Warranty Limitation We do not warrant that the operation of Software will be uninterrupted or error free, or that Software will operate in hardware and Software combinations other than as expressly required by us in the Product specifications or that Software will meet your requirements.
Xxxxxx Limitation The Service reserves the right to refuse to pay any Xxxxxx to whom you may direct a payment. As required by applicable law, the Service will notify you promptly if it decides to refuse to pay a Xxxxxx designated by you. as set forth in Section 13 of the General Terms (Prohibited Payments) or an Exception Payment under this Agreement.
Warranty Limitations This Contractual Warranty does not warrant uninterrupted or error-free operation of the Product or cover normal wear and tear of the Product or costs related to the removal, installation, or troubleshooting of the customer's electrical systems. The warranty claims that relate to defects caused by any of the following factors are not covered by the Contractual Warranty: • Improper Use or Non-compliance with installation, commissioning, operation or maintenance instructions (i.e. not according to the operation & installation manual) • Unauthorized modifications, changes or attempted repairs, • Vandalism, destruction through external influence and/or persons/animals • Use in an unsuitable environment, including any environment or location that causes excessive wear and tear or dirt or dust or debris buildup within the system or that is difficult or unsafe for Xantrex LLC representatives to access • Insufficient ventilation • Installation in a corrosive environment • Failure to observe applicable safety standards & regulations • Damages during transportation or storage • Force majeure, examples include, but not limited to: fire, flood, earthquakes, storm damage, overvoltage & lightning strikes • Exposure to fire, water, snow, moisture, or liquid ingress (except for any such exposure to environmental conditions that your Product was specifically designed to withstand as indicated in the applicable specifications for your Product) • Used as a component part of a product expressly warranted by another manufacturer • If the original identification (trade-mark, serial number) markings have been defaced, altered, or removed • Consumable components of any type are not covered, including but not limited to fans, fuses and filters etc. • Cosmetic shortcoming which do not impair the use of the product for the intended purpose i.e. supply of energy Warranty claims also exclude: • Damages arising due to the fact that the use of the product for the intended purpose is no longer possible or only possible with restrictions as a result of amendments to the statutory provisions applicable to the operation of the product made after the delivery of the product • Compensation for damages related to loss of power production or business operation or any expenses incurred by customer towards repair & replacement of the product (including but not limited to labor, transportation, temporary power) • Cost arising from changes to existing PV systems or building installations or vehicle or marine vessel installation and like • Additional costs and expenses (i.e. shipping costs, travel, accommodation, meals, etc.) arising due to remote locations of the indicated geographies, including but not limited to islands and overseas territories
Specific Limitations No Member shall have the right or power to: (a) withdraw or reduce such Member’s Capital Contribution except as a result of the dissolution of the Company or as otherwise provided by law or in this Agreement; (b) make voluntary Capital Contributions or to contribute any property to the Company other than cash; (c) bring an action for partition against the Company or any Company assets; (d) cause the termination and dissolution of the Company, except as set forth in this Agreement; or (e) upon the Distribution of its Capital Contribution require that property other than cash be distributed in return for its Capital Contribution. Each Member hereby irrevocably waives any such rights.
Estimated Number of Participating Households Approximately 6,460. This figure is based on loans with unpaid principal balances ranging from $200,000 to $400,000 with an average funding of $5,000.00.
Liability Limitation Subsequent to the issuance of a Certificate of Completion pursuant to this Agreement, Applicant shall be entitled to the Liability Limitation set forth at ECL § 27-1421, subject to the terms and conditions stated therein and to the provisions of 6 NYCRR §§ 375-1.9 and 375-3.9.
Regulatory Limitation In the event, as a result of increases in the value of Alternative Currencies against the Dollar or for any other reason, the obligation of any of the Lenders to make Loans (taking into account the Dollar Amount of the Obligations and all other indebtedness required to be aggregated under 12 U.S.C.A. §84, as amended, the regulations promulgated thereunder and any other Applicable Law) is determined by such Lender to exceed its then applicable legal lending limit under 12 U.S.C.A. §84, as amended, and the regulations promulgated thereunder, or any other Applicable Law, the amount of additional Extensions of Credit such Lender shall be obligated to make or issue or participate in hereunder shall immediately be reduced to the maximum amount which such Lender may legally advance (as determined by such Lender), the obligation of each of the remaining Lenders hereunder shall be proportionately reduced, based on their applicable Commitment Percentages to the relevant Credit Facility and, to the extent necessary under such laws and regulations (as determined by each of the Lenders, with respect to the applicability of such laws and regulations to itself), and the Company shall reduce, or cause to be reduced, complying to the extent practicable with the remaining provisions hereof, the Obligations outstanding hereunder by an amount sufficient to comply with such maximum amounts.
Indemnity Limitation for TIPS Sales Texas and other jurisdictions restrict the ability of governmental entities to indemnify others. Vendor agrees that if any "Indemnity" provision which requires the TIPS Member to indemnify Vendor is included in any TIPS sales agreement/contract between Vendor and a TIPS Member, that clause must either be stricken or qualified by including that such indemnity is only permitted, "to the extent permitted by the laws and constitution of [TIPS Member's State]” unless the TIPS Member expressly agrees otherwise. Any TIPS Sale Supplemental Agreement containing an "Indemnity" clause that conflicts with these terms is rendered void and unenforceable.
Review Process Limitations The Asset Representations Reviewer will have no obligation (i) to determine whether a Delinquency Trigger Event has occurred or whether the required percentage of Noteholders has voted to direct an Asset Representations Review under the Indenture, (ii) to determine which Receivables are subject to an Asset Representations Review, (iii) to obtain or confirm the validity of the Review Materials, (iv) to obtain missing or insufficient Review Materials except as specifically described herein, (v) to take any action or cause any other party to take any action under any of the Transaction Documents to enforce any remedies for breaches of representations or warranties about the Eligible Representations, (vi) to determine the reason for the delinquency of any Review Receivable, the creditworthiness of any Obligor, the overall quality of any Review Receivable or the compliance by the Servicer with its covenants with respect to the servicing of such Review Receivable, or (vii) to establish cause, materiality or recourse for any failed Test as described in Section 3.03.
Minimum Balance Xxxxxxxx agrees to maintain a minimum balance of funds in the Settlement Account as Processor may specify to Merchant in writing from time to time.
