Utility Additions Lessor reserves the right to install new or additional utility facilities throughout the Office Building Project for the benefit of Lessor or Lessee, or any other lessee of the Office Building Project, including, but not by way of limitation, such utilities as plumbing, electrical systems, communication systems, and fire protection and detection systems, so long as such installations do not unreasonably interfere with Lessee's use of the Premises.
Utility Adjustments DB Contractor shall not commence or permit or suffer commencement of construction of a Utility Adjustment included in the Construction Work until TxDOT issues NTP2, all of the conditions set forth in Section 4.4.1 that are applicable to the Utility Adjustment (reading such provisions as if they referred to the Utility Adjustment) have been satisfied, and the following additional requirements have been satisfied:
(a) If applicable, the Alternate Procedure List has been approved by FHWA, and either the affected Utility or the Utility Owner is on the approved Alternate Procedure List, as supplemented.
(b) The Utility Adjustment is covered by an executed Utility Agreement.
(c) The review and comment process has been completed and any required approvals have been obtained for the Utility Assembly covering the Utility Adjustment.
Workplace adjustment An employer wishing to employ a person under the provisions of this clause shall take reasonable steps to make changes in the workplace to enhance the employee’s capacity to do the job. Changes may involve re-design of job duties, working time arrangements and work organisation in consultation with other employees in the area.
Buildings The Employer will provide and maintain all state-owned buildings, facilities, and equipment in accordance with the specific written order(s) of the Michigan (MIOSHA) Departments of Licensing and Regulatory Affairs and/or Health and Human Services. Where facilities are leased by the Employer, the Employer shall make a reasonable attempt to assure that such facilities comply with the order(s) of the Michigan Departments of Licensing and Regulatory Affairs and/or Health and Human Services.
Volume and Additional Discounts In addition to the Part 1 Minimum Percentage Discount proposed herein, does Vendor ever expect and intend to offer additional, greater, or volume discounts to TIPS Members? If proposing on Part 1, point(s) may be assigned for your response in the Part 1 category of "Pricing" during scoring and evaluation. If you are not proposing on Part 1, you must respond to proceed but no points will be assigned for your response. Yes
Classifications 32.1 The Classification levels for Employees engaged under this agreement shall be read in accordance with the Award unless specifically amended by the terms of this Agreement. Classification levels, relativities, pay rates and other details are contained in APPENDIX 1.
32.2 An Employee not already engaged as CW4 (marker/setter) shall be paid an all-purpose allowance of 5% of his/her applicable hourly rate when performing this work.
32.3 Where any Employee on any day performs two or more classes of work to which different rates of pay are applicable, the Employee shall be paid at the higher hourly rate for the day if the Employee is required to work at that class of work for two (2) hours or more, and if for less than two (2) hours during any one (1) day the Employee will be paid the higher rate for the time so worked.
32.4 Where an Employee is elected by Employees of the Employer as a HSR and agrees to undertake the required training to fulfil the role, the Employee will be classified as the higher of CW4, or the Employee's usual classification. In addition, a HSR is entitled to an all-purpose hourly allowance for the life of this agreement as per the table at Appendix 2 – Health and Safety Representatives Allowance.
(a) For clarity, an Employee is only entitled to one all-purpose hourly allowance pursuant to clauses 32.4 and 32.5.
Ceiling Company and its subcontractors will not affix, attach, or suspend any lighting fixtures, signs, or other fixtures or devices of any kind or nature from the ceiling above any of the Premises without the prior written approval of Authority.
New Job Classifications When a new classification (which is covered by the terms of this collective agreement) is established by the Hospital, the Hospital shall determine the rate of pay for such new classification and notify the local Union of the same. If the local Union challenges the rate, it shall have the right to request a meeting with the Hospital to endeavour to negotiate a mutually satisfactory rate. Such request will be made within ten (10) days after the receipt of notice from the Hospital of such new occupational classification and rate. Any change mutually agreed to resulting from such meeting shall be retroactive to the date that notice of the new rate was given by the Hospital. If the parties are unable to agree, the dispute concerning the new rate may be submitted to arbitration as provided in the agreement within fifteen (15) days of such meeting. The decision of the arbitrator (or board of arbitration as the case may be) shall be based on the relationship established by comparison with the rates for other classifications in the bargaining unit having regard to the requirements of such classification. When the Hospital makes a substantial change in the job content of an existing classification which in reality causes such classification to become a new classification, the Hospital agrees to meet with the Union if requested to permit the Union to make representation with respect to the appropriate rate of pay. If the matter is not resolved following the meeting with the Union, the matter may be referred to arbitration as provided in the agreement within fifteen (15) days of such meeting. The decision of the arbitrator (or board of arbitration as the case may be) shall be based on the relationship established by comparison with the rates for other classifications in the bargaining unit having regard to the requirements of such classifications. The parties further agree that any change mutually agreed to or awarded as a result of arbitration shall be retroactive only to the date that the Union raised the issue with the Hospital. The parties further agree that the above process as provided herein shall constitute the process for Pay Equity Maintenance as required by the Pay Equity Act.
Location of Improvements; No Encroachments All improvements which were considered in determining the Appraised Value of the Mortgaged Property lay wholly within the boundaries and building restriction lines of the Mortgaged Property, and no improvements on adjoining properties encroach upon the Mortgaged Property. No improvement located on or being part of the Mortgaged Property is in violation of any applicable zoning law or regulation;
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification.
2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length.
2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A.
2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties.
2.5.5 Rates for ULM are as set forth in Exhibit A.
2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered.
2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned.
2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition.
2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.
