Honeywell Shall Implement Sample Clauses

Honeywell Shall Implement.  Provide Discharge Air Temperature (DAT) control, economizer control, morning warm-up with OA dampers closed, and space temperature control.  Provide and install five (5) new 2-way heating valves and actuators for the steam unit vents.  Remove existing pneumatic thermostat and provide a blank plate if the new DDC sensor isn’t mounted in the same location.  Occupied/Unoccupied schedules and set points are to be programmed per Exhibit G1 and G2.  Graphics for units showing proper points and associating alarm points with their respective graphic pages.  Integration into the existing BMS.
Sample 1See All (6)
AutoNDA by SimpleDocs
Honeywell Shall Implement.  The two (2) gym space sensors will be combination CO2 and space temperature. The CO2 readings will be used for the DCV sequence for the gym H&V unit. Provide protective covers over space sensors mounted in the gym.  Provide and install fifteen (15) new 2-way heating valves and actuators on the radiators.  Occupied/Unoccupied schedules and set points are to be programmed per Exhibit G1 and G2.  Remove existing pneumatic thermostat and provide a blank plate if the new DDC sensor isn’t mounted in the same location.  Graphics for units showing proper points and associating alarm points with their respective graphic pages.  Integration into the existing BMS.
Sample 1
Honeywell Shall Implement.  Provide DAT control, economizer control, MAT control, DCV, and reheat coil control.  Reuse existing valves. Provide new damper actuators and commission OA dampers.  Retain all existing H&V safety interlocks.  Graphics for units showing proper points and associating alarm points with their respective graphic pages.
Sample 1
Honeywell Shall Implement.  Enable/disable control of the chiller based on outside air lockout setpoint.  Chilled water available signal to all associated cooling equipment.  Graphics for units showing proper points, setpoints, and associating alarm points with their respective graphic pages. Family Resource Center – Scope of Work
Sample 1
Honeywell Shall Implement.  Provide DAT control, economizer control, zone temp control, and DCV. TAB OA/RA dampers.  Provide RTU-5 static pressure control and VAV zone damper control  Commission OA/RA dampers and zone dampers.  Graphics for all units showing proper points and associated alarm points with their respective graphic pages.  Occupied/Unoccupied schedules and setpoints as outlined in the IGA REPORT.  Graphics for units showing proper points and associating alarm points with their respective graphic pages.
Sample 1
Honeywell Shall Implement.  Install new JACE AX controller to allow existing Invensys controls to be integrated into the new Building Management System.  New graphics for existing units showing proper points and associating alarm points with their respective graphic pages.
Sample 1
Honeywell Shall Implement.  Provide DAT control, economizer control, zone temp control, and DCV.  Occupied/Unoccupied schedules and setpoints as outlined in the IGA REPORT.  Commission OA/RA dampers. – Note, work includes testing and adjusting linkages as necessary to provide tight close-off of dampers modulated in both directions. Customer will be notified if dampers need replacement.  Graphics for units showing proper points and associating alarm points with their respective graphic pages.
Sample 1
AutoNDA by SimpleDocs
Honeywell Shall Implement.  Install new sensors and control existing valve.  Occupied/Unoccupied schedules and setpoints as outlined in the IGA REPORT.  Graphics for units showing proper points and associating alarm points with their respective graphic pages.
Sample 1

Related to Honeywell Shall Implement

  • Provisioning of High Frequency Spectrum and Splitter Space 3.2.1 BellSouth will provide <<customer_name>> with access to the High Frequency Spectrum as follows:

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CBB chooses to subtend a Verizon access Tandem, CBB’s NPA/NXX must be assigned by CBB to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG.

  • Construction Management Plan Contractor shall prepare and furnish to the Owner a thorough and complete plan for the management of the Project from issuance of the Proceed Order through the issuance of the Design Professional's Certificate of Material Completion. Such plan shall include, without limitation, an estimate of the manpower requirements for each trade and the anticipated availability of such manpower, a schedule prepared using the critical path method that will amplify and support the schedule required in Article 2.1.5 below, and the Submittal Schedule as required in Article 2.2.3. The Contractor shall include in his plan the names and resumés of the Project Superintendent, Project Manager and the person in charge of Safety.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.

  • Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.

  • Project Implementation 2. The Borrower shall:

  • Data shared with Subcontractors If DSHS Data provided under this Contract is to be shared with a subcontractor, the Contract with the subcontractor must include all of the data security provisions within this Contract and within any amendments, attachments, or exhibits within this Contract. If the Contractor cannot protect the Data as articulated within this Contract, then the contract with the sub- Contractor must be submitted to the DSHS Contact specified for this contract for review and approval.

  • Alignment with Modernization Foundational Programs and Foundational Capabilities The activities and services that the LPHA has agreed to deliver under this Program Element align with Foundational Programs and Foundational Capabilities and the public health accountability metrics (if applicable), as follows (see Oregon’s Public Health Modernization Manual, (xxxx://xxx.xxxxxx.xxx/oha/PH/ABOUT/TASKFORCE/Documents/public_health_modernization_man ual.pdf):

  • Contractor Cooperation CONTRACTOR shall actively participate and cooperate with County, State and/or federal representatives in the monitoring, assessment and evaluation processes, including making any program and any administrative staff (fiscal, etc.) available at the request of such representatives.

  • Approval of Contractor’s Staff 7.3.1 County has the absolute right to approve or disapprove all of the Contractor’s staff performing work hereunder and any proposed changes in the Contractor’s staff, including, but not limited to, the Contractor’s Project Manager.

Time is Money Join Law Insider Premium to draft better contracts faster.