Bumping Routes. If a driver’s/monitor’s leaves the District after assignments are given, then that driver/monitor’s route will be open to other drivers/monitors by seniority.
Bumping Routes Sample Clauses
Related to Bumping Routes
Routes All bus stops and bus routes will be mutually agreed upon prior to the start of the school year. Additional stops will be not be added until approved by SSAS and reviewed for safety and approved by the School Board’s Transportation Department. Route changes, if approved, will require 7 calendar days from the date of request to the date of implementation. Special needs transportation requests must be made a minimum of 14 days prior to the requested date of implementation.
Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.
Bumping The employee scheduled for layoff under Section D. may elect to either accept layoff or bump in accordance with the process outlined in this Section. An employee scheduled for layoff who fails or is unable, in accordance with Section D.3., to exercise the option to bump to the least senior position shall be laid off. Within seven calendar days of receipt of notification of layoff, the employee scheduled for layoff shall notify the Employer of his/her decision to either accept layoff or bump within his/her current class series, as listed below. Alternatively, an employee may bump into the least senior position in the layoff unit in a former class series at or below any level at which the employee had satisfactorily completed the required probationary period. This alternative shall not apply to employees who were demoted from the higher paying class for disciplinary reasons or who transferred from the higher paying classification in less than satisfactory employment status. An employee seeking to bump into another position must meet all requirements in accordance with Section D.3. As a result of bumping, an employee shall not earn more than the maximum rate of the lower classification bumped into or more than the rate previously earned in a higher classification from which the employee bumped. When an employee bumps downward, he/she shall be paid at that step in the lower level pay range which credits the service in the higher level range(s) to the step at which the employee was paid when promoted from a lower level. Corrections Medical Aide Corrections Medical Officer 8 Corrections Medical Officer E9 Corrections Medical Unit Officer E10 Corrections Officer Corrections Officer 8 Corrections Officer E9 Resident Unit Officer 10 Forensic Security Aide Forensic Security Assistant 8 Forensic Security Assistant 9 Forensic Security Assistant E10 Special Alternative Incarceration Officer Special Alternative Incarceration Officer 9 Special Alternative Incarceration Officer E10 Bump process--after the parties have identified the layoff unit: 1. The Employer shall identify the vacancies and least senior employees within the layoff unit equal to the number of positions being abolished within the layoff unit. These least senior employees shall be issued layoff notices. 2. If the layoff unit contains more than one work location, employees remaining in the layoff unit who are displaced from their original work location (due to the closure, reduction consolidation, etc.), will be placed in existing vacancies or the vacated positions identified in step 1 above. Placement into these positions shall be in seniority order based on preferences provided by the employees. 3. Employees remaining in the layoff unit may request an exchange transfer (one for one transfer) with any bargaining unit member in the same classification in accordance with Article 15 Part D §A.6., either within or outside the layoff unit. Exchange transfers shall not be unreasonably denied and will be processed with the rest of the layoff unit moves, if possible. In addition, during the bump process, exchange transfers occurring within this Article shall supersede all other closer to home and seniority based transfers or recalls, as no vacancy exists. Requests for exchange transfers shall be in writing by both employees requesting to exchange. 4. The parties may reach mutual agreement to modify the process to minimize impact on affected employees as necessary.
Bumping Procedure In the application of this Article, permanent part-time employees cannot displace permanent full-time employees or vice versa provided that permanent full-time employees who have exhausted their bumping rights hereunder and are to be laid off from work shall have the right to displace a permanent part-time employee with lesser GO seniority, within their section. Such bumping within the section may only be in a downward or lateral direction provided they are qualified, willing and able to do the work (refer to Schedule “E-I” and “E-I OFPT”). Downward shall be defined as lesser pay per hour and/or lesser hours per week (permanent full-time vs. permanent part-time). Lateral shall be defined as same pay per hour. In the application of this Article, permanent part-time employees cannot displace permanent full-time employees or vice versa provided that permanent full-time employees who have exhausted their bumping rights hereunder and are to be laid off from work, shall have the right to displace any permanent part-time employee with lesser GO Transit seniority, within their section provided they are able, willing and qualified. Due to the nature of the bumping procedure and the unpredictability of the direction and results of that bumping, the layoff must take precedent over all other normal movement of employees (i.e., standing applications). During layoffs an employee may choose to accept an open position for which he/she is qualified rather than bumping within their classification or section and should he/she elect this option, they shall retain recall rights to the original classification without loss of seniority. Where an OFPT employee who has been notified or is on layoff and currently possesses the qualifications and skills of a position they have held previously, then the employee may bump laterally or downward within their section or another section where the previously held position is identified. At the time of layoff the employee must satisfy the criteria identified in the current job description, and the employee must have satisfied the performance standards of that classification. Should the parties agree that the bumping procedure will likely cause significant movement within a classification or section, then the parties may agree to have a “master” sign-up take place which will be the sole responsibility of the Union to administer.
Bumping Rights An employee laid off from his/her present class may bump only into the next equal or lower class in which the employee has greater seniority. The employee may continue to bump into such equal or lower classes to avoid layoff.
Service Areas HHSC authorizes the MA Dual SNP to add the MA Product to Texas service areas that are not identified in Attachment C, Proposed MA Product Service Areas, provided it receives prior CMS approval and complies with the notice requirements specified in this Agreement.
Signaling protocol The Parties will interconnect their networks using SS7 signaling where Technically Feasible and available as defined in GR 905 Telcordia Standards including ISDN User Part (ISUP) for trunk signaling and TCAP for CCS-based features in the Interconnection of their networks. All Network Operations Forum (NOF) adopted standards shall be adhered to. Where available, CenturyLink signaling services to link its Signaling Transfer Points (STPs) for CLEC switches which connect to CenturyLink’s STPs via “A” links or for CLEC’s STPs to connect to CenturyLink’s STPs via “D” links which are dedicated to the transport of signaling for local Interconnection, may be ordered from the CenturyLink Tariff.
Signaling Each Party will provide the other Party with access to its databases and associated signaling necessary for the routing and completion of the other Party’s traffic in accordance with the provisions contained in the Unbundled Network Element Attachment or applicable access tariff.
Local Switching 4.1.1 BellSouth shall provide non-discriminatory access to local circuit switching capability, and local tandem switching capability, on an unbundled basis, except as set forth below in Section 4.1.
Unbundled Channelization (Multiplexing) 5.7.1 To the extent NewPhone is purchasing DS1 or DS3 or STS-1 Dedicated Transport pursuant to this Agreement, Unbundled Channelization (UC) provides the optional multiplexing capability that will allow a DS1 (1.544 Mbps) or DS3 (44.736 Mbps) or STS-1 (51.84 Mbps) Network Elements to be multiplexed or channelized at a BellSouth central office. Channelization can be accomplished through the use of a multiplexer or a digital cross-connect system at the discretion of BellSouth. Once UC has been installed, NewPhone may request channel activation on a channelized facility and BellSouth shall connect the requested facilities via COCIs. The COCI must be compatible with the lower capacity facility and ordered with the lower capacity facility. This service is available as defined in NECA 4. 5.7.2 BellSouth shall make available the following channelization systems and interfaces: 5.7.2.1 DS1 Channelization System: channelizes a DS1 signal into a maximum of twenty- four (24)
