Show Up Time An employee who reports to work in the usual manner without having been notified that there is no work available and is sent home because of lack of work before having worked four (4) hours shall receive a minimum of four (4) hours pay at their prevailing hourly rate. The employee shall also receive their full accommodation allowance if and when applicable. Each employee must inform the Employer of a means of being contacted on short notice. If an attempt is made by the Employer at least two (2) hours before the employee’s shift commences by way of the contact information provided, in an effort to inform the employee of a lack of work, and the Employer is unable to do so, the employee will not be entitled to show up time.
Shipping must be Freight On Board Destination to the delivery location designated on the Customer purchase order The Contractor will retain title and control of all goods until delivery is completed and the Customer has accepted the delivery. All risk of transportation and all related charges are the responsibility of the Contractor. The Customer will notify the Contractor and H-GAC promptly of any damaged goods and will assist the Contractor in arranging for inspection. The Contractor must file all claims for visible or concealed damage. Unless otherwise stated in the Agreement, deliveries must consist only of new and unused merchandise.
Voice Grade Unbundled Copper Sub-Loop Unbundled Sub-Loop Distribution – Intrabuilding Network Cable (aka riser cable)
Unbundled Voice Loop – SL2 (UVL-SL2 Loops may be 2-wire or 4-wire circuits, shall have remote access test points, and will be designed with a DLR provided to NewPhone. SL2 circuits can be provisioned with loop start, ground start or reverse battery signaling. OC is provided as a standard feature on XX0 Xxxxx. The OC feature will allow NewPhone to coordinate the installation of the Loop with the disconnect of an existing customer’s service and/or number portability service. In these cases, BellSouth will perform the order conversion with standard order coordination at its discretion during normal work hours.
Flex Time Upon agreement of the supervisor's immediate supervisor, an individual flex-time schedule may be established.
Minimum Call-In Time Any employee called in to work on a day when the employee is not scheduled to work shall receive a minimum of two (2) hours pay at the appropriate rate of pay under this Agreement.
Mail Order Catalog Warnings In the event that, the Settling Entity prints new catalogs and sells units of the Products via mail order through such catalogs to California consumers or through its customers, the Settling Entity shall provide a warning for each unit of such Product both on the label in accordance with subsection 2.4 above, and in the catalog in a manner that clearly associates the warning with the specific Product being purchased. Any warning provided in a mail order catalog shall be in the same type size or larger than other consumer information conveyed for such Product within the catalog and shall be located on the same display page of the item. The catalog warning may use the Short-Form Warning content described in subsection 2.3(b) if the language provided on the Product label also uses the Short-Form Warning.
Turnaround Time The number of hours between scheduled shifts shall not be less than seven and one-half (7-1/2) hours. Violations shall be compensated at the rate of time and one-half for all hours worked on the shift following the hours of rest.
Customer Care a) Contractor shall comply with the applicable requirements of the Americans with Disabilities Act and provide culturally competent customer service to all Covered California Enrollees in accordance with the applicable provisions of 45 C.F.R. § 155.205 and § 155.210, which refer to consumer assistance tools and the provision of culturally and linguistically appropriate information and related products.
DELIVERY: FOB DESTINATION, INSIDE DELIVERY, FREIGHT PAID Whenever possible, contractors should give the ordering entities 3 working days prior notice of any deliveries and/or installations. Furniture contractors will not be responsible for the removal/moving of existing furnishings unless requested by the ordering entity. Contractors should verify site readiness prior to delivery. All deliveries will be made during normal working hours unless otherwise arranged with the ordering entity. Contractor will communicate any scheduling delays and/or changes immediately. Agencies will not be responsible for any freight damage, concealed or otherwise.
