Consultations and Committee on Trade in Goods and Rules of Origin Sample Clauses

Consultations and Committee on Trade in Goods and Rules of Origin. 1. The Parties hereby establish a Committee on Trade in Goods and Rules of Origin, comprising representatives of each Party.
AutoNDA by SimpleDocs
Consultations and Committee on Trade in Goods and Rules of Origin. The Parties hereby establish a Committee on Trade in Goods and Rules of Origin, comprising representatives of each Party. The Committee shall meet periodically, and at any other time on the request of either Party or the Commission, to ensure the effective implementation and administration of this Chapter, Chapter IV (Rules of Origin), Chapter V (Customs Procedures), Chapter VI (Emergency Action), Chapter IX (Trade Facilitation and Additional Provisions) and any Uniform Regulations. In this regard, the Committee shall:
Consultations and Committee on Trade in Goods and Rules of Origin. The Parties hereby establish a Committee on Trade in Goods and Rules of Origin, comprising representatives of each Party. The Committee shall meet periodically, and at any other time on the request of either Party or the Commission, to ensure the effective implementation and administration of this Chapter, Chapter Three (Rules of Origin), Chapter Four (Customs Procedures), Chapter Five (Trade Facilitation), Chapter Eight (Emergency Action) or any Uniform Regulations. In this regard, the Committee shall: • monitor the implementation and administration by the Parties of this Chapter, Chapter Three (Rules of Origin), Chapter Four (Customs Procedures), Chapter Five (Trade Facilitation), Chapter Eight (Emergency Action) or any Uniform Regulations to ensure their uniform interpretation; • review, at the request of either party, a proposed modification of or addition to this Chapter, Chapter Three(Rules of Origin), Chapter Four(Customs Procedures), Chapter Five (Trade Facilitation), Chapter Eight (Emergency Action) or any Uniform Regulations; • review, in a timely manner, amendments to the Harmonized System with a view to reflecting these amendments in Annex 3.02 (Product-Specific Rules of Origin); • recommend to the Commission a modification of or addition to this Chapter, Chapter Three (Rules of Origin), Chapter Four (Customs Procedures), Chapter Five (Trade Facilitation), Chapter Eight (Emergency Action), any Uniform Regulations or any other provision of this Agreement as may be required to conform with a change to the Harmonized System; • consider a tariff or non-tariff issue raised by either Party; or • consider any other matter relating to the implementation and administration by the Parties of this Chapter, Chapter Three (Rules of Origin), Chapter Four (Customs Procedures), Chapter Five (Trade Facilitation), Chapter Eight (Emergency Action) or any Uniform Regulations referred to it by: o a Party, o the Customs Procedures Sub-Committee established under Article 4.14 (Customs Procedures - Customs Procedures Sub-Committee), or o the Sub-Committee on Agriculture established under paragraph 4. If the Committee fails to resolve a matter referred to it pursuant to paragraph 2(b) or (d) within 30 days of such referral, either Party may request a meeting of the Joint Commission under Article 21.01 (Administration of the Agreement - Joint Commission). At the request of a Party, the Committee will establish a Sub-Committee on Agriculture that shall: • meet within 90 ...

Related to Consultations and Committee on Trade in Goods and Rules of Origin

  • Committee on Trade in Goods 1. The Parties hereby establish a Committee on Trade in Goods, comprising representatives of each Party.

  • Non-discrimination Based on National Origin as evidenced by Limited English Proficiency The Contractor agrees to comply with the non-discrimination requirements of Title VI of the Civil Rights Act of 1964, 42 USC Section 2000d, et seq., and with the federal guidelines promulgated pursuant to Executive Order 13166 of 2000, which require that contractors and subcontractors receiving federal funds must assure that persons with limited English proficiency can meaningfully access services. To the extent the Contractor provides assistance to individuals with limited English proficiency through the use of oral or written translation or interpretive services in compliance with this requirement, such individuals cannot be required to pay for such services.

  • Visitors to and Conduct on School Property Petitions or written correspondence to the Board shall be presented to the Board in the next regular Board packet. LEGAL REF.: 5 ILCS 120/2.06, Open Meetings Act. 105 ILCS 5/10-6 and 5/10-16. CROSS REF.: 2:220 (School Board Meeting Procedure), 8:10 (Connection with the Community), 8:30 (Visitors to and Conduct on School Property) Adopted: September 5, 2019 Meridian CUSD 223 2:240 Board Policy Development The School Board governs using written policies. Written policies ensure legal compliance, establish Board processes, articulate District ends, delegate authority, and define operating limits. Board policies also provide the basis for monitoring progress toward District ends. Policy Development Anyone may propose new policies, changes to existing policies, or elimination of existing policies. Staff suggestions should be processed through the Superintendent. Suggestions from all others should be made to the Board President or the Superintendent. A Board Policy Committee will consider all policy suggestions, and provide information and recommendations to the Board. The Superintendent is responsible for: (1) providing relevant policy information and data to the Board,

  • Committee on Technical Barriers to Trade 1. The Parties hereby establish the Committee on Technical Barriers to Trade, comprising representatives of each Party.

  • Human and Financial Resources to Implement Safeguards Requirements 6. The Borrower shall make available necessary budgetary and human resources to fully implement the EMP and the RP.

  • Information Technology Accessibility Standards Any information technology related products or services purchased, used or maintained through this Grant must be compatible with the principles and goals contained in the Electronic and Information Technology Accessibility Standards adopted by the Architectural and Transportation Barriers Compliance Board under Section 508 of the federal Rehabilitation Act of 1973 (29 U.S.C. §794d), as amended. The federal Electronic and Information Technology Accessibility Standards can be found at: xxxx://xxx.xxxxxx-xxxxx.xxx/508.htm.

  • Certification Regarding Prohibition of Boycotting Israel (Tex Gov. Code 2271) If (a) Vendor is not a sole proprietorship; (b) Vendor has ten (10) or more full-time employees; and (c) this Agreement or any agreement with a TIPS Member under this procurement has value of $100,000 or more, the following certification shall apply; otherwise, this certification is not required. Vendor certifies, where applicable, that neither the Vendor, nor any affiliate, subsidiary, or parent company of Vendor, if any, boycotts Israel, and Vendor agrees that Vendor and Vendor Companies will not boycott Israel during the term of this Agreement. For purposes of this Agreement, the term “boycott” shall mean and include refusing to deal with, terminating business activities with, or otherwise taking any action that is intended to penalize, inflict economic harm on, or limit commercial relations with Israel, or with a person or entity doing business in Israel or in an Israeli-controlled territory but does not include an action made for ordinary business purposes. When applicable, does Vendor certify? Yes

  • CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.

  • Provisions for Covered Entity to Inform Business Associate of Privacy Practices and Restrictions (a) Covered Entity shall notify Business Associate of any limitation(s) in the notice of privacy practices of Covered Entity under 45 CFR 164.520, to the extent that such limitation may affect Business Associate’s use or disclosure of protected health information.

  • Data Practices The Parties acknowledge that this Agreement is subject to the requirements of Minnesota’s Government Data Practices Act, Minnesota Statutes, Section 13.01

Time is Money Join Law Insider Premium to draft better contracts faster.