Technical Requirements 4.5.3.1 Tandem Switching shall have the same capabilities or equivalent capabilities as those described in Telcordia TR-TSY-000540 Issue 2R2, Tandem Supplement, June 1, 1990. The requirements for Tandem Switching include but are not limited to the following: 4.5.3.1.1 Tandem Switching shall provide signaling to establish a tandem connection; 4.5.3.1.2 Tandem Switching will provide screening as jointly agreed to by <<customer_short_name>> and BellSouth; 4.5.3.1.3 Where applicable, Tandem Switching shall provide AIN triggers supporting AIN features where such routing is not available from the originating end office switch, to the extent such Tandem switch has such capability; 4.5.3.1.4 Where applicable, Tandem Switching shall provide access to Toll Free number database; 4.5.3.1.5 Tandem Switching shall provide connectivity to Public Safety Answering Point (PSAP)s where 911 solutions are deployed and the tandem is used for 911; and 4.5.3.1.6 Where appropriate, Tandem Switching shall provide connectivity for the purpose of routing transit traffic to and from other carriers. 4.5.3.2 BellSouth may perform testing and fault isolation on the underlying switch that is providing Tandem Switching. Such testing shall be testing routinely performed by BellSouth. The results and reports of the testing shall be made available to <<customer_short_name>>. 4.5.3.3 BellSouth shall control congestion points and network abnormalities. All traffic will be restricted in a non-discriminatory manner. 4.5.3.4 Tandem Switching shall process originating toll free traffic received from <<customer_short_name>>’s local switch. 4.5.3.5 In support of AIN triggers and features, Tandem Switching shall provide SSP capabilities when these capabilities are not available from the Local Switching Network Element to the extent such Tandem Switch has such capability.
Compliance with Governmental Requirements Comply with all laws, ordinances, and regulations, now or hereafter in effect, of all governmental authorities applicable to the conduct of Borrower’s properties, businesses and operations, and to the use or occupancy of the Collateral, including without limitation, the Americans With Disabilities Act. Borrower may contest in good faith any such law, ordinance, or regulation and withhold compliance during any proceeding, including appropriate appeals, so long as Borrower has notified Lender in writing prior to doing so and so long as, in Lender’s sole opinion, Lender’s interests in the Collateral are not jeopardized. Lender may require Borrower to post adequate security or a surety bond, reasonably satisfactory to Lender, to protect Lender’s interest.
Compliance with Accessibility Standards All parties to this Agreement shall ensure that the plans for and the construction of all projects subject to this Agreement are in compliance with standards issued or approved by the Texas Department of Licensing and Regulation (TDLR) as meeting or consistent with minimum accessibility requirements of the Americans with Disabilities Act (P.L. 101-336) (ADA).
Compliance with Environmental Requirements 50.1 The Contractor shall provide the goods and/or Services required under the Contract in accordance with applicable laws and the Authority’s environmental policy, which is to conserve energy, water and other resources, reduce waste and phase out the use of ozone depleting substances and minimise the release of greenhouse gases, volatile organic compounds and other substances damaging to health and the environment. 50.2 The Authority is committed to promoting a low carbon, high growth, global economy. The Contractor shall work with the Authority regarding any environmental or sustainability issues as the Authority considers relevant, comply with contractual obligations and carry out any reasonable request to ensure the protection of the environment, society and the economy and promotion of sustainable development and sustainable procurement throughout the Contract Period. 50.3 All written outputs, including reports, produced in connection with the Contract shall (unless otherwise specified) be produced on recycled paper containing at least 80% post consumer waste and used on both sides where appropriate. 50.4 Nothing in this Condition 50 shall relieve the obligations of the Contractor to comply with its statutory duties and Good Industry Practice.
Compliance with TIA Every amendment, waiver or supplement of this Indenture or the Securities shall comply with the TIA as then in effect.
General Requirements The Contractor hereby agrees:
COMPLIANCE WITH GOVERNMENTAL RULES AND REGULATIONS; RECORDS The Trust assumes full responsibility for its compliance with all securities, tax, commodities and other laws, rules and regulations applicable to it.
Compliance with Applicable Laws, Rules and Regulations The Dealer Manager represents to the Company that (a) it is a member of FINRA in good standing, and (b) it and its employees and representatives who will perform services hereunder have all required licenses and registrations to act under this Agreement. With respect to its participation and the participation by each Participating Dealer in the offer and sale of the Offered Shares (including, without limitation, any resales and transfers of Offered Shares), the Dealer Manager agrees, and, by virtue of entering into the Participating Dealer Agreement, each Participating Dealer shall have agreed, to comply with any applicable requirements of the Securities Act and the Exchange Act, applicable state securities or blue sky laws, and, specifically including, but not in any way limited to, NASD Conduct Rules 2340 and 2420, and FINRA Conduct Rules 2310, 5130 and 5141.
Compliance with Texas Privacy Laws and Regulations In performing their respective obligations under the Agreement, the LEA and the Provider shall comply with all Texas laws and regulations pertaining to LEA data privacy and confidentiality, including but not limited to the Texas Education Code Chapter 32, and Texas Government Code Chapter 560.
Compliance with Safeguarding Customer Information Requirements The Servicer has implemented and will maintain security measures designed to meet the objectives of the Interagency Guidelines Establishing Standards for Safeguarding Customer Information published in final form on February 1, 2001, 66 Fed. Reg. 8616, and the rules promulgated thereunder, as amended from time to time (the “Guidelines”). The Servicer shall promptly provide the Seller information regarding the implementation of such security measures upon the reasonable request of the Seller.
