Implementation of Changes If Tenant: (i) approves in writing the cost or savings and the estimated extension in the time for completion of Landlord’s Work, if any, and (ii) deposits with Landlord any Excess TI Costs required in connection with such Change, Landlord shall cause the approved Change to be instituted. Notwithstanding any approval or disapproval by Tenant of any estimate of the delay caused by such proposed Change, the TI Architect’s determination of the amount of Tenant Delay in connection with such Change shall be final and binding on Landlord and Tenant.
Construction Plans Tenant shall prepare final plans and specifications for the Tenant Improvements that (a) are consistent with and are logical evolutions of the Approved Schematic Plans and (b) incorporate any other Tenant-requested (and Landlord-approved) Changes (as defined below). As soon as such final plans and specifications ("Construction Plans") are completed, Tenant shall deliver the same to Landlord for Landlord's approval, which approval shall not be unreasonably withheld, conditioned or delayed. All such Construction Plans shall be submitted by Tenant to Landlord in electronic .pdf, CADD and full-size hard copy formats, and shall be approved or disapproved by Landlord within ten (10) business days after delivery to Landlord. Landlord's failure to respond within such ten (10) business day period shall be deemed approval by Landlord. If the Construction Plans are disapproved by Landlord, then Landlord shall notify Tenant in writing of its objections to such Construction Plans, and the parties shall confer and negotiate in good faith to reach agreement on the Construction Plans. Promptly after the Construction Plans are approved by Landlord and Tenant, two (2) copies of such Construction Plans shall be initialed and dated by Landlord and Tenant, and Tenant shall promptly submit such Construction Plans to all appropriate Governmental Authorities for approval. The Construction Plans so approved, and all change orders approved (to the extent required) by Landlord, are referred to herein as the "Approved Plans."
APPROVAL OF PLANS AND SPECIFICATIONS The Plans and Specifications will conform to the requirements and conditions set out by applicable law or any effective restrictive covenant, and to all governmental authorities which exercise jurisdiction over the Leased Premises or the construction thereon.
Development Plans 4.3.1 For each Licensed Indication and corresponding Licensed Product in the Field, Licensee will prepare and deliver to Licensor a development plan and budget (each a “Development Plan”). The initial Development Plans for each Licensed Indication will be delivered within […***…] after the Grant Date for such Licensed Indication.
Specification Changes Upon any change in the Product Specifications, stability protocols, QC laboratory methods raw material specification or Packaging Specifications (whether initiated by Horizon or made in response to a request by sanofi-aventis that is agreed to by Horizon), including the addition of new packaging configurations, new SKUs, new formulations, or a change in either raw materials or Packaging Component supply, Horizon shall promptly advise sanofi-aventis in writing of such changes, and sanofi-aventis shall promptly advise Horizon as to any scheduling and/or price adjustments which may result from such changes. Prior to implementation of such changes, the Parties shall negotiate in good faith in an attempt to reach agreement on (a) the new Product Price for any Product which embodies such changes, (b) any amounts to be reimbursed by Horizon to sanofi-aventis as described in the next sentence of this paragraph, and (c) any other amendments to this Agreement which may be necessitated by such changes (i.e., an adjustment to the lead time for purchase orders). Horizon shall reimburse sanofi-aventis for the mutually agreed upon reasonable expenses incurred by sanofi-aventis as a result of such changes, including, but not limited to, reimbursing sanofi-aventis for its mutually agreed validation and development costs, capital expenditure costs, costs for any Packaging Components or other materials rendered unusable as a result of such changes, and cost of required stability to support a change. If during the Term Horizon amends the Product Specifications or Packaging ***Confidential Treatment Requested MANUFACTURING AND SUPPLY AGREEMENT PAGE 7 Specifications (whether voluntarily or as required by law) so as to render obsolete quantities of the Active Ingredient, Excipients and/or Packaging Components for the Product on hand at sanofi-aventis, Horizon shall (i) accept the return of all such obsolete Active Ingredient and (ii) purchase from sanofi-aventis, at sanofi-aventis’ Acquisition Cost, all such obsolete Excipients and Packaging Components obtained by sanofi-aventis pursuant to its normal procurement policies to manufacture quantities of the Product pursuant to Horizon forecasts under Section 6.1. Sanofi-aventis’ normal procurement policies for purposes of the preceding sentence of this Article 5 shall be considered to be quantities of Excipients and Packaging Components corresponding to the immediately following […***…] months of Horizon’s most recent forecasted Product demand. If a change in Specifications is initiated by sanofi-aventis and approved by Horizon, any cost associated with said change shall be borne by sanofi-aventis. In the event that a change in Specifications is initiated by Horizon or driven by a regulatory or business change, the costs associated with qualification of the change shall be paid by Horizon. The amount of the change shall be reasonable and customary and subject to written approval by Horizon, such approval not to be unreasonably withheld. Sanofi-aventis, with written agreement and approval from Horizon, will be responsible for the appropriate (cGMP) destruction of any materials covered under this Article 5, and sanofi-aventis shall be reimbursed by Horizon at the reasonable and customary approved rate.
Changes to Specifications All Specifications and any changes thereto agreed to by the parties from time to time shall be in writing, dated and signed by the parties. Any change to the Packaging process shall be deemed a Specification change. No change in the Specifications shall be implemented by PCI, whether requested by Client, requested by PCI or requested or required by any Regulatory Authority, until the parties have agreed in writing to such change, the implementation date of such change, and any increase or decrease in costs, expenses or fees associated with such change (including any change to Pricing). PCI shall respond promptly to any request made by Client for a change in the Specifications, and both parties shall use commercially reasonable, good faith efforts to agree to the terms of such change in a timely manner. As soon as possible after a request is made for any change in Specifications, PCI shall notify Client of the costs associated with such change and shall provide such supporting documentation as Client may reasonably require. Client shall pay all costs associated with such agreed upon changes. If there is a conflict between the terms of this Agreement and the terms of the Specifications, this Agreement shall control. PCI reserves the right to postpone effecting changes to the Specifications, or in the case of changes requested or required by any Regulatory Authority postpone Packaging under this Agreement, until such time as the parties agree to and execute the required written amendment.
Work Plans Tenant shall prepare and submit to Landlord for approval schematics covering the Tenant Improvements prepared in conformity with the applicable provisions of this Work Letter (the “Draft Schematic Plans”). The Draft Schematic Plans shall contain sufficient information and detail to accurately describe the proposed design to Landlord and such other information as Landlord may reasonably request. Landlord shall notify Tenant in writing within ten (10) business days after receipt of the Draft Schematic Plans whether Landlord approves or objects to the Draft Schematic Plans and of the manner, if any, in which the Draft Schematic Plans are unacceptable. Landlord’s failure to respond within such ten (10) business day period shall be deemed approval by Landlord. If Landlord reasonably objects to the Draft Schematic Plans, then Tenant shall revise the Draft Schematic Plans and cause Landlord’s objections to be remedied in the revised Draft Schematic Plans. Tenant shall then resubmit the revised Draft Schematic Plans to Landlord for approval, such approval not to be unreasonably withheld, conditioned or delayed. Landlord’s approval of or objection to revised Draft Schematic Plans and Tenant’s correction of the same shall be in accordance with this Section until Landlord has approved the Draft Schematic Plans in writing or been deemed to have approved them. The iteration of the Draft Schematic Plans that is approved or deemed approved by Landlord without objection shall be referred to herein as the “Approved Schematic Plans.”
