Demarcation Point 98.1 CenturyLink will designate the point of demarcation between CenturyLink’s equipment and CLEC’s collocated equipment, which point of demarcation shall be in or adjacent to its Collocation Space unless otherwise mutually agreed to by the Parties. At CLEC's request, CenturyLink will identify the location(s) of other possible demarcation points available to CLEC, and CLEC will designate from these location(s) the point(s) of demarcation between its collocated equipment and CenturyLink's equipment. CenturyLink will use its best efforts to identify the closest demarcation point to CLEC's equipment that is available.
Focal Points In accordance with CCR §7364(a)(5) County will specify to Subrecipient the identity of the Area Plan designated focal points for service delivery in the community which is attached hereto as Exhibit 6 and is hereinafter referred to as Exhibit 6. THE REMAINDER OF THIS PAGE WAS INTENTIONALLY LEFT BLANK
Contact Points 1. Each Party shall designate a contact point to facilitate communications between the Parties on any matter covered by this Agreement. 2. Upon request of the other Party, the contact point shall identify the office or official responsible for the matter and assist, as necessary, in facilitating communication with the requesting Party. Contact points shall work jointly to develop agendas and make other preparations for the Free Trade Commission meetings and follow-up on the Free Trade Commission's decisions as appropriate; provide administrative support to the Panels established under Chapter 15 (Dispute Settlement) and address any other matter entrusted by the Free Trade Commission.
Interconnection Points 8.5.1 The IP of a Party (“Receiving Party”) for Measured Internet Traffic delivered to the Receiving Party by the other Party shall be the same as the IP of the Receiving Party for Reciprocal Compensation Traffic under Section 7.1 above.
Interconnection Point The Service Provider is responsible for connecting to the LFC Network at the Interconnection Point. The LFC may only change an Interconnection Point if a change is necessary to protect the security or integrity of that Interconnection Point in order to maintain the continuity of supply of the Wholesale Services. In the event of any such change:
Contact Point 1. Each Party shall designate a contact point to facilitate communications between the Parties on any matter covered by this Agreement.
Rate Demarcation Point The physical point in a Verizon provided network facility at which Verizon's responsibility for maintaining that network facility ends and the Customer's responsibility for maintaining the remainder of the facility begins, as set forth in this Agreement, Verizon's applicable Tariffs, if any, or as otherwise prescribed under Applicable Law.
Delivery Points Project water made available to the Agency pursuant to Article 6 shall be delivered to the Agency by the State at the delivery structures established in accordance with Article 10.
Signaling Parameters All SS7 signaling parameters will be provided in conjunction with traffic exchange trunk groups, where and as available. These parameters include Automatic Number Identification ("ANI"), Calling Party Number ("CPN"), Privacy Indicator, calling party category information, originating line information, charge number, etc. Also included are all parameters relating to network signaling information, such as Carrier Information Parameter ("CIP"), wherever such information is needed for call routing or billing. GTE will provide SS7 via GR-394-SS7 and/or GR-317-SS7 format(s).
Configuration Management The Contractor shall maintain a configuration management program, which shall provide for the administrative and functional systems necessary for configuration identification, control, status accounting and reporting, to ensure configuration identity with the UCEU and associated cables produced by the Contractor. The Contractor shall maintain a Contractor approved Configuration Management Plan that complies with ANSI/EIA-649 2011. Notwithstanding ANSI/EIA-649 2011, the Contractor’s configuration management program shall comply with the VLS Configuration Management Plans, TL130-AD-PLN-010-VLS, and shall comply with the following:
