Explanation of polygraph instrumentation and testing procedures Sample Clauses

Explanation of polygraph instrumentation and testing procedures. The testing process should be explained to the examinee, including an explanation of the instrumentation used and the physiological and psychological basis of response. Nothing in this Model Policy should be construed as favoring a particular explanation of polygraph science. In general, an integrated explanation involving emotional attributions, cognitive theory and behavioral learning theory may be the best approach.
AutoNDA by SimpleDocs

Related to Explanation of polygraph instrumentation and testing procedures

  • Testing Procedures Testing will be conducted by an outside certified Agency in such a way to ensure maximum accuracy and reliability by using the techniques, chain of custody procedures, equipment and laboratory facilities which have been approved by the U.S. Department of Health and Human Services. All employees notified of a positive controlled substance or alcohol test result may request an independent test of their split sample at the employee’s expense. If the test result is negative the Employer will reimburse the employee for the cost of the split sample test.

  • Implementation of Agreement Each Party must promptly execute all documents and do all such acts and things as is necessary or desirable to implement and give full effect to the provisions of this Agreement.

  • Reporting Procedures Enter in the XXX Entity Management area the information that XXX requires about each proceeding described in paragraph 2 of this award term and condition. You do not need to submit the information a second time under assistance awards that you received if you already provided the information through XXX because you were required to do so under Federal procurement contracts that you were awarded.

  • Introduction and Statement of Policy The National Institutes of Health (NIH) has established NIH-designated data repositories (e.g., database of Genotypes and Phenotypes (dbGaP), Sequence Read Archive (SRA), NIH Established Trusted Partnerships) for securely storing and sharing controlled-access human data submitted to NIH under the NIH Genomic Data Sharing (GDS)

  • Implementation and Review The Parties shall consult annually, or as otherwise agreed, to review the implementation of this Chapter and consider other matters of mutual interest affecting trade in services. (10) 10 Such consultations will be addressed under Article 170 (Free Trade Commission) of Chapter 14 (Administration of the Agreement).

  • Documentation and compliance (a) The data importer shall promptly and adequately deal with enquiries from the data exporter that relate to the processing under these Clauses. (b) The Parties shall be able to demonstrate compliance with these Clauses. In particular, the data importer shall keep appropriate documentation on the processing activities carried out on behalf of the data exporter. (c) The data importer shall make available to the data exporter all information necessary to demonstrate compliance with the obligations set out in these Clauses and at the data exporter’s request, allow for and contribute to audits of the processing activities covered by these Clauses, at reasonable intervals or if there are indications of non-compliance. In deciding on a review or audit, the data exporter may take into account relevant certifications held by the data importer.

  • Referral Procedures Section 1. For Local Unions now having a job referral system as contained in their Collective Bargaining Agreement, the Contractor agrees to utilize such system and it shall be used exclusively by such Contractor, except as it may be modified by this Article. Referrals shall not be affected by obligations of Union membership or the lack thereof. Where airport security clearance requirements apply to work to be performed, the Contractor shall inform the Union’s hiring hall dispatcher of those requirements when requesting workers. Section 2. In the event that Local Unions are unable to fill any request for employees within the time specified by the local CBAs the Contractor may employ applicants from any other available source. The Contractor shall inform the Union of the name and social security number of any applicants hired from other sources and shall refer the applicant to the Local Union for dispatch to the projects prior to the commencement of work. Section 3. There shall be no discrimination against any employee or applicant for employment because of his/her membership or non-membership in the union or based upon race, creed, color, sex, age or national origin, or any other legally protected class of such employee or applicant. Section 4. No employee covered by this Agreement shall be required to join any Union as a condition of being employed on the project; provided, however, that an employee who is a member of the referring union at the time of the referral shall maintain that membership while employed under the Agreement. All employees shall, however, be required to comply with the union security provision of the applicable Collective Bargaining Agreement, for the period during which they are performing on-site work, except as modified by this Agreement. The Contractor agrees to deduct union dues or representation fees, whichever is applicable, from the pay of any employee who executes a voluntary authorization for such deductions and to remit the dues to the Union or Council. Section 5. The parties agree that where a Contractor is not party to a current Collective Bargaining Agreement with the Union having jurisdiction over the affected work, the Contractor may request by name, and the Local will honor, referral of up to a maximum of five (5) persons per each contractor (“core” employees), provided that the Contractor first demonstrate that those persons possess the following qualifications: (1) Any license required by state or federal law for the project work to be performed; (2) Have worked a total of at least one thousand (1,000) hours in the construction craft during the prior three (3) years; (3) Were on the Contractor’s active payroll for at least sixty (60) out of the one hundred eighty (180) calendar days prior to the contract award; (4) Have the ability to perform the work safely. The Contractor may elect to hire its first “core” employee to be a xxxxxxx. After the contractor hires his first core employee, the Union will refer to such contractor one journeyman employee from the hiring hall out-of–work list for the affected trade or craft, then refer one of such Contractor’s “core” employees as a journeyman, and shall, alternate, one core employee and one employee from the out-of-work list, until such Contractor’s crew requirements are met or until such Contractor has hired five (5) “core” employees, whichever occurs first. Thereafter, all additional employees in the affected trade or craft shall be hired exclusively from the hiring hall out-of-work list(s). For the duration of the Contractor’s work the ratio of “core” employees to hiring hall referrals shall be maintained and when the Contractor’s workforce is reduced, employees shall be reduced in the same ratio as was applied in the initial hiring. All employees, core and union, shall be dispatched from the appropriate union. Trust benefits shall be paid on all employees, core and union. Section 6. Upon referral or dispatch from a Union, “turnaround” or refusal of any worker by the Contractors, requires written explanation from the Contractor that shall be communicated from the Prime Contractor to the Port and affected Union within 48 hours. Section 7. Individual seniority will not be recognized or applied to employees working on the project. This provision will not interfere with or supersede the use by individual Contractors of “call lists” maintained by such Contractor pursuant to addenda to the local Collective Bargaining Agreement between such Contractor and a Union signatory to this Agreement. Section 8. The selection of craft foremen and/or general foremen and the number of such foremen and/or general foremen required shall be entirely the responsibility of the Contractor. Craft foremen shall be designated working foremen at the request of the Contractor. Craft workers covered by this Agreement will, in the normal day- to-day operations, take their direction and supervision from their xxxxxxx.

  • Safety Procedures The Contractor shall: (a) comply with all applicable safety regulations according to Attachment H; (b) take care for the safety of all persons entitled to be on the Site; (c) use reasonable efforts to keep the Site and Works clear of unnecessary obstruction so as to avoid danger to these persons; (d) provide fencing, lighting, guarding and watching of the Works until completion and taking over under clause 10 [Employer's Taking Over]; and (e) provide any Temporary Works (including roadways, footways, guards and fences) which may be necessary, because of the execution of the Works, for the use and protection of the public and of owners and occupiers of adjacent land.

  • Billing Procedures The Supporting Party will xxxx the Protecting Party for actual costs incurred for Assistance by Hire. Reimbursements will be limited to the provisions of the Agreement and the applicable OP, regardless of whether or not it is authorized on the Resource Order or other documentation produced by the incident. Reimbursable costs may include transportation, salary, overtime, per diem and other approved expenses of Supporting agency personnel. Rates and conditions of use for the equipment and personnel are documented in the OP. Parties shall submit a xxxx within 90 days of the incident. Parties must use their own invoice form for billing under this Agreement to avoid any confusion with other services that may have been ordered under other agreements. Invoices must identify Supporting Party’s name, address, and Taxpayer Identification Number (Department only), fire name, order and request number, and xxxx number and amount. Invoice supporting documentation must include description of services performed, period of services performed, and any applicable cost share agreements. Supporting documentation will itemize details of billing, listing personnel, equipment, travel and per diem, aircraft, supplies and purchases as approved in the attached AOP. It will also include itemized deductions for maintenance and repair of equipment. Department invoices will include “Record of Activities” (FSLA-5) and U.S. Forest Service invoices will include transaction register. Invoices for services under this agreement must be sent to: Name: Xxxx Xxxxxx-Xxxxx, ECC Manager Address: 0000 Xxxxxxxxx Xxxxx Xxxx, Xxxxx, Xxx: Xxxxxxxxxx, XX 00000 Telephone: (000) 000-0000 FAX: (000) 000-0000 Email: xxxxxxxxxxxx@xx.xxx.xx Name: Spalding Community Service District Address: 000-000 Xxxxxxxx Xxx Xxxx, Xxxxx, Xxx: Xxxxxxxxxx, XX 00000 Telephone: (000) 000-0000 FAX: (000) 000-0000 Email: xxxxxxxxxxxxx@xxxxxxx.xxx All bills will have a payment due date 30 days upon receipt. Contested Xxxxxxxx: Written notice that a xxxx is contested will be mailed to the Party within 30 days of receipt of the invoice and will fully explain the contested items. Contested items should be resolved no later than 60 days following receipt of the written notice. Parties are responsible for facilitating resolution of contested xxxxxxxx. Billing requirements and rates are documented in the attached OP.

  • Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!