Minimum Germination. The minimum germination rate of 90 percent for Canada Certified #1 will apply only for the Quality Loss factor.
Minimum Germination Sample Clauses
Related to Minimum Germination
Requiring Minimum Compensation for Covered Employees a. Contractor agrees to comply fully with and be bound by all of the provisions of the Minimum Compensation Ordinance (MCO), as set forth in San Francisco Administrative Code Chapter 12P (Chapter 12P), including the remedies provided, and implementing guidelines and rules. The provisions of Sections 12P.5 and 12P.5.1 of Chapter 12P are incorporated herein by reference and made a part of this Agreement as though fully set forth. The text of the MCO is available on the web at xxx.xxxxx.xxx/xxxx/xxx. A partial listing of some of Contractor's obligations under the MCO is set forth in this Section. Contractor is required to comply with all the provisions of the MCO, irrespective of the listing of obligations in this Section.
Minimum Balance Merchant agrees to maintain a minimum balance of funds in the Settlement Account as Bank may specify to Merchant in writing from time to time.
Minimum Call-Back Time An employee who is called in and required to work outside their regular working hours shall be paid for a minimum of two (2) hours at overtime rates unless the call-in is immediately prior to their normal work day, in which case there should be no minimum.
Minimum Call (a) Should an employee report for work on a regular scheduled basis and there is no work available, they shall be paid a minimum of four (4) hours’ pay at their regular rate.
Contribution Formula - Basic Life Coverage For employee basic life coverage and accidental death and dismemberment coverage, the Employer contributes one-hundred (100) percent of the cost.
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Formal Levels 14.3.1 Step 1.
Staffing Levels to deal with Potential Violence The Employer agrees that, where there is a risk of violence, an adequate level of trained employees should be present. The Employer recognizes that workloads can lead to fatigue and a diminished ability both to identify and to subsequently deal with potentially violent situations.
Minimum Balance Requirements To be a member and maintain Accounts with Us You must purchase 1 share in the Credit Union. The par value of a share in this Credit Union is $10.00. If the balance in Your primary savings Account drops below 1 share ($10.00), at any time, We may, at Our option, close Your Account. Nonsufficient Funds Returns. Any check or pre-authorized transfer, or transaction made through the use of a debit card, or other electronic means, as is applicable (including any in-person transaction), that is presented to Us for payment on Your Account when Your Account lacks sufficient collected funds to pay any such item may, at Our option, be returned for nonsufficient funds or We may honor any such item and charge You a fee for doing so. Overdraft Balance Calculation. When processing transactions that debit or credit Your Account, We start each Business Day with Your final Account balance from the preceding Business Day. The final balance takes into Account all of the debit and credit transactions that were settled that Business Day pursuant to Our Funds Availability Policy, as well as any other debits or credits to Your Account that were finally settled that day, as described above in the "Deposit of Items" and "Collection and Processing of Items" sections of the Account Agreement. This starting balance at the beginning of a Business Day (the preceding Business Day's final balance) is sometimes referred to as Your "actual balance." As credits and debits to Your Account are received by Us, We add them to and subtract them from Your actual balance. Examples of credits include, but are not limited to, electronic direct deposits, check deposits that have been fully and finally collected, ACH credits that have settled that day, and cash deposits made to one of Our tellers. Examples of debits include, but are not limited to, checks drawn on Your Account that are presented to Us for payment together with such checks that are returned unpaid and subsequently represented for payment, electronic fund transfer (EFT) debit transactions (such as preauthorized payments and settled EFT debits) and all reinitiated electronic fund transfer (EFT) debit transactions (such as preauthorized payments), memo-posted EFT debits (EFT debits that We have authorized but which have not been settled), and all Credit Union fees and charges. As noted above, these examples are not an exhaustive list and should not be construed as such. The result of this calculation at any given point in time is called Your "available balance." For the purpose of determining whether an overdraft has occurred, We use Your available balance. First, We add all of the settled credit transactions to the beginning actual balance. Then, We subtract all of the debit transactions that settled that day. We also subtract all of the pending debit transactions. This determines the available balance for overdraft purposes. Each debit transaction that We process when Your Account has, or will have, a negative available balance is an overdraft, subject to an overdraft charge. Subject to applicable law, You are responsible for paying any overdraft fees and charges assessed in connection with Our payment of an overdraft, as well as any NSF fees charged to Your Account when We dishonor and return an item for non- sufficient funds. It is Your responsibility to know Your Account balance, and if You have any questions You should contact a Credit Union representative.
Transition Period LVRT Standard The transition period standard applies to wind generating plants subject to FERC Order 661 that have either: (i) interconnection agreements signed and filed with the Commission, filed with the Commission in unexecuted form, finally executed as conforming agreements, or filed with the Commission as non-conforming agreements between January 1, 2006 and December 31, 2006, with a scheduled in-service date no later than December 31, 2007, or (ii) wind generating turbines subject to a wind turbine procurement contract executed prior to December 31, 2005, for delivery through 2007.
