Mode Management Requirements. 2.1.2.1.1. CSW
1. Stand-by – all the ASW modules are in their respective Stand-by, Off or Safe modes (they need not to be in the same mode).
Mode Management Requirements Sample Clauses
Related to Mode Management Requirements
Agreement Requirements This agreement will be issued to cover the Janitorial Service requirements for all State Agencies and shall be accessible to any School District, Political Subdivision, or Volunteer Fire Company.
Equipment Requirements No Equipment is provided to Customer as part of this Service.
Project Requirements 1. Project must conform to regulations under 24 CFR Part 92, commonly known as the HOME Regulations.
Support Requirements If there is a dispute between the awarded vendor and TIPS Member, TIPS or its representatives may assist, at TIPS sole discretion, in conflict resolution or third party (mandatory mediation), if requested by either party. TIPS, or its representatives, reserves the right to inspect any project and audit the awarded vendors TIPS project files, documentation and correspondence. TIPS Members stand in the place of TIPS as related to this agreement and have the same access to the proposal information and all related documents. TIPS Members have all the same rights under the awarded Agreement as TIPS.
Payment Requirements A. Contract Amount: It is expressly agreed and understood that the total amount to be paid by County under this Contract shall not exceed the total County funding as set forth in Attachment B-Payment/Compensation to Subrecipient attached hereto and incorporated herein by reference. B. County will reclaim any unused balance of funds for reallocation to other County approved projects.
Operating Requirements Any operating and technical requirements that may be applicable due to Regional Transmission Organization, Independent System Operator, control area, or the Connecting Transmission Owner’s requirements, including those set forth in the Small Generator Interconnection Agreement. Operating Requirements shall include Applicable Reliability Standards.
Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.
Interface Requirements 2.4.5.1 The NID shall be equal to or better than all of the requirements for NIDs set forth in the applicable industry standard technical references.
License Requirements The Hotel’s alcoholic beverage license requires that the Hotel shall: (i) request proper identification (photo ID) of any person of questionable age and refuse alcoholic beverage service if the person is either under age or proper identification cannot be produced, and (ii) refuse alcoholic beverage service to any person who, in the Hotel’s judgment, appears to be intoxicated; and (iii) instruct its personnel to avoid encouraging patrons to consume alcoholic beverages (commonly referred to as “over-pouring”).
Check Requirements Any image of a check that I transmit to you must accurately and legibly provide all the information on the front and back of the check at the time presented to me by the drawer. Prior to capturing the original check, I will indorse the back of the original check. My endorsement will include "For Directions E- Deposit Only" in addition to my signature. The image of the check transmitted to you must accurately and legibly provide, among other things, the following information: (1) the information identifying the drawer and the paying bank that is preprinted on the check, including complete and accurate MICR information and the signature(s); and (2) other information placed on the check prior to the time an image of the check is captured, such as any required identification written on the front of the check and any endorsements applied to the back of the check. The image quality for the check will meet the standards for image quality established by the American National Standards Institute ("ANSI"), the Board of Governors of the Federal Reserve, and any other regulatory agency, clearing house or association. Rejection of Deposit. You are not liable for any service or late charges levied against me due to your rejection of any item. In all cases, I am responsible for any loss or overdraft plus any applicable fees to my Account due to an item being returned. Items Returned Unpaid. A written notice will be sent to me of transactions you are unable to process because of returned items. With respect to any item that I transmit to you for remote deposit that you credit to my Account, in the event such item is dishonored, I authorize you to debit the amount of such item from the Account.
