European Monetary Union If any Agreed Currency ceases to be lawful currency of the nation issuing the same and is replaced by the euro and the Administrative Agent or the Required Lenders shall so request in a notice delivered to the Borrowers, then any amount payable hereunder by any party hereto in such Agreed Currency shall instead be payable in the euro and the amount so payable shall be determined by translating the amount payable in such Agreed Currency to the euro at the exchange rate established by that nation for the purpose of implementing the replacement of the relevant Agreed Currency by the euro (and the provisions governing payments in Agreed Currencies in this Agreement shall apply to such payment in the euro as if such payment in the euro were a payment in an Agreed Currency). Prior to the occurrence of the event or events described in the preceding sentence, each amount payable hereunder in any Agreed Currency will, except as otherwise provided herein, continue to be payable only in that currency. The Company agrees, at the request of any Lender, to compensate such Lender for any loss, cost, expense or reduction in return that such Lender shall reasonably determine shall be incurred or sustained by such Lender as a result of the replacement of any Agreed Currency by the euro and that would not have been incurred or sustained but for the transactions provided for herein. A certificate of any Lender setting forth such Lender's determination of the amount or amounts necessary to compensate such Lender shall be delivered to the Company and shall be conclusive absent manifest error so long as such determination is made on a reasonable basis. The Company shall pay such Lender the amount shown as due on any such certificate within ten (10) days after receipt thereof.
European Union The academic use restriction in Section 12.d(i) below does not apply in the jurisdictions listed on this site: (xxx.xx/xxxxxxxxxxx).
Procurement of Goods and Services (a) If the HSP is subject to the procurement provisions of the BPSAA, the HSP will abide by all directives and guidelines issued by the Management Board of Cabinet that are applicable to the HSP pursuant to the BPSAA.
(b) If the HSP is not subject to the procurement provisions of the BPSAA, the HSP will have a procurement policy in place that requires the acquisition of supplies, equipment or services valued at over $25,000 through a competitive process that ensures the best value for funds expended. If the HSP acquires supplies, equipment or services with the Funding it will do so through a process that is consistent with this policy.
Notice to European Union Users Advanced Platform Solutions 's operations are located primarily in the United States. If you provide information to us, the information will be transferred out of the European Union (EU) and sent to the United States. (The adequacy decision on the EU-US Privacy became operational on August 1, 2016. This framework protects the fundamental rights of anyone in the EU whose personal data is transferred to the United States for commercial purposes. It allows the free transfer of data to companies that are certified in the US under the Privacy Shield.) By providing personal information to us, you are consenting to its storage and use as described in this Policy. Under the regulations of the General Data Protection Regulation ("GDPR") of the EU you have certain rights as a Data Subject. These rights are as follows: · The right to be informed: this means we must inform you of how we intend to use your personal data and we do this through the terms of this Policy. · The right of access: this means you have the right to request access to the data we hold about you and we must respond to those requests within one month. You can do this by sending an email to xxxxxxxxxxx@xxxxxxxxxxx.xxx. · The right to rectification: this means that if you believe some of the date, we hold is incorrect, you have the right to have it corrected. You can do this by logging into your account with us, or by sending us an email with your request. · The right to erasure: this means you can request that the information we hold be deleted, and we will comply unless we have a compelling reason not to, in which case you will be informed of same. You can do this by sending an email to xxxxxxxxxxx@xxxxxxxxxxx.xxx. · The right to restrict processing: this means you can change your communication preferences or opt-out of certain communications. You can do this by sending an email to xxxxxxxxxxx@xxxxxxxxxxx.xxx. · The right of data portability: this means you can obtain and use the data we hold for your own purposes without explanation. If you wish to request a copy of your information, contact us at xxxxxxxxxxx@xxxxxxxxxxx.xxx. · The right to object: this means you can file a formal objection with us regarding our use of your information with regard to third parties, or its processing where our legal basis is our legitimate interest in it. To do this, please send an email to xxxxxxxxxxx@xxxxxxxxxxx.xxx. In addition to the rights above, please rest assured that we will always aim to encrypt and anonymize your personal information whenever possible. We also have protocols in place in the unlikely event that we suffer a data breach and we will contact you if your personal information is ever at risk. For more details regarding our security protections see the section below or visit our website at Xxxxxxxxxxx.xxx.
Vlastnictví Zdravotnické zařízení si ponechá a bude uchovávat Zdravotní záznamy. Zdravotnické zařízení a Zkoušející převedou na Zadavatele veškerá svá práva, nároky a tituly, včetně práv duševního vlastnictví k Důvěrným informacím (ve smyslu níže uvedeném) a k jakýmkoli jiným Studijním datům a údajům.
Procurement of Goods and Works Except as ADB may otherwise agree, Goods and Works shall only be procured on the basis of the methods of procurement set forth below:
Other Methods of Procurement of Goods and Works The following table specifies the methods of procurement, other than International Competitive Bidding, which may be used for goods and works. The Procurement Plan shall specify the circumstances under which such methods may be used:
(a) National Competitive Bidding (b) Shopping (c) Direct Contracting
Medicines To be filled in if your child requires medication as part of an individual health plan, for example for an on-going condition such as asthma or eczema etc and is for the use of that child only. For staff: Individual health plan sighted and a copy taken: Tick One: Yes No Name of medicine: Method and dose of medicine: When does the medicine need to be taken: (State time or specific symptoms) Parent/Guardian Signature: Date: / / Enrolment Details: Date of Enrolment: / / Date of Entry: / / Date of Exit: / / Please Note: 20 Hours ECE is for up to six hours per day, up to 20 hours per week and there must be no compulsory fees when a child is receiving 20 Hours ECE funding. Days Enrolled: Monday Tuesday Wednesday Thursday Friday Times Enrolled: Total hours: 20 Hours ECE at this service Total hours: 20 Hours ECE at another service Total hours: Parent/Guardian Signature: Date: / /
Design Development Phase 1.3.1 Based on the approved Schematic Design Documents, model(s) and any adjustments to the Program of Requirements, BIM Execution Plan or Amount Available for the Construction Contract authorized by the Owner, the Architect/Engineer shall prepare, for approval by the Owner and review by the Construction Manager, Design Development Documents derived from the model(s) in accordance with Owner’s written requirements to further define and finalize the size and character of the Project in accordance with the BIM Execution Plan, “Facility Design Guidelines” and any additional requirements set forth in Article 15. The Architect/Engineer shall review the Design Development documents as they are being modeled at intervals appropriate to the progress of the Project with the Owner and Construction Manager at the Project site or other location specified by Owner in the State of Texas. The Architect/Engineer shall utilize the model(s) to support the review process during Design Development. The Architect/Engineer shall allow the Construction Manager to utilize the information uploaded into Owner’s PMIS to assist the Construction Manager in fulfilling its responsibilities to the Owner.
1.3.2 As a part of Design Development Phase, Architect/Engineer shall accomplish model coordination, aggregation and “clash detection” to remove conflicts in design between systems, structures and components. Architect/Engineer shall utilize Owner’s PMIS to accomplish model coordination and collaborate with Construction Manager in the resolution of critical clashes identified by the Construction Manager. Architect/Engineer shall demonstrate and provide written assurance to Owner that conflicts/collisions between models have been resolved.
1.3.3 The Architect/Engineer shall review the Estimated Construction Cost prepared by the Construction Manager, and shall provide written comments.
1.3.4 Before proceeding into the Construction Document Phase, the Architect/Engineer shall obtain Owner’s written acceptance of the Design Development documents and approval of the mutually established Amount Available for the Construction Contract and schedule.
1.3.5 The Architect/Engineer shall prepare presentation materials including an animation derived from the model(s) as defined in “Facility Design Guidelines” at completion of Design Development and if so requested shall present same to the Board of Regents at a regular meeting where scheduled within the state.
1.3.6 The Architect/Engineer shall prepare preliminary recommended furniture layouts for all spaces where it is deemed important to substantiate the fulfillment of program space requirements, or to coordinate with specific architectural, mechanical and electrical elements.
1.3.7 Architect/Engineer shall assist the Owner, if requested, with seeking approval of the Project by the Texas Higher Education Coordinating Board (THECB). Such assistance shall include (i) the preparation of a listing of the rooms and square footages in the Project, and (ii) the preparation of project cost information, in accordance with THECB Guidelines. This information shall be provided at the completion of the Design Development Phase when requested by the Owner. The listing of rooms and square footages shall then be updated to reflect any changes occurring during construction and provided to the Owner at Substantial Completion.
1.3.8 At the completion of the Design Development Phase, or such other time as Owner may specify to Architect/Engineer, at Owner’s sole option and discretion, Owner will furnish Architect/Engineer with a Guaranteed Maximum Price proposal prepared by Construction Manager based upon the Design Development documents prepared by the Architect/Engineer and approved by the Owner. The Architect/Engineer shall assist the Owner and endeavor to further and advocate the Owner’s interests in Owner’s communications with the Construction Manager in an effort to develop a Guaranteed Maximum Price proposal acceptable to Owner, in Owner’s sole option and discretion. If the Owner does not accept the Construction Manager’s Guaranteed Maximum Price proposal, the Architect/Engineer shall participate with the Owner and Construction Manager in constructability reviews and shall revise the documents as necessary in order to reach an agreement. If the Construction Manager’s Guaranteed Maximum Price proposal exceeds the Schematic Design Phase Estimated Construction Cost prepared by, or otherwise accepted by the Construction Manager due to an increase in the scope of the Project caused by further development of the design documents by the Architect/Engineer to the extent that such could not be reasonably inferred by the Construction Manager from the Schematic Design documents, and Owner directs Architect/Engineer to revise the documents, the Architect/Engineer shall revise the documents at its own expense so that the Guaranteed Maximum Price proposal for constructing the Project shall not exceed the Owner’s Amount Available for the Construction Contract and any previously approved Estimated Construction Costs. If it is determined to be in the Owner’s best interest, instead of requiring the Architect/Engineer to revise the Drawings and Specifications, the Owner reserves the right to accept a Guaranteed Maximum Price proposal that exceeds the stipulated Amount Available for the Construction Contract. The Architect/Engineer shall analyze the final Guaranteed Maximum Price proposal document, together with its supporting assumptions, clarifications, and contingencies, and shall submit a detailed written analysis of the document to the Owner. Such analysis shall include, without limitation, reference to and explanation of any inaccurate or improper assumptions and clarifications. The A/E will not be required to make revisions to the documents at its own expense under the provisions of this paragraph if the Owner’s rejection of the Guaranteed Maximum Price proposal is not due to a failure of the A/E to provide the services otherwise required herein.
1.3.9 After the Guaranteed Maximum Price has been accepted, the Architect/Engineer shall incorporate necessary revisions into the Design Development documents. The A/E will not be required to make revisions to the documents at its own expense under the provisions of this paragraph if the revisions are required as the result of inaccurate assumptions and clarifications made in the development of the Guaranteed Maximum Price proposal that are not due to a failure of the A/E to provide the services otherwise required herein.
Start-Up and Synchronization Consistent with the mutually acceptable procedures of the Developer and Connecting Transmission Owner, the Developer is responsible for the proper synchronization of the Large Generating Facility to the New York State Transmission System in accordance with NYISO and Connecting Transmission Owner procedures and requirements.
