AS9100 Certification AS9100 Certification, specifies requirements for a quality management system to demonstrate the Contractor’s ability to consistently meet the customer requirements as well as statutory and regulatory requirements for the aerospace industry. An AS9100 Certification, is not mandatory; however, Contractors who desire to compete for work within the aerospace industry are encouraged to have AS9100 Certification, during the entire term of OASIS. The Contractor shall notify the OASIS CO, in writing, if there are any changes in the status of their AS9100 Certification, and provide the reasons for the change and copies of audits from an AS9100 Certification Body, as applicable. If only part of a Contractor’s organization is AS9100, certified, the Contractor shall make the distinction between which business units or sites and geographic locations have been certified.
DAF Specifications Developer shall submit initial specifications for the DAF, including System Protection Facilities, to Connecting Transmission Owner and NYISO at least one hundred eighty (180) Calendar Days prior to the Initial Synchronization Date; and final specifications for review and comment at least ninety (90) Calendar Days prior to the Initial Synchronization Date. Connecting Transmission Owner and NYISO shall review such specifications to ensure that the DAF are compatible with the technical specifications, operational control, and safety requirements of the Connecting Transmission Owner and NYISO and comment on such specifications within thirty (30) Calendar Days of Developer’s submission. All specifications provided hereunder shall be deemed to be Confidential Information.
General specifications For the purpose of this Regulation, the vehicle shall fulfil the following requirements:
CLEC Certification 8.1 Notwithstanding any other provision of this Agreement, CenturyLink shall have no obligation to perform under this Agreement until such time as CLEC has obtained such FCC and Commission authorization(s) as may be required by Applicable Law for conducting business in the State as a competitive local exchange carrier. CLEC shall not be permitted to establish its account nor place any orders under this Agreement until it has obtained such authorization and provided proof of such to CenturyLink. For the life of this Agreement, CLEC must represent and warrant to CenturyLink that it remains a certified local provider of Telephone Exchange Service within CenturyLink’s Local Calling Area(s) in the State. At any time during the life of this Agreement, CLEC will provide a copy of its current Certificate of Operating Authority or other evidence of its status to CenturyLink upon request. CLEC’s failure to maintain such authorization(s) as may be required by Applicable Law for conducting business in the State as a CLEC shall be considered a Default of Agreement.
Technical Specifications The Technical Specifications furnished on the CD are intended to establish the standards for quality, performance and technical requirements for all labor, workmanship, material, methods and equipment necessary to complete the Work. When specifications and drawings are provided or referenced by the County, these are to be considered part of the Scope of Work, and to be specifically documented in the Detailed Scope of Work. For convenience, the County supplied specifications, if any, and the Technical Specifications furnished on the CD.
ODUF Packing Specifications 6.3.1 A pack will contain a minimum of one message record or a maximum of 99,999 message records plus a pack header record and a pack trailer record. One transmission can contain a maximum of 99 packs and a minimum of one pack.
Licenses and Certifications Where required by law, PROVIDER must, at all times, be licensed or certified by either the State or County as a qualified provider of the services purchased hereby. PROVIDER shall fully cooperate with licensing and certification authorities. PROVIDER shall submit copies of the required licenses or certifications upon request by COUNTY. PROVIDER shall promptly notify COUNTY in writing of any citation PROVIDER receives from any licensing or certification authority, including all responses and correction plans.
OFAC Certification Company certifies that (i) it is not acting on behalf of any person, group, entity, or nation named by any Executive Order or the United States Treasury Department, through its Office of Foreign Assets Control (“OFAC”) or otherwise, as a terrorist, “Specially Designated Nation”, “Blocked Person”, or other banned or blocked person, entity, nation, or transaction pursuant to any law, order, rule or regulation that is enforced or administered by OFAC or another department of the United States government, and (ii) Company is not engaged in this transaction on behalf of, or instigating or facilitating this transaction on behalf of, any such person, group, entity or nation.
Quality Specifications SANMINA-SCI shall comply with the quality specifications set forth in its Quality Manual, incorporated by reference herein, a copy of which is available from SANMINA-SCI upon request.
New Certifications If a participating Employer is newly certified by ONA at one of its owned nursing homes for its registered nurses, the existing standard non-monetary provisions in the central ONA/RN agreements will automatically apply to the nurses effective nine (9) months after the Employer receives notice to bargain from the Union or a Memorandum of Agreement or Interest Arbitration Award is received, whichever is earlier. These provisions include: Article 1 Article 2.03 Articles 2.05, 2.07-2.12 Articles 3-8 Articles 9.01(d) only, 9.03-9.13, 9.15, 9.16, 9.17 Article 10
