Procurement Requirements The below listed provisions of State Procurement requirements shall be complied with throughout the contract period:
U.S. Federal Procurement Requirements Without limiting Section 12.1, in light of DXC’s status as a U.S. Federal contractor and subcontractor, all applicable procurement regulations required by federal statute or regulation to be inserted in contracts or subcontracts apply to this Order, including but not limited to FAR 52.219-8 (Utilization of Small Business Concerns), FAR 52.219.-9 (Small Business Subcontracting Plan), FAR 52.219-16 (Liquidated Damages Subcontracting Plan), FAR 52.222-26 (Equal Opportunity), FAR 52.222-35 (Equal Opportunity for Special Disabled Veterans, Veterans of the Vietnam Era, and other Eligible Veterans), FAR 52.222-36 (Affirmative Action for Workers with Disabilities), FAR 52.222-39 ( Notification of Employee Rights Concerning Payment of Union Dues or Fees), FAR 52.222-41 (Service Contract Act of 1965), and FAR 52.247-64 (Preference for Privately Owned U.S. Flag Commercial Vessels).
Management Requirements Procedures for managing equipment (including replacement equipment), whether acquired in whole or in part under a Federal award, until disposition takes place will, as a minimum, meet the following requirements:
Agreement Requirements This agreement will be issued to cover the Janitorial Service requirements for all State Agencies and shall be accessible to any School District, Political Subdivision, or Volunteer Fire Company.
General Program Requirements Subrecipient shall adhere, but not be limited to, the following requirements for all programs:
Equipment Requirements No Equipment is provided to Customer as part of this Service.
Development Requirements The exterior wall standards set forth in this section shall apply to the structures located on the Property. At least ninety percent (90%) of the combined exterior surface area of all walls, including all stories of buildings / structures, shall consist of stone, brick, painted or tinted stucco, and factory tinted (not painted) split faced concrete masonry unit or similar material approved by the Director of Planning.
Divestment Requirements 34.1.1 Upon Termination, the Concessionaire shall comply with and conform to the following Divestment Requirements:
GENERAL OPERATIONAL REQUIREMENTS 12.1 Interference or damage to Distributor's Equipment by Customers: The Trader must, subject to clause 29.1, include in each of its Customer Agreements a requirement that, during the term of the Customer Agreement and until the end of the period ending on the earlier of 6 months after the termination of the Customer Agreement or the date on which a new Customer Agreement is entered into in respect of the relevant ICP, the Customer must not interfere with or damage, and must ensure that its agents and invitees do not interfere with or damage, the Distributor's Equipment without the prior written consent of the Distributor (except to the extent that emergency action has to be taken to protect the health or safety of persons or to prevent damage to property).
Project Requirements Failure to comply with the following requirements will result in a suspension of all other operations: