project in context with respect to flood control issues. The draft LHS will be submitted for review, comment and approval. Comments and suggested edits will be included in a final LHS. This scope of work assumes that a formal conditional and final Letter of Map Revision (CLOMR and LOMR) submittal to FEMA is not required.
Sample 1
AutoNDA by SimpleDocs

Related to Bridge Design Hydraulic Study / Location Hydraulic Study

  • Programming Phase 2.2.1.2. Schematic Design Phase: 2.2.1.3. Design Development Phase:

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Provisioning of High Frequency Spectrum and Splitter Space 3.2.1 BellSouth will provide <<customer_name>> with access to the High Frequency Spectrum as follows:

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • Schematic Design Phase Services § 3.2.1 The Architect shall review the program and other information furnished by the Owner, and shall review laws, codes, and regulations applicable to the Architect’s services.

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • Joint Network Implementation and Grooming Process Upon request of either Party, the Parties shall jointly develop an implementation and grooming process (the “Joint Grooming Process” or “Joint Process”) which may define and detail, inter alia:

  • Synchronization, Commissioning and Commercial Operation 4.1.1 The Power Producer shall give at least thirty (30) days written notice to the SLDC and GUVNL, of the date on which it intends to synchronize the Power Project to the Grid System.

  • ROAD WORK PHASE APPROVAL Purchaser shall obtain written approval from the Contract Administrator upon completion of each of the following phases of road work:  Drainage installation  Subgrade compaction  Rock compaction SUBSECTION RESTRICTIONS

  • FABRICATION Making up data or results and recording or reporting them.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!