FINAL SYSTEM PRICING Sample Clauses

FINAL SYSTEM PRICING. System and installation pricing is subject to final system configuration. The design of the system may call for system devices to be placed in specific locations for systems with tag location and/or tamper detection capability or the use of End User or regulatory agency specific cable management systems. In the event that those locations are inaccessible (i.e., hard ceiling), an access hatch may be required to be installed at or near that location. The cost of installing appropriate access hatches will be the responsibility of the End User, or, if needed, CenTrak or its reseller (where applicable) dealer can install the hatch and the price can be added to the [applicable quotation]. CenTrak does not warrant system operational characteristics which may be affected by the pre-existing End User site constraints and/or environment situations such as (but not limited to) RF interference, metallic building infrastructure or materials, inter-device interference, and system design issues, or which may arise as a direct or indirect result of the physical placement of the devices in the End User's premises. Under these circumstances, CenTrak will notify the End User of their findings and provide recommendations to alleviate the customer site constraints and/or environmental issues. These recommendations may include (but not limited to) the requirement for additional services, modifications, and/or necessary equipment which are NOT included in the applicable quotation. EXHIBIT G CenTrak End User License Agreement THIS END USER LICENSE AGREEMENT (“XXXX”), is entered into by End User (as defined below), for the benefit of CenTrak, Inc., a Delaware corporation (“CenTrak”), as of the date (the “Effective Date”) of effectiveness of the related agreement between End User and CenTrak, or where applicable, CenTrak’s Reseller. End User acknowledges and agrees that Reseller will provide a copy of this XXXX to CenTrak, and that CenTrak shall have the full right to enforce all of CenTrak’s rights and remedies as against End User under this XXXX.
Sample 1
AutoNDA by SimpleDocs

Related to FINAL SYSTEM PRICING

  • Alternative Work Schedule An alternate forty (40) hour work schedule (other than five (5) uniform and consecutive eight (8) hour days in a seven (7) day period), or for hospital personnel an eighty (80) hour workweek in a fourteen (14) day period and other mutually agreed upon schedules that comply with applicable federal and state law. Employee work schedules normally include two (2) consecutive days off.

  • Alternative Work Schedules Alternative work schedule means an approved schedule for an Employee that deviates from the work week described in Section 1, Section 2, or a schedule that deviates from a worksite’s normal schedule. Employees who work a “shift work schedule” as part of a rotating group of individuals who must continuously maintain a 24-hour operation or facility are not eligible for an alternative work schedule.

  • Vehicle Base Specifications Note: The actual vehicle awarded may exceed the minimum specifications stated below. The Authorized User may elect to add additional Options, delete Options, or substitute a vehicle feature that is an Option with another Option. See Contract Section III.6

  • Technical Specification As enumerated in Special Conditions of Contract/Scope of Work/attached Drawing/ Details/Schedule of Rates.

  • Project Schedule Construction must begin within 30 days of the date set forth in Appendix A, Page 2, for the start of construction, or this Agreement may become null and void, at the sole discretion of the Director. However, the Recipient may apply to the Director in writing for an extension of the date to initiate construction. The Recipient shall specify the reasons for the delay in the start of construction and provide the Director with a new start of construction date. The Director will review such requests for extensions and may extend the start date, providing that the Project can be completed within a reasonable time frame.

  • Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.

  • Technical Specifications The Technical Specifications furnished on the CD are intended to establish the standards for quality, performance and technical requirements for all labor, workmanship, material, methods and equipment necessary to complete the Work. When specifications and drawings are provided or referenced by the County, these are to be considered part of the Scope of Work, and to be specifically documented in the Detailed Scope of Work. For convenience, the County supplied specifications, if any, and the Technical Specifications furnished on the CD.

  • Change Order Formats Formats for Lump Sum Change Orders and for Change Orders based upon either a force account or upon unit pricing with an indeterminate number of units are in Section 7, Forms.

  • Schematic Design Phase Services § 3.2.1 The Architect shall review the program and other information furnished by the Owner, and shall review laws, codes, and regulations applicable to the Architect’s services.

  • Implementation Schedule TIME IS OF THE ESSENCE with regard to all dates and time periods set forth and/or incorporated herein. Any material modification or deviation from an approved schedule described in this Agreement shall occur only upon approval of the City and RDA, with any such approvals required to be in writing as an amendment to this Agreement, and which approvals shall not be unreasonably withheld. City shall cooperate and act promptly with respect to any and all permits or approvals necessary for completion of the Project. Notwithstanding the above, this Agreement shall not limit the discretion of the City, or any of its duly appointed and authorized governing bodies, boards or entities, in approving or rejecting any aspect of the Project or improvements contemplated on or about the Property.

Time is Money Join Law Insider Premium to draft better contracts faster.