Closing and Possession (a) Closing shall be held within 10 days after Seller’s abstracting obligations under this Agreement have been met at Xxxxxx Cooperative, of Ames, Iowa or at such other place as may be mutually agreed upon by Seller and Buyer.
Documenting and Reporting Breaches 6.1 Business Associate shall report to Covered Entity any Breach of Unsecured PHI, including Breaches reported to it by a Subcontractor, as soon as it (or any of its employees or agents) becomes aware of any such Breach, and in no case later than two (2) business days after it (or any of its employees or agents) becomes aware of the Breach, except when a law enforcement official determines that a notification would impede a criminal investigation or cause damage to national security.
Filing and Postmark The filing or service of any notice or document herein shall be timely if it is personally served or if it bears a certified postmark of the United States Postal Service within the time period.
Reporting and Documenting Breaches 6.1 Business Associate shall Report to Covered Entity any Breach of Unsecured PHI as soon as it, or any Person to whom PHI is disclosed under this Agreement, becomes aware of any such Breach, and in no event later than five (5) business days after such awareness, except when a law enforcement official determines that a notification would impede a criminal investigation or cause damage to national security. Such Report shall be timely made notwithstanding the fact that little information may be known at the time of the Report and need only include such information then available.
JOB POSTING AND BIDDING A. Notices of bargaining unit job vacancies, excluding temporary and on-call vacancies, shall be posted on the bulletin board at each facility for a period of three (3) business days prior to filling the vacancy. The Notice should include the job requirements specific to the position being posted. The full and complete minimum requirements for the position will be maintained by the personnel representative for disclosure to applicants at the time of bid.
Penalties for Non-compliance to Service Level Agreement Where the Supplier/Service Provider fails to deliver the Goods/Services within the agreed and accepted milestone timelines and provided that the cause of the delay was not due to a fault of Transnet, penalties shall be imposed at …………………………………………………… .
Sealing and Marking of Bids 21.1 The bidder shall seal the original and each copy of the bid in separate envelopes duly marking the envelopes “ORIGINAL” and “COPY”. The envelopes shall then be sealed in an outer separate envelope.
Posting and Filling Vacancies For the purposes of this section “working days”, will be consecutive days, exclusive of Saturdays, Sundays or holidays observed by the Company.
Posting and Filling of Vacancies 8.1(1) When a permanent vacancy occurs within a classification covered by this agreement, which the Employer intends to fill, after the Employer applies the internal job transfer bidding procedure and the ultimate vacancy is thereby identified, such vacancy shall be advertised for ten (10) calendar days provided that nothing herein shall prevent the Employer from advertising such vacancy throughout its system or outside during the ten (10) day period. Probationary employees may, at the sole discretion of the Employer, be considered for another position outside their classification after the signing date of this agreement. The Corporation reserves the sole and absolute right to carry out any applicable interviewing or testing that is necessary in its opinion. All test processes will be approved by qualified Human Resources staff. An employee will only be allowed to take one test failure for each different job classification bid every four (4) months. Current employees applying for positions which involve increased driving responsibilities must meet corporate driving standards and provide with application a current driving abstract. The opinion of the Employer shall not be exercised in an arbitrary or discriminatory manner.
Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
