Preparatory Contract Negotiations Meetings Where operational requirements permit, the Employer will grant leave without pay to an employee to attend preparatory contract negotiations meetings.
Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.
Office of Inspector General Investigative Findings Expert Review In accordance with Senate Bill 799, Acts 2021, 87th Leg., R.S., if Texas Government Code, Section 531.102(m-1)(2) is applicable to this Contract, Contractor affirms that it possesses the necessary occupational licenses and experience.
Contract Negotiations Meetings Where operational requirements permit, the Employer will grant leave without pay to an employee for the purpose of attending contract negotiations meetings on behalf of the Institute.
Conduct of a Meeting; Member Lists (a) The Board shall have full power and authority concerning the manner of conducting any meeting of the Members, including the determination of Persons entitled to vote, the existence of a quorum, the satisfaction of the requirements of this ARTICLE 7, the conduct of voting, the validity and effect of any proxies and the determination of any controversies, votes or challenges arising in connection with or during the meeting or voting. The Board shall designate a Person to serve as chairman of any meeting and shall further designate a Person to take the minutes of any meeting. All minutes shall be kept with the records of the Company maintained by the Board. The Board may make such other regulations consistent with applicable law and this Agreement as it may deem advisable concerning the conduct of any meeting of the Members, including regulations in regard to the appointment of proxies, the appointment and duties of inspectors of votes, the submission and examination of proxies and other evidence of the right to vote. (b) A complete list of Members entitled to vote at any meeting of Members, arranged in alphabetical order and showing the address of each such Member and the number of Shares registered in the name of such Member, shall be open to the examination of any Member, for any purpose germane to the meeting, during ordinary business hours, for a period of at least 10 days before the meeting, at the principal place of business of the Company. The Member list shall also be produced and kept at the time and place of the meeting during the whole time thereof, and may be inspected by any Member who is present.
Professional Conferences Professional conferences are those conferences sponsored by educational organizations, institutions of higher learning, and government and industry concerning teaching, learning and educational research. When a full-time or part-time faculty member’s attendance at a professional conference conflicts with his/her regular assignment, the faculty member must submit a request for attendance to the appropriate Xxxx, Director, or Supervisor. If granted, the attendance at the conference will be considered leave with pay, and a follow-up report of the conference shall be submitted to the appropriate Supervisor.
SPECIAL CONFERENCES Special conferences for important matters may be arranged between the Union and the designated representative of the Board upon the request of either party.
Project Steering Committee 1. For a sound implementation and management of the project, a steering committee shall be set up in line with provisions of the programme manual. 2. The steering committee is the decision-making body of the project and it shall be composed by representatives of the LP and all PPs duly authorised to represent the respective LP and PP institutions. It shall be chaired by the LP and it shall meet on a regular basis. Associated partners shall be invited to take part in the steering committee in an advisory capacity. External key stakeholders may also be invited to take part to one or more meetings in an observer/advisory capacity. 3. The steering committee shall at least: a. be responsible for monitoring and validating the implementation of the project and the achievement of the planned results as in the approved application form; b. perform the financial monitoring of the project implementation and to decide on any budget modifications as in § 11 of this agreement; c. monitor and manage deviations of the project implementation; d. decide on project modifications (e.g. partnership, budget, activities, and duration) if needed; e. be responsible for the settlement of any disputes within the partnership (as stipulated in § 22 of this agreement). 4. Further aspects, including the creation of sub-groups or task forces, may be set out in the rules of procedure of the steering committee.
Research Plan The Parties recognize that the Research Plan describes the collaborative research and development activities they will undertake and that interim research goals set forth in the Research Plan are good faith guidelines. Should events occur that require modification of these goals, then by mutual agreement the Parties can modify them through an amendment, according to Paragraph 13.6.
Programming Phase Schematic Design Phase: 2.2.1.3. Design Development Phase:
