Compressors. On compressor houses, manifold compressors or large single unit compressors (750 CFM or more) in the same location: one (1)
Compressors. This Section 07.06.00 shall not apply to the required xxxxxxx on Compressor Houses.
Compressors. Lessor shall provide use of compressors throughout the Leased Premises at 100 PSI. The line from the compressors shall be extended to the production area as directed by Lessee.
Compressors. Since they can create can create a strong visual contrast and create auditory distractions, compressors will not be approved within two miles of the base of the Pumpkin Buttes.
Compressors. All compressors shall be an oil free design. The compressor shall be capable of operating continuously at the maximum delivery pressure (5000 psig) under environmental conditions specified herein without having to stop for cool-down. The lubricants used shall be of an approved type listed in NAVSEA Technical manual S9086-H7-STM-010/CH-262.
Compressors. The compressors for the open loop heat pump can be seen in Figure 35 and are turbo compressors of the model EA42 with a custom dedicated impeller design for stage 1 and stage 2. The gearbox is cooled internally and the cooling water from the DC motor can be used to cool the gearbox. This is a significant improvement from the former EC38 units which required external oil cooling. Further improvement includes that the inlet and outlet connections from the compressor to the system can be adjusted so that standard industry piping and screw connections can be used. Figure 36 shows the connection pipe work of the EA42 and EC38 compressor, respectively.
Compressors. 1. Check suction and head pressures 2. Electrical amperes 3. All electrical connections
Compressors. A. Compressors: Hermetic scroll type. Quantity of two for dual staging.
B. Mounting: Statically and dynamically balance rotating parts and mount on spring vibration isolators.
1. Internally isolate hermetic units on springs.
C. Lubrication System: Reversible, positive displacement oil pump with oil charging valve, oil level sight glass, and magnetic plug or strainer.
D. Motor: Constant speed 1800 rpm suction gas cooled with electronic sensor and winding over temperature protection, designed for across-the-line starting. Furnish withstarter.
Compressors. When the number of Compressors (excluding compressor house or plant) of the 150 C.F.M. type, gasoline or diesel driven exceed nine
Compressors. (a) The compressors shall be continuously rated and of a reciprocating, air cooled pattern.
(b) All working parts shall be replaceable.
(c) The compressors shall be provided with after-cooler and, where necessary inter-coolers. They shall be air cooled and the tube nests shall be replaceable. The tubes shall be of corrosion resistant material. Each cooler shall be complete with moisture separator and automatic trap fitted with sight glass assembly.
(d) Main bearings, and for reciprocating compressors, connecting rod and crosshead bearings shall be oil pressure lubricated by a pump mechanically driven from the compressor. Where separate cylinder or rotor lubrication is provided, the oil pump shall be mechanically driven from the compressor.
