Fixing of Frames Sample Clauses

Fixing of Frames. The frames shall be got approved by the Engineer-in-Charge before being painted, oiled or otherwise treated and before fixing in position. The surface of the frames abutting masonry or concrete and the portions of the frames embedded in floors shall be given a coating of coal tar. Frames shall be fixed to the abutting masonry or concrete with holdfasts or metallic fasteners as specified. After fixing, the jamb posts of the frames shall be plugged suitably and finished neat. Vertical members of the door frames shall be embedded in the floor· for the full thickness of the floor finish and shall be suitably strutted and wedged in order to prevent warping during construction. A minimum of three hold fasts shall be fixed on each side of door and window frames one at centre point and other two at 30 cm from the top and bottom of the frames. In case of window and ventilator frames of less than 1 m in height two hold fasts shall be fixed on each side at quarter point of the frames. Hold fasts and metallic fasteners shall be measured and paid for separately.
Sample 1
AutoNDA by SimpleDocs
Fixing of Frames. The holes in concrete/masonry/wood/any other members for fixing anchor bolts/fasteners/screws shall be drilled with an appropriate electric drill. Windows/doors/ventilators etc. shall be placed in correct final position in the opening and fixed to Xxx xxxx backing using stainless steel screws of star headed, counter sunk and matching size groove. of required size at spacing not more than 250 mm c/c or dash fastener. All joints shall be sealed with approved silicone sealants. In the case of composite windows and doors, the different units are to be assembled first. The assembled composite units shall be checked for line, level and plumb before final fixing is done. Engineer-in-Charge in his sole discretion may allow the units to be assembled in their final location if the situation so warrants. Snap beadings and EPDM gasket shall be fixed as per the detail shown in the shop drawings. Where aluminium comes into contact with stone masonry, brick work, concrete, plaster or dissimilar metal, it shall be coated with an approved insulation lacquer, paint or plastic tape to ensure that electrochemical corrosion is avoided. Insulation material shall be trimmed off to a clean flush line on completion. The contractor shall be responsible for the doors, windows' etc. being set straight, plumb, level and for their satisfactory operation after fixing is complete.
Sample 1
Fixing of Frames. The frames are to be fixed in prepared openings in the walls. All civil work and tiling should be completed before the fixing of the frames. The frames are to be fixed directly on the plastered wall. In case tiling is to be done in the place the frames are to be fitted, a 50 mm strip should be left untiled at the location where the frames are to be fitted. The frames are erected in the prepared opening such that the vertical members of the door frame are embedded 50 mm in the floor. The frame shall be fitted truly in plumb. A minimum of three anchor bolts or screws of size 65/100 shall be used to fix each vertical member. One bolt shall be fixed at 200 mm from the top member and one bolt shall be fixed at 200 mm from the floor. The third anchor bolt shall be fixed in the center. The top horizontal member shall be fixed using two 65/100 size anchor bolts or screws at a distance of 200 mm from both the corners.
Sample 1

Related to Fixing of Frames

  • Passing of Risk Save as provided in paragraph 7.6, the time at which the risk shall pass shall be fixed in accordance with the International Rules for the Interpretation of Trade Terms (Incoterms) of the International Chamber of Commerce in force at the date of the formation of the contract.

  • Posting of Agreement 68.1 To ensure that the Parties are aware of the terms of the Agreement, and to assist in any resolution of a disputes or the avoidance thereof a copy of this Agreement shall be retained by the Employer at all times for ready access by any Employee on a project site or via access to the Employer’s intranet, and the Employer will provide a permanent copy for each Union Delegate or Employee representative and Health and Safety Representative on a project site.

  • Banking of RDOs (a) Where the Employer and an Employee agree up to five RDOs may be accrued for the purpose of creating a bank to be drawn upon by the Employee at times mutually agreed. Details of such banked RDOs will be entered on to each Employee’s employment records.

  • RECORDING OF AGREEMENT Tenant shall not record this Agreement on the Public Records of any public office. In the event that Tenant shall record this Agreement, this Agreement shall, at Landlord's option, terminate immediately and Landlord shall be entitled to all rights and remedies that it has at law or in equity.

  • RECORDING OF SERVICE INSTRUCTIONS The Bank may (but shall not be obliged to) at its absolute discretion tape or otherwise record all Service Instructions, and the Account Holder agrees to the use of such tapes or recordings and any transcripts thereof which the Bank may make for any purpose that the Bank deems desirable, including their use as evidence in any proceedings against the Account Holder or any other person.

  • Posting of Schedules The Employer shall post the weekly work schedule for all employees not later than Monday 6:00 p.m. and twenty-two (22) days in advance. An employee's schedule may be changed without notice in the event of absence of other staff due to sickness or accident or in the event of emergencies. In all other cases, at least twenty-four (24) hours' notice of any change must be given or four (4) additional hours' pay given in lieu of notice. All requests for time off for special personal events to be made to Management for their approval prior to the posting of the schedule, and will be granted wherever possible. It is understood that this clause does not apply to casual employees. There shall be a daily starting time for each employee. Daily hours of work for full time employees shall be consecutive, with the exception of meal periods.

  • Heating of Room Throughout the Term the Manager will provide a heating system sufficient to provide a comfortable temperature in the Room and will operate, maintain and repair that heating system. During any period in which the heating system is not functioning to the standards set out above, the Manager will use commercially reasonable efforts, after receiving notice of the deficiency, to have the system repaired and functioning as soon as may be possible in the circumstances. In no event however, is the Manager liable to the Resident for any consequential illness or discomfort and the Manager shall not be deemed to be in default of its obligations under this Agreement, so long as it is using commercially reasonable efforts to have the system repaired.

  • Pricing of Services Subcontractor shall provide or perform the Services at the pricing specified in Exhibit ___ to this Subcontract. [ATTACH A XXXX OF MATERIALS, RATE CARD OR OTHER APPROPRIATE COST SHEET COVERING THE SERVICES TO BE PROVIDED.]

  • Clearing of Record Any letter of reprimand, suspension or any other sanction will be removed from the record of an employee eighteen (18) months following the receipt of such letter, suspension or other sanction provided that such employee’s record has been discipline free for one year. All leaves of absence in excess of ten (10) calendar days will not count toward either of the above periods.

  • SIGNING OF AGREEMENT 37.1 Within 21 days of receipt of the notification of award, the successful bidder shall sign the Form of Agreement and return it to the Employer, together with the required performance security.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!