Licensee Responsibilities Licensee is responsible for Licensee’s Users’ compliance with this Agreement. Licensee is responsible for all of Licensee’s uses and accounts. Licensee will be responsible for maintaining the security of Licensee’s accounts, passwords and files. Licensee and Users cannot share Licensee’s accounts or passwords or allow any third party to use Licensee’s accounts or passwords. Licensee will exercise reasonable precautions to prevent unauthorized use of the Software.
Joint Responsibility If the Seller determines that the Interface Problem is attributable partially to the design of a Warranted Part and partially to the design of any Supplier Part, the Seller will, if so requested by the Buyer, seek a solution to the Interface Problem through cooperative efforts of the Seller and any Supplier involved. The Seller will promptly advise the Buyer of such corrective action as may be proposed by the Seller and any such Supplier. Such proposal will be consistent with any then existing obligations of the Seller hereunder and of any such Supplier towards the Buyer. Such corrective action, unless reasonably rejected by the Buyer, will constitute full satisfaction of any claim the Buyer may have against either the Seller or any such Supplier with respect to such Interface Problem.
Contractor Responsibility (a) The Contractor shall be responsible for the entire Performance under the Contract regardless of whether the Contractor itself performs. The Contractor shall be the sole point of contact concerning the management of the Contract, including Performance and payment issues. The Contractor is solely and completely responsible for adherence by the Contractor Parties to all applicable provisions of the Contract.
(b) The Contractor shall exercise all reasonable care to avoid damage to the State's property or to property being made ready for the State's use, and to all property adjacent to any work site. The Contractor shall promptly report any damage, regardless of cause, to the State.
Maintenance of Services A. Reseller will adopt and adhere to the standards contained in the applicable BellSouth Work Center Interface Agreement regarding maintenance and installation of service.
B. Services resold under the Company’s Tariffs and facilities and equipment provided by the Company shall be maintained by the Company.
C. Reseller or its end users may not rearrange, move, disconnect, remove or attempt to repair any facilities owned by the Company, other than by connection or disconnection to any interface means used, except with the written consent of the Company.
D. Reseller accepts responsibility to notify the Company of situations that arise that may result in a service problem.
E. Reseller will be the Company's single point of contact for all repair calls on behalf of Reseller’s end users. The parties agree to provide one another with toll-free contact numbers for such purposes.
F. Reseller will contact the appropriate repair centers in accordance with procedures established by the Company.
G. For all repair requests, Reseller accepts responsibility for adhering to the Company's prescreening guidelines prior to referring the trouble to the Company.
H. The Company will xxxx Reseller for handling troubles that are found not to be in the Company's network pursuant to its standard time and material charges. The standard time and material charges will be no more than what BellSouth charges to its retail customers for the same services.
I. The Company reserves the right to contact Reseller’s customers, if deemed necessary, for maintenance purposes.
Client Responsibility For clarity, the parties agree that in reviewing the documents referred to in clause (b) above, Patheon’s role will be limited to verifying the accuracy of the description of the work undertaken or to be undertaken by Patheon. Subject to the foregoing, Patheon will not assume any responsibility for the accuracy of any application for receipt of an approval by a Regulatory Authority. The Client is solely responsible for the preparation and filing of the application for approval by the Regulatory Authority and any relevant costs will be borne by the Client.
Management Responsibility No Limited Partner, as such, shall take part in the management of the business or transact any business for the Partnership.
Contractor Responsibilities 19.1. Contractor shall perform national criminal history checks for Ohio, Indiana, and Kentucky, and 10-panel drug screening tests on all prospective employees performing work under this RFP or coming onto a CMHA property and any resulting contract and provide summaries of the results to the Authority if requested. For the purposes of this section, the term “employees” includes contractor. Prospective employees whose criminal background check discloses a misdemeanor or felony involving crimes of moral turpitude, sexual offenses or harm to persons or property shall not be employed to perform work under this RFP or any resulting contract. Contractor is required to perform drug screening of all employees and to ensure acceptable test results. Criminal history and drug screening checks will be completed at the sole expense of the contractor. Any employee of the Contractor suspected of being under the influence of drugs and or alcohol will be reported to the appropriate personnel at CMHA and/or other local law enforcement. If the employee is determined to be under the influence of drugs or alcohol in any form or manner, or believed by proper authority to be dealing in illicit sale of alcohol or drugs they will be removed and shall not be allowed to return to any job site on the Authority’s property. The Contractor’s contract may be suspended and/or terminated should such a situation occur or if the Contractor fails to submit results pursuant to this section.
19.1.1. If CMHA requests additional drug screening, the test shall be performed within 24 hours and the summary shall be sent directly to CMHA from the testing facility.
19.2. Contractor(s) shall provide uniforms and ID Badges identifying Contractor for all employees working on CMHA’s properties. No employees will be allowed on CMHA’s properties out of uniform and without his/her ID badge on his/her person. Contractor(s) must submit a picture of the uniform and a sample of his/her ID badge if requested by CMHA.
19.3. Contractor’s personnel shall be neat and conduct all work in a professional and efficient manner. If any employee of Contractor is deemed unacceptable by CMHA, Contractor shall immediately replace such personnel with an acceptable substitute to CMHA.
19.4. Contractor(s) shall practice acceptable safety precautions so as not to cause harm to any persons or property while performing services under this RFP or any resulting contract. Contractor(s) shall follow industry safety standards, and use only industry approved safety equipment in accordance with the manufacturer’s specifications in the performance of all duties.
19.5. Contractor(s) shall pay all of its employees, including any and all approved Sub-Contractors, at least the legal minimum wages as determined by the United States Department of Labor and the United States Department of Housing and Urban Development and Department of Labor Prevailing Wage. Wage Determinations can be accessed via the Department of Labor website, xxx.xxxx.xxx.
19.6. Upon completion of the work, Contractor(s) shall clean up the area where the work was performed and Contractor(s) shall remove any debris generated by the products and/or services at CMHA premises. At no time, will Contractor(s) discard debris into any CMHA refuse container.
19.7. Contractor(s) shall clearly mark all work areas that might reasonably be expected to endanger the health and safety of residents, guests, or any other persons. Contractor(s) will provide such signs, markers and barricades as required to identify all work areas and minimize inherent dangers.
19.8. The contractor shall be responsible for notifying CMHA immediately of any damages (i.e. fire, container leaking) deemed to be a health or safety hazard whether the damage is caused by the contractor or other means.
19.9. The Contractor shall be responsible for safeguarding all CMHA property provided for Contractor use. At the close of each workday, CMHA facilities, property and materials shall be inspected and secured.
Customer Responsibility You agree that you are responsible for all access to and use of the Service through your account or password(s) and for any fees incurred for the Service, or for software or other merchandise purchased through the Service, or any other expenses incurred in accordance with the terms of this Agreement. You agree that you are responsible for backing up (a) any data you submit, receive or transfer over the Service, including, without limitation, your email; and (b) any data, files, programs, or applications on any device you connect to the Service. You acknowledge that you are aware that content accessible on or through the Service may contain material that is unsuitable for minors (persons under 18 years of age). You agree to supervise usage of your account by minors. You ratify and confirm any obligations incurred by a minor using your account.
Joint Responsibilities The relationship between SAE ITC, the Activities and its Members shall be, and at all times, advisory only, and no party shall have the authority to enter into any contract or commitment in the name of, or on behalf of, any other party. Nothing in this Agreement shall be construed to confer upon either party the status of employee, agent, partner, joint venturer or legal representative of the other, it being intended by all parties to remain independent legal entities solely responsible for its own actions.
Waiver of responsibility 1. Any appraisal of the Programme undertaken before or after its approval by the FMC, does not in any way diminish the responsibility of the National Focal Point and the Programme Operator to verify and confirm the correctness of the documents and information forming the basis of the programme agreement.
2. Nothing contained in the programme agreement shall be construed as imposing upon the FMC or the FMO any responsibility of any kind for the supervision, execution, completion, or operation of the Programme or its projects.
3. The FMC does not assume any risk or responsibility whatsoever for any damages, injuries, or other possible adverse effects caused by the Programme or its projects including, but not limited to inconsistencies in the planning of the Programme or its projects, other project(s) that might affect it or that it might affect, or public discontent. It is the full and sole responsibility of the National Focal Point and the Programme Operator to satisfactorily address such issues.
4. Neither the National Focal Point, the Programme Operator, entities involved in the implementation of projects, nor any other party shall have recourse to the FMC for further financial support or assistance to the Programme in whatsoever form over and above what has been provided for in the programme agreement.
5. Neither the European Free Trade Association, its Secretariat, including the FMO, its officials or employees, nor the FMC, its members or alternate members, nor the EFTA States, can be held liable for any damages or injuries of whatever nature sustained by the National Focal Point or the Beneficiary State, the Programme Operator, Project Promoters or any other third person, in connection, be it direct or indirect, with this programme agreement.
6. Nothing in this programme agreement shall be construed as a waiver of diplomatic immunities and privileges awarded to the European Free Trade Association, its assets, officials or employees.
