GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site.
Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer.
Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations.
Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage.
Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer.
Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized.
Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel.
Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations.
Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job.
Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours.
Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement.
Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Actions to Satisfy Closing Conditions Each Party shall take all such actions as are within its power to control, and shall use its best efforts to cause other actions to be taken which are not within its power to control, so as to ensure compliance with any conditions set forth in this Agreement which are for the benefit of itself or any other Party.
WORKING CONDITIONS 9.01 Lunch periods shall be at mid-shift.
9.02 The Employer shall allow each employee two (2) breaks of ten (10) minutes each, but not more in a work shift. Time of breaks shall be mutually agreed upon.
9.03 Essential protective clothing including welder’s gloves, protective vests or leather jackets, noise abatement devices, and rainwear shall be supplied at no charge to the employee. In the event that an employee does not return the foregoing items supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any money owing to the employee.
9.04 Chemical or flush toilets shall be provided from the commencement of work on all jobs. Where the sewer or chemical toilets are not available, sanitary toilet facilities shall be provided as called for in local sanitary regulations. Toilet houses shall be painted, at least on the inside, and cleaned out daily. Toilet paper will be provided.
9.05 Where there is no running tap water available, drinking water in approved sanitary containers shall be provided. Paper cups will be supplied. Salt tablets shall be supplied during the summer months.
9.06 If requested by the Union or employee, the Employer will provide within three (3) calendar days, a termination slip which shall state the reason for the employee’s termination and whether or not he is eligible for rehire.
9.07 Adequate time will be allowed prior to quitting time for picking up tools.
9.08 A lock-up shall be provided for employees for drying clothes, and dressing room, as well as lunch room. The lock-up shall have tables, and benches with provision for drying clothes. Such lock-up shall have windows and venting with adequate lighting and provision for continuous heat twenty-four (24) hours a day. The Employer shall be responsible for having the lock-up cleaned out daily and kept cleared of building material and other construction paraphernalia. Additional shelters shall be provided for employees to eat their lunch as may be required.
9.09 In case of fire or burglary on property or premises provided by the Employer, the Employer shall protect the value of an employee’s work clothes up to a total of three hundred and fifty dollars ($350.00). The Employer shall also provide fire and burglary insurance for the employees required tools to a total value of the tools, tool for tool, make for make, provided an inventory of tools and clothing is filed with the Employer. The Employer shall supply the required forms and obtain the inventory from each employee. The employee shall receive a signed copy of the inventory from the Employer. Coverage will commence at the date of the filing of the inventory with the Employer. Where an employee fails to file an inventory his rights to submit a claim shall be waived.
(a) All mechanics, welders, servicemen, tire servicemen, drill doctors, steel sharpeners, bodymen painters, and mechanics and welder apprentices who request coveralls shall have these supplied and cleaned by the Employer. There shall be one change a week available in the employee’s proper size. Employees are expected to take reasonable care of coveralls supplied. In the event that an employee does not return the coveralls supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any monies owing to the employee. When requested, coveralls shall be supplied on a temporary basis to employees who assist on work as described above, or where the Employer and the Union mutually agree that coveralls are required.
(b) Employees entitled to receive coveralls as provided herein may obtain an additional change of coveralls in any one week providing the condition of the coveralls requires a change. The shop xxxxxxx shall use discretion in authorizing the additional change.
(c) All shops shall provide adequate clean-up facilities.
9.11 The Employer shall pay the cost of obtaining operators’ licences other than those required under the Motor Vehicles Act for employees covered by this Agreement.
9.12 No employee will be permitted to use his own motor vehicle in a manner which is unfair to other members or against the best interest of the Union.
9.13 Each employee being terminated will be given one (1) hour’s notice of termination by the Employer or one (1) hour’s pay allowed in lieu thereof. Heavy duty mechanics and apprentice mechanics may utilize this hour to gather together their tools and put them in shape for their next job.
9.14 When a mechanic leaves the employ of the Employer, the Employer shall be required to pay cost of shipping mechanic’s tools. Tools shall be shipped within forty-eight (48) hours of his leaving his employment, subject to the same conditions as govern transportation. When an Operating Engineer elects to transport his own tools to and from the jobsite, the employee shall be paid the rate of two dollars and seventy-five cents ($2.75) per one hundred (100) pounds per one hundred (100) miles. (e.g. $2.75 x 528 pounds x 273 miles = $39.64). Where the Employer fails to comply with the above, the employee shall be deemed to be still on the payroll of the Employer and shall receive his usual wages and all other conditions of this Agreement until there is compliance with these provisions.
9.15 Where an employee is involved in an accident while on the job and as a result is unable to perform his work, he shall receive a full day’s pay for the day of the accident.
Closing Conditions (a) The obligations of the Company hereunder in connection with the Closing are subject to the following conditions being met:
(i) the accuracy in all material respects (or, to the extent representations or warranties are qualified by materiality or Material Adverse Effect, in all respects) on the Closing Date of the representations and warranties of the Purchasers contained herein (unless as of a specific date therein in which case they shall be accurate as of such date);
(ii) all obligations, covenants and agreements of each Purchaser required to be performed at or prior to the Closing Date shall have been performed; and
(iii) the delivery by each Purchaser of the items set forth in Section 2.2(b) of this Agreement.
(b) The respective obligations of the Purchasers hereunder in connection with the Closing are subject to the following conditions being met:
(i) the accuracy in all material respects (or, to the extent representations or warranties are qualified by materiality or Material Adverse Effect, in all respects) when made and on the Closing Date of the representations and warranties of the Company contained herein (unless as of a specific date therein in which case they shall be accurate as of such date);
(ii) all obligations, covenants and agreements of the Company required to be performed at or prior to the Closing Date shall have been performed;
(iii) the delivery by the Company of the items set forth in Section 2.2(a) of this Agreement;
(iv) there shall have been no Material Adverse Effect with respect to the Company since the date hereof; and
(v) from the date hereof to the Closing Date, trading in the Common Stock shall not have been suspended by the Commission or the Company’s principal Trading Market, and, at any time prior to the Closing Date, trading in securities generally as reported by Bloomberg L.P. shall not have been suspended or limited, or minimum prices shall not have been established on securities whose trades are reported by such service, or on any Trading Market, nor shall a banking moratorium have been declared either by the United States or New York State authorities nor shall there have occurred any material outbreak or escalation of hostilities or other national or international calamity of such magnitude in its effect on, or any material adverse change in, any financial market which, in each case, in the reasonable judgment of such Purchaser, makes it impracticable or inadvisable to purchase the Securities at the Closing.
Adverse Weather Conditions Except in emergency conditions, the Employer shall not require an employee to work outside under extreme weather conditions.
Market Conditions Notwithstanding any provision of this Agreement to the contrary, settlement and payment for Foreign Assets received for the account of the Portfolios and delivery of Foreign Assets maintained for the account of the Portfolios may be effected in accordance with the customary established securities trading or processing practices and procedures in the country or market in which the transaction occurs, including, without limitation, delivering Foreign Assets to the purchaser thereof or to a dealer therefor (or an agent for such purchaser or dealer) with the expectation of receiving later payment for such Foreign Assets from such purchaser or dealer. The Custodian shall provide to each Board the information with respect to custody and settlement practices in countries in which the Custodian employs a Foreign Sub-Custodian described on Schedule C hereto at the time or times set forth on such Schedule. The Custodian may revise Schedule C from time to time, provided that no such revision shall result in a Board being provided with substantively less information than had been previously provided hereunder.
Satisfaction of Closing Conditions (a) The parties shall use their commercially reasonable best efforts to take all action necessary or appropriate to bring about the satisfaction as soon as possible of all the conditions contained in Section 7. Without limiting the generality of the foregoing, the parties shall apply for and diligently prosecute all applications for, and shall use their commercially reasonable best efforts promptly to obtain, such consents, authorizations and approvals from such third parties and governmental authorities as shall be necessary to permit the consummation of the transactions contemplated by this Merger Agreement, including, without limitation, making the requisite filings with the Federal Trade Commission and the Antitrust Division of the Department of Justice pursuant to the HSR Act and each party will refrain from taking any action which would cause, and shall use its commercially reasonable best efforts to take any action necessary to prevent, any of the representations and warranties made by it in this Merger Agreement not to be true and correct in all material respects at and as of the Closing Date with the same force and effect as then made (except with respect to representation and warranties which are made as of a specific date), subject only to exceptions permitted or expressly contemplated by this Merger Agreement. The Company further covenants and agrees, with respect to any threatened or pending judgment, order, injunction, decree or decision of any governmental authority that will adversely affect the ability of the parties hereto to consummate the transactions contemplated hereby, to use all commercially reasonable efforts to prevent the entry or promulgation thereof and to defend and cooperate with each other in the defending of any legal proceedings, whether judicial or administrative and whether brought derivatively or on behalf of third parties challenging the transaction contemplated hereby as the case may be, it being understood that such efforts shall not include any requirement of the Company to expend material sums of money or grant any material financial or other accommodation.
(b) The Buyer agrees to use commercially reasonable best efforts to obtain the financing necessary to consummate the transactions contemplated hereby as soon as possible. The Buyer agrees that any 144A offerings contemplated by the Financing Letters must be consummated prior to October 31, 1998 and that if any such offering is not consummated prior to such date, then the Buyer will be obligated on October 31, 1998 to obtain the bridge loan financing contemplated by the Financing Letter in substitution therefor pursuant to the terms thereof, subject to the conditions for such bridge loan financing set forth in the Financing Letters. The Company agrees to provide, and will cause its subsidiaries and their respective personnel and advisers to provide, all cooperation reasonably requested in connection with the arrangement of such financing, including without limitation, participation in meetings, due diligence sessions, road shows, the preparation of offering memoranda, private placement memoranda, prospectuses and similar documents, the execution and delivery of any commitment letters, underwriting or placement agreements, pledge and security documents, other definitive financing documents, or other requested certificates or documents, including a certificate of the chief financial officer of the Company with respect to solvency matters, comfort letters of accountants as may be reasonably requested by Buyer. Notwithstanding the foregoing, Buyer agrees that the payment of any expenses relating to providing such cooperation, including fees by the Company in connection with any commitment letters, shall be subject to the occurrence of the Closing.
CONDITIONS TO LOANS The obligations of Lenders to make Loans are subject to satisfaction of all of the applicable conditions set forth below.
Existing Conditions Tenant accepts the Property in its condition as of the execution of the Lease, subject to all recorded matters, laws, ordinances, and governmental regulations and orders. Except as provided herein, Tenant acknowledges that neither Landlord nor any agent of Landlord has made any representation as to the condition of the Property or the suitability of the Property for Tenant's intended use. Tenant represents and warrants that Tenant has made its own inspection of and inquiry regarding the condition of the Property and is not relying on any representations of Landlord or any Broker with respect thereto. If Landlord or Landlord's Broker has provided a Property Information Sheet or other Disclosure Statement regarding the Property, a copy is attached as an exhibit to the Lease.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
