Electrical and Telephone Outlets. Locate all power and telephone requirements: Dimension the position from a corner and give height above concrete slab for all critically located outlets. Identify all dedicated circuits and identify all power outlets greater than 120 volts. For the equipment used in these outlets which require dedicated circuits and/or which require greater than 120 volts, identify the type of equipment, the manufacturer's name and the manufacturer's model number, and submit a brochure for each piece of equipment. Also identify the manufacturer's name of the phone system to be used and the power requirements, size, and location of its processing equipment.
Electrical and Telephone Outlets. Locate all power and telephone requirements. Dimension each outlet from a corner and give height above concrete slab for all critically located outlets. Identify all dedicated circuits and identify all power outlets greater than 120 volts. For the equipment used in these outlets which require dedicated circuits and/or which require greater than one hundred, twenty (120) volts, identify the type of equipment, the manufacturer’s name and the manufacturer’s model number, and submit product literature for each piece of equipment. Also identify the manufacturer’s name of the Tenant’s phone system and the power requirements, size, and location of its processing equipment. Provide cut sheet on any special equipment requiring plumbing.
Electrical and Telephone Outlets. All existing perimeter wall outlets shall remain as is. Any additional such outlets shall be installed per Code. All outlets in all removed partitions shall be disconnected at the junction box by Lessor. Any and all new outlets and all electrical power required by Lessee for the installation of Lessees pre-fab type office systems, and industrial equipment shall be constructed by Lessor in a "roughed-out" condition ready for final hook-up to said office systems and industrial equipment at Lessee's expense.
Electrical and Telephone Outlets. Vertical pack poles are not permitted. Two (2) Electrical outlets for each standard closed office; 3 electrical outlets for each executive office, (over 180 sq. ft.) and conference rooms and meeting rooms. Necessary outlets for maintenance of corridors and cleaning. Standard quantity of telephone outlets; 1 per work station. At each wall telephone outlet, in insulated wall, provide a 3/4" empty conduit to ceiling space with pull cord. In open office areas, each desk will have a quadrupex and a telephone outlet; connection of electrified base for partitions by Tenant. 1 floor monument in big conference room, 1 floor monument behind reception desk. April 10, 2000
Electrical and Telephone Outlets. As outlined on Exhibit A-1, any additional work will be at the expense of the Lessee
Electrical and Telephone Outlets. As per attached plans.
Electrical and Telephone Outlets. Please see Section 5.00, Interior Improvements.
Electrical and Telephone Outlets. All electrical and telephone outlets shall remain "as is". Notwithstanding the above, Lessor shall install new electrical outlets and telephone "stub-out" boxes in all new partition to be built by Lessor as stated in 1 above.
Electrical and Telephone Outlets. A. One wall telephone with 3/4" conduit or one electrical outlet per 100 square feet.
Electrical and Telephone Outlets. Standard 110 volt duplex electrical outlets provided two per enclosed office or work area; two (2) at break rooms and one (1) ground fault outlet at each restroom. Telephone outlet wall box and EMT stub-up above finished ceiling provided at one (1) per enclosed office or work area. Specialty outlets, i.e. higher voltage or amperage, dedicated outlets isolated grounds, etc., may be provided at Tenant optional extra. Tenant to be responsible for all telephone/data cable installation, termination devices, equipment, and permitting.
