Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
TRAINING AND RELATED MATTERS The parties recognise that in order to increase the efficiency and productivity of the company a significant commitment to structured training and skill development is required. Accordingly the parties commit themselves to:
a) The parties to this Agreement recognise the importance of the apprenticeship system to the construction industry. It is agreed that every employer party to this Agreement who employs five (5) or more tradespersons in any one classification shall undertake to employ at least one (1) apprentice or make arrangements to host an apprentice from an agreed group apprenticeship scheme. Where an employer does not currently have an apprentice as per this provision, reasonable time shall be allowed to enable the employer to comply with this clause. Further, the parties are committed to a strong ratio of apprentices in the industry. Apprenticeship levels on a specific project may be discussed at the Project Pre-Commencement Conference (refer Clause 16).
b) Providing employees with the opportunity to acquire additional skills within relevant career path structures through appropriate structured training based on nationally endorsed (i.e. Construction Training Australia endorsed) competency standards and curriculum;
c) Actively encouraging employees to seek formal recognition of their skills (i.e. recognition of prior learning); and
d) Using training providers accredited and acceptable to the parties. The CFMEU, MBAV and other employer associations are legitimately engaged in providing training to industry and it is hereby agreed that all parties will properly recognise and accept the validity of nationally accredited training as provided by the other parties.
e) The parties will consult on the development of training programs which are consistent with the following: • Training provided will be consistent with the company’s business requirements, relevant to the work of the employees, consistent with the skills development of each employee and with applicable national competency standards. • Training may be taken either on or off the job with all reasonable steps being taken to conduct training in normal working hours. • If an approved training activity is undertaken during ordinary working hours, the employee/s concerned shall not suffer any loss of pay. • Approved training activities undertaken outside of ordinary hours will be paid at single time or will, at the employee’s option, be taken as time off in lieu of payment. Provided that the scheduling of time off must be consistent with the needs of the business and be by agreement with the company. • Training costs of courses approved by the company will be met by the company. • The company will not be asked to meet the costs of training undertaken by employees which was not approved by the company. • Leave of absence granted pursuant to this clause shall count as service for all purposes of the award and this agreement. • Accredited members of the union will be allowed up to 5 days per year, without loss of pay, to attend trade union educational courses conducted or approved by the union. (see appendix H)
f) The parties to this Agreement recognise the importance of the role that Apprentices/Trainees fulfill within the industry and, more importantly, a role that they will fulfill as trades persons following the conclusion of the indentures. To this end the Victorian Building Industry Consultative Committee will investigate ways of enhancing employment prospects for Apprentice/Trainees. In addition it is agreed that, where appropriate, employers will use their best endeavours to employ Apprentices/Trainees in order to ensure appropriate trade persons levels for the future.
Training and Support Licensor shall offer installation support to the Licensee and each of the Members, including assisting with the implementation of any Licensor software. Licensor will provide appropriate training to Licensee and Member staff relating to the use of the Licensed Materials and any Licensor software. Licensor will offer reasonable levels of continuing support to assist Licensee and Members in use of the Licensed Materials, including providing help files and other appropriate user documentation in connection with the use of and access to Licensed Materials. Licensor will, at a minimum, make its personnel available by email, telephone or via the Web, or in person during Licensor’s regular business hours, Monday through Friday, for training and user access support.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction.
(b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Department of Housing and Urban Development Iowa Civil Rights Commission 000 Xxxx 00xx Xxxxxx
Training and Education SECTION 1 – Law Enforcement Supervisors’ Training
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Advertising and Marketing Except in so far as herein expressly provided, the Service Provider shall not make or issue any formal or informal announcement (with the exception of Stock Exchange announcements), advertisement or statement to the media in connection with this Agreement or otherwise disclose the existence of this Agreement or the subject matter thereof to any other person without the prior written consent of SARS.
Training and Development 3.1 Authorities will develop local 'Workforce Development Plans (see Part 4.8),' closely linked to their service delivery plans, which will provide the focus for the establishment of training and development priorities. Training and development should be designed to meet the corporate and service needs of authorities both current and in the future, taking into account the individual needs of employees. Local schemes on training and development should enable authorities to attain their strategic objectives through development of their employees. Training and development provisions should be shaped to local requirements and take account of the full range of learning methods. Such an approach should enable access to learning for all employees. The needs of part time employees and shift workers need particular consideration.
3.2 Employees attending or undertaking required training are entitled to payment of normal earnings; all prescribed fees and other relevant expenses arising. Employees are also entitled to paid leave for the purpose of sitting for required examinations. When attending training courses outside contracted daily hours, part-time employees should be paid on the same basis as full- time employees. (Assistance for other forms of learning, for example that directed at individual development, will be locally determined). Some training can be very expensive and authorities may require repayment of all or part of the costs incurred should an employee leave the authority before a reasonable time period has expired. The authority's policy in this regard should be made explicit.
3.3 Objectives for training and development programmes should include the following: • To enable Councils to attain their strategic objectives via investment in their employees. • To promote equity of access to learning. • To encourage employees to develop their skills and level of responsibility to the maximum of their individual potential. • To widen and modernise the skills profile of employees to maximise their versatility, employability and so, job security. • To enable employees to raise productivity, quality and customer service in pursuit of sustainable improvement
3.4 Authorities should establish local partnership arrangements, to include recognised trade unions, to develop their local workforce development plans.
3.5 The NJC endorses partnership provision such as the "Return to Learn" scheme. Authorities and the recognised trade unions shall encourage and support employees taking on the statutory Union Learning Representative (ULR) role. This will include agreeing facilities and paid release in accordance with statutory provisions. ULRs should be enabled to play a full part in promoting and implementing local training and development programmes.
Training and Promotion a. The contractor will assist in locating, qualifying, and increasing the skills of minorities and women who are applicants for employment or current employees. Such efforts should be aimed at developing full journey level status employees in the type of trade or job classification involved.
b. Consistent with the contractor's work force requirements and as permissible under Federal and State regulations, the contractor shall make full use of training programs, i.e., apprenticeship, and on-the-job training programs for the geographical area of contract performance. In the event a special provision for training is provided under this contract, this subparagraph will be superseded as indicated in the special provision. The contracting agency may reserve training positions for persons who receive welfare assistance in accordance with 23 U.S.C. 140(a).
c. The contractor will advise employees and applicants for employment of available training programs and entrance requirements for each.
d. The contractor will periodically review the training and promotion potential of employees who are minorities and women and will encourage eligible employees to apply for such training and promotion.
