Energy Transfer Stations Sample Clauses

Energy Transfer Stations. Energy transfer stations in Phase 1 NDES will be designed based on the concept shown on Drawing M07 in Appendix Six. Generally, there will be one ETS per building consisting of one space heating heat exchanger and one domestic hot water heat exchanger, however the exact number of heat exchangers will depend on the individual building load. The ETS design will be based on the following criteria:  Building heating systems return temperature of 45°C to enable low return temperatures to the energy centre. This is an important design requirement that must be met in Phase 1 so that buildings provide suitable return temperatures for the heat pumps in the CEP in Phase 2.  Domestic hot water may be cascaded with the return on the space heating heat exchanger in buildings if needed to meet required return temperatures to the energy centre. The design of the ETS will be done on a building by building basis, including whether or not to use cascading. Additional considerations for designing buildings to be connected to the NDES are provided as part of the DES Compatibility Guide in Appendix Seven.
Sample 1Sample 2Sample 3
AutoNDA by SimpleDocs
Energy Transfer Stations. Class C KWL has extensive experience with the design and installation of energy transfer stations (ETS) in both new and existing buildings in the Lower Mainland. In KWL’s experience, an ETS installed in a new high- rise or low-rise building will cost approximately $115,000, including general conditions, engineering and contingencies. KWL has found that the design capacity of the ETS is a relatively insignificant factor in the overall cost of an ETS for Multi-Unit Residential Buildings in the Lower Mainland. The ETS cost for existing buildings is generally higher than that of new buildings because of additional constraints and demolition costs in existing mechanical rooms. In KWL’s experience, an ETS installed in an existing high-rise or low-rise residential building will cost approximately $155,000, including general conditions, engineering and contingencies, and the cost of an ETS in an existing commercial building $65,000. General conditions have been estimated at 3% of total capital cost for the ETS, while engineering has been estimated at 6% for design, specification, tendering and construction support. A contingency of 10% has been added to the capital cost.
Sample 1Sample 2Sample 3

Related to Energy Transfer Stations

  • Technology Transfer (a) Sublicensee acknowledges and agrees that ECC has delivered and made to Sublicensee a disclosure of a general introduction to the Technology and to its commercial feasibility prior to the execution of this Agreement. Except to the extent such information falls within one or more of the exceptions to the definition of "Confidential Information", all information disclosed by ECC to Sublicensee prior to the execution of this Agreement shall be deemed to constitute part of the Technology and shall be deemed to be confidential. The timing and extent of additional disclosure by ECC to Sublicensee shall be as set forth in subparagraph 22(b) hereof. (b) Upon execution of this Agreement, ECC shall provide Sublicensee with copies of the patents listed in Section B of Exhibit "B" hereto. Beyond that, ECC shall not be required to provide additional information concerning, or disclosure of, the Technology to Sublicensee until Sublicensee provides to ECC (i) written notice of Sublicensee's intent to commercialize a Product, which written notice shall include detailed specifications for the designated Product, and (ii) evidence, reasonably satisfactory to ECC, of Sublicensee's intent to commercialize the designated Product in the form of written documentation of orders placed by Sublicensee of the equipment needed by Sublicensee to produce and commercialize the designated Product or in the form of written documentation from Sublicensee confirming the dedication and/or modification of existing equipment necessary to produce the designated Product. Within ninety (90) days after ECC's receipt of the items described in the preceding sentence, ECC shall provide to Sublicensee the following additional disclosure: (w) a Product specific recipe for the production of the designated Product; (x) Product specific process specifications for the production of the designated Product; (y) copies of all patent applications listed in the Exhibits hereto that ECC deems relevant to the production of the designated Product; and (z) a list of known raw materials suppliers and preferred equipment vendors.

  • Public Works Installation work which is considered public works is excluded from purchase under this Contract. Historically, the New York State Bureau of Public Works has maintained that installation, maintenance, and repair of equipment attached to any wall, ceiling, or floor, or affixed by hard wiring or plumbing is public work. In contrast, installation of a piece of equipment which is portable or a “plug-in” free-standing unit would not be considered public work. Thus, this Contract does not authorize installation where the equipment becomes a permanent part of the building structure, or is otherwise incorporated into the fabric of the building (e.g. installation on a wall, ceiling, or floor in a fixed location, or affixed by hard-wiring or plumbing). See Xxxxxxxx X, §00 Prevailing Wage Rates – Public Works

  • Scope and Order Placement These terms may be used by Customer either for a single Order or as a framework for multiple Orders. In addition, these terms may be used on a global basis by the parties’ “Affiliates”, meaning any entity controlled by, controlling, or under common control with a party. The parties can confirm their agreement to these terms either by signature where indicated at the end or by referencing these terms on Orders. Affiliates participate under these terms by placing orders which specify product or service delivery in the same country as the HP Affiliate accepting the Order, referencing these terms, and specifying any additional terms or amendments to reflect local law or business practices.

  • Statewide HUB Program Statewide Procurement Division Note: In order for State agencies and institutions of higher education (universities) to be credited for utilizing this business as a HUB, they must award payment under the Certificate/VID Number identified above. Agencies, universities and prime contractors are encouraged to verify the company’s HUB certification prior to issuing a notice of award by accessing the Internet (xxxxx://xxxxx.xxx.xxxxx.xx.xx/tpasscmblsearch/index.jsp) or by contacting

  • Funding Restrictions and Order Quantities The Agency reserves the right to reduce or increase estimated or actual quantities in whatever amount necessary without prejudice or liability to the Agency, if: 12.3.1 Funding is not available; 12.3.2 Legal restrictions are placed upon the expenditure of monies for this category of service or supplies; or, 12.3.3 The Agency’s requirements in good faith change after award of the contract.

  • Human and Financial Resources to Implement Safeguards Requirements The Borrower shall make available necessary budgetary and human resources to fully implement the EMP and the RP.

  • Registration Compliance; No Stop Orders The Registration Statement has become effective under the Securities Act, and no stop order suspending the effectiveness of the Registration Statement or any part thereof, preventing or suspending the use of any Preliminary Prospectus, the Prospectus or any Permitted Free Writing Prospectus or any part thereof shall have been issued and no proceedings for that purpose or pursuant to Section 8A under the Securities Act shall have been initiated or threatened by the Commission, and all requests for additional information on the part of the Commission (to be included in the Registration Statement or the Prospectus or otherwise) shall have been complied with to the reasonable satisfaction of the Representative; the Rule 462(b) Registration Statement, if any, and the Prospectus shall have been filed with the Commission within the applicable time period prescribed for such filing by, and in compliance with, the Rules and Regulations and in accordance with Section 4(a) of this Agreement, and the Rule 462(b) Registration Statement, if any, shall have become effective immediately upon its filing with the Commission; and FINRA shall have raised no unresolved objection to the fairness and reasonableness of the terms of this Agreement or the transactions contemplated hereby.

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • Power System Stabilizers The Developer shall procure, install, maintain and operate Power System Stabilizers in accordance with the requirements identified in the Interconnection Studies conducted for Developer’s Large Generating Facility. NYISO and Connecting Transmission Owner reserve the right to reasonably establish minimum acceptable settings for any installed Power System Stabilizers, subject to the design and operating limitations of the Large Generating Facility. If the Large Generating Facility’s Power System Stabilizers are removed from service or not capable of automatic operation, the Developer shall immediately notify the Connecting Transmission Owner and NYISO. The requirements of this paragraph shall not apply to wind generators.

  • DEVELOPMENT OR ASSISTANCE IN DEVELOPMENT OF SPECIFICATIONS REQUIREMENTS/ STATEMENTS OF WORK

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!