COMMAND Codes Sample Clauses

COMMAND Codes. The valid commands are: 0x01 CONFIGURE_LINK 0x02 HDLC_OPEN 0x03 HDLC_CLOSE 0x06 LINK_STATUS 0x07 READ_HDLC_STATISTICS 0x08 FLUSH_HDLC_STATISTICS 0x09 READ_COMMS_ERR_STATS 0x0A FLUSH_COMMS_ERR_STATS 0x0B SET_GLOBAL_VARIABLES 0x0C READ_MODEM_STATUS 0x0D FLUSH_HDLC_DATA_BUFFERS 0x11 HDLC_WRITE 0x12 READ_HDLC_CONFIGURATION 0x13 SET_HDLC_CONFIGURATION 0x14 OPERATE_DATALINE_MONITOR 0x15 READ_CODE_VERSION 0x14 OPERATE_DATALINE_MONITOR 0x16 READ_TRACE_DATA CONFIGURE_LINK (0x01) This command configures the Sangoma HDLC code to use the frame level addressing corresponding to a network DTE or DCE. The link is CLOSED and will not transmit frames or respond to any incoming frames until an HDLC_OPEN has been performed. All queued Information frames are flushed, the statistic variables for the link are reset and the link is disconnected. If ‘auto_HDLC’ has been enabled (set to 1) in the configuration file, then this command should not be executed, as the station will already have been configured as defined in this configuration file. Control Block values to be set on entry: BUFFER_ LENGTH: Set to 0x01. DATA: offset 0x00 is used to define the frame level addressing as follows: 0x01 - use DTE addressing. 0x02 - use DCE addressing Control Block values set on return: RETURN_ CODE: 0x00 The action has been performed successfully. 0x01 The selected operational addressing mode is invalid. 0x06, 0x07, 0x08, 0x09, 0x0A See Section "Notes on Return Codes" for further details. HDLC_OPEN (0x02) Th is c o mma n d all o w s t h e HDLC c o d e t o t r an smit f r xxxx an d t o r espo n d t o an y in c o min g f r xxxx. DTR w ill be au t o mat ic all y r aised o n c e t h e HDLC_OPEN h as been issu ed . If ‘au t o _HDLC’ h as been en abl ed in t h e c o n f ig u r a t io n f i l e, t h en t h is c o mma n d is n o t n ecc essar y, as t h e l in k w o u l d h ave been au t o mat ic all y ‘o pen ed ’ o n l o ad in g . Co n t r o l Xx x x x xxx u es t o be set o n en t r y: BUFFER_ LEN GTH: Set t o 0x 00 . Co n t r o l Xx x x x xxx u es set o n r et u r n : RETURN_ COD E: 0x 00 Th e a c t io n h as been per f o r med su cc essf u ll y. 0x 06, 0x 07, 0x 08, 0x 09, 0x 0A See Sec t io n "N o t es o n Ret u r n Co d es" f o r f u r t h er d et ail s . HDLC_CLOSE (0x03) Th i s c o mma n d c au ses t h e HDLC c o d e t o n o l o n g er sen d f r xxxx o r t o r espo n d t o in c o min g f r xxxx. Th e HDLC l in k s t at e is u n c h an g ed , bu t n o t r an smissio n s w ill o cc u r u n t i l a...
Sample 1
AutoNDA by SimpleDocs
COMMAND Codes. There are two levels of commands available when using the X.25 interface - HDLC and X.25 level commands. A limited number of the HDLC level functions are described in this document, as they may be useful in debugging any link level problems which may occur. Users wishing to fully control the HDLC link (or to interface at the HDLC level) should contact their Sangoma Technologies representative for additional interface documentation. The valid commands are:
Sample 1

Related to COMMAND Codes

  • Fire, Life Safety, and Accessibility Codes The following codes, in the versions approved by the Georgia State Fire Marshal/Fire Safety Commissioner and Department of Human Resources, shall be used. The Design Professional will designate any additional codes or special modifications in the Supplementary General Conditions.

  • Information Technology Accessibility Standards Any information technology related products or services purchased, used or maintained through this Grant must be compatible with the principles and goals contained in the Electronic and Information Technology Accessibility Standards adopted by the Architectural and Transportation Barriers Compliance Board under Section 508 of the federal Rehabilitation Act of 1973 (29 U.S.C. §794d), as amended. The federal Electronic and Information Technology Accessibility Standards can be found at: xxxx://xxx.xxxxxx-xxxxx.xxx/508.htm.

  • Technical Barriers to Trade 1. The rights and obligations of the Parties relating to standards or technical regulations and related measures shall be governed by the WTO Agreement on Technical Barriers to Trade.

  • Destination CSU-Pueblo scholarship This articulation transfer agreement replaces all previous agreements between CCA and CSU-Pueblo in Bachelor of Science in Physics (Secondary Education Emphasis). This agreement will be reviewed annually and revised (if necessary) as mutually agreed.

  • Registry Interoperability and Continuity Registry Operator shall comply with the Registry Interoperability and Continuity Specifications as set forth in Specification 6 attached hereto (“Specification 6”).

  • Committee on Technical Barriers to Trade 1. The Parties hereby establish the Committee on Technical Barriers to Trade, comprising representatives of each Party.

  • Workstation/Laptop encryption All workstations and laptops that process and/or store DHCS PHI or PI must be encrypted using a FIPS 140-2 certified algorithm which is 128bit or higher, such as Advanced Encryption Standard (AES). The encryption solution must be full disk unless approved by the DHCS Information Security Office.

  • Accreditation of Online Schools The District will implement a system of accrediting its online schools, as defined in section 22-30.7- 102(9.5), C.R.S. This system shall adhere to section 00-00-000, C.R.S., including a review of the online school’s alignment to the quality standards outlined in section 22-30.7-105(3)(b), C.R.S., and compliance with statutory or regulatory requirements, in accordance with section 22-30.7-103(3)(m), C.R.S.

  • Protocols Each party hereby agrees that the inclusion of additional protocols may be required to make this Agreement specific. All such protocols shall be negotiated, determined and agreed upon by both parties hereto.

  • Internet Safety X. Xxxxxxx and Users - Despite every effort for supervision and filtering, all Users and their parents/guardians are advised that access to the electronic Network may include the potential for access to materials inappropriate for school-aged students. Every User must take responsibility for his or her use of the Network and Internet and avoid these sites.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!