Equipment and equipment / vent unit storage Sample Clauses

Equipment and equipment / vent unit storage. The Contractor shall furnish all equipment for accessing the exterior of the dome and for all work related to the cutting of the vent apertures in the dome skin, the installation of any reinforcement or auxiliary structures, and the physical installation of the vent units with the exception that CFHT’s interior dome cranes will be provided as outline in Article 7 above. The number of tie-off points for scaffolding or platforms on the exterior of the dome is limited. Therefore, use of a ground-based manlift is recommended. If the Contractor elects to use equipment that requires the dome structure for support, then it is the Contractor’s responsibility to perform all necessary engineering assessments to ensure safe operation and positioning of equipment and personnel; and the Contractor will assume responsibility related to its use. Unsecured storage of equipment, tools, or supplies for the job outside CFHT building is not permitted. It is suggested that the Contractor keep equipment in an enclosed and locked container on the site adjacent to the Observatory building if it is not going to be transported daily by truck. Vehicles may be parked on the site. Everything stored outside must be secured to be able to withstand high wind gusts (100 mph) and severe weather, and must be placed so as not to interfere with vehicle access to the building. If necessary, staging areas for large equipment may be made available at lower altitudes on the summit. To avoid clutter at the summit, the OMKM requires that vent units, which are not expected to be installed promptly, shall be staged at the Xxxx Pohaku mid-level facility.
Sample 1
AutoNDA by SimpleDocs

Related to Equipment and equipment / vent unit storage

  • Equipment Use Lessee agrees that the Equipment will be operated by competent, qualified personnel in connection with Lessee's business for the purpose for which the Equipment was designed and in accordance with applicable operating instructions, laws, and government regulations, and that Lessee shall use all reasonable precautions to prevent loss or damage to the Equipment from fire and other hazards. Lessee shall procure and maintain in effect all orders, licenses, certificates, permits, approvals, and consents required by federal, state, or local laws or by any governmental body, agency, or authority in connection with the delivery, installation, use, and operation of the Equipment.

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • Furniture, Fixtures and Equipment Sublessee shall have the right to use during the Term the office furnishings and equipment within the Subleased Premises that are identified on Exhibit C attached hereto, as such exhibit may be adjusted by mutual agreement of the parties prior to the Third Floor Premises Delivery Date (the “Furniture”), provided Sublessee may only use the Furniture located in the Second Floor Premises after the Second Floor Commencement Date. The Furniture is provided in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever. Sublessee shall insure the Furniture under the property insurance policy required under the Master Lease, as incorporated herein, and pay all taxes with respect to the Furniture. Sublessee shall maintain the Furniture in good condition and repair, reasonable wear and tear excepted, and shall be responsible for any loss or damage to the same occurring during the Term. Sublessee shall surrender the Furniture to Sublessor upon the termination of this Sublease in the same condition as exists as of the applicable Delivery Date, reasonable wear and tear excepted. Sublessee shall not remove any of the Furniture from the Subleased Premises. Notwithstanding anything to the contrary herein, Sublessee may provide Sublessor with written notice one (1) time not less than forty-five (45) days prior to the Third Floor Premises Delivery Date that lists any items of Furniture that Sublessee does not want to use and Sublessor shall, at no cost to Sublessee, remove such items from the Subleased Premises prior to the Third Floor Premises Delivery Date and such items shall no longer be considered Furniture hereunder. Notwithstanding the foregoing, provided Sublessee is not in default beyond the expiration of any applicable cure or grace period as of the date of the expiration or earlier termination of this Sublease, which condition may be waived by Sublessor in its sole discretion, then upon the expiration or earlier termination of this Sublease, the Furniture shall become the property of Sublessee, and Sublessee shall accept the same in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever except as provided in the Bill of Sale referred to in the following sentence. In the event the Furniture is to become the property of Sublessee upon the expiration or earlier termination of this Sublease pursuant to the terms of the immediately preceding sentence, then Sublessor agrees to execute and deliver to Sublessee a Bill of Sale in the form of Exhibit D attached hereto conveying and transferring to Sublessee the Furniture.

  • Service Location and Equipment The AGENCY must request in writing and said request must be approved in writing by the COUNTY’S Manager of the CCC or designee, prior to any change in the dates, times, and locations of services provided in this Contract.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.

  • Premises and equipment 6.1 If necessary, the Customer shall provide the Supplier with reasonable access at reasonable times to its premises for the purpose of supplying the Services. All equipment, tools and vehicles brought onto the Customer’s premises by the Supplier or the Staff shall be at the Supplier’s risk.

  • Collocation of Switching Equipment CLEC may collocate any equipment that is necessary for Interconnection or access to Unbundled Network Elements.

  • Equipment and Vehicle Parking Company will ensure that all equipment, including but not limited to, vehicles owned or operated by Company, its vendors and/or contractors, will not be parked in a manner that interferes in any way with any operations at the Airport. Company’s equipment and vehicles and those of its vendors and/or contractors will be parked in designated parking areas as provided by Authority. No vehicle shall access the AOA unless directly related to Company’s business operations. All vehicles driven, escorted, or parked on the AOA must meet Authority’s insurance requirements and any other applicable Authority Rules and Regulations and security requirements. All vehicles, including those of Company’s Parties, excluding escorted vehicles, accessing the AOA must bear Company’s identification on both sides of the vehicle which should be identifiable from a distance of fifty (50) feet. Company must also display Authority’s logo decal. Information regarding vehicle access to the AOA is available from Authority’s Badging Office. All persons accessing the AOA must adhere to Authority’s SIDA training, Airport Security Program, and TSA regulations. Company will verify that its Company Parties who operate motorized vehicles on Airport property have a valid driver’s license. Company will provide evidence in writing of such verification within fifteen (15) days’ of written request by Authority. If Company fails to provide verification or if Company’s Party is found to be driving on Airport property without a valid driver’s license, Authority will revoke the offending driver’s ID Media and may assess liquidated damages against Company of up to $1,000 per occurrence. Said liquidated damages will be due and payable within fifteen (15) days’ notice of invoice for the same. On a quarterly basis, Company will conduct and maintain periodic audits of the status of the driver’s licenses of Company Parties to ensure that they possess and maintain a valid driver’s license. Such audits shall be provided to Authority upon fifteen (15) days’ written request by Authority.

  • STANDARD EQUIPMENT All items of standard equipment which are provided by the OEM shall be furnished unless such items are expressly deleted by the Authorized User or are specified to be other than standard in the Mini-Bid. When Optional equipment is specified, all components listed in the OEM’s data book as being included with the Option shall be furnished.

Time is Money Join Law Insider Premium to draft better contracts faster.