Building Maintenance The host facility provider shall maintain (in a state of good repair) all buildings used for the educational program. All damages made by the AGENCY’s program will be the responsibility of the AGENCY to repair.
Maintenance of Premises LESSOR will be responsible for all structural and roof maintenance of the leased premises but specifically excluding damage caused by the careless, malicious, willful, or negligent acts of LESSEE or others, chemical, water or corrosion damage from any source, and maintenance of the space heating, ventilating, and cooling units exclusively serving the leased premises (collectively, the "HVAC Unit") and of any non "building standard" leasehold improvements. LESSOR shall not be deemed to have breached its obligation to make the repairs required to be made by LESSOR unless LESSOR fails to make the same within a reasonable period (taking into consideration the type of repair involved) after receiving written notice from LESSEE of the need therefor. LESSEE agrees to maintain at its expense the HVAC Unit and all other aspects of the leased premises in the same condition as they are at the commencement of the term or as they may be put in during the term of this lease, normal wear and tear and damage by fire or other casualty only excepted, and whenever necessary, to replace light bulbs, plate glass and other glass therein, acknowledging that the leased premises are now in good order and the light bulbs and glass whole. If LESSOR so directs, LESSEE shall enter into a preventive maintenance/service contract acceptable to LESSOR with a maintenance contractor acceptable to LESSOR at LESSEE's sole cost and expense for servicing all air conditioning, heating, ventilating, and other equipment or other equipment located within or serving the leased premises. LESSEE will properly control or vent all solvents, degreasers, smoke, odors, etc. and shall not cause the area surrounding the leased premises to be in anything other than a neat and clean condition, depositing all waste in appropriate receptacles. LESSEE shall be solely responsible for any damage to plumbing equipment, sanitary lines, or any other portion of the building which results from the discharge or use of any acid or corrosive substance by LESSEE. LESSEE shall not permit the leased premises to be overloaded, damaged, stripped or defaced, nor suffer any waste, and will not keep animals within the leased premises. LESSEE will protect any carpet with plastic or masonite chair pads under any rolling chairs. Unless heat is provided at LESSOR's expense, LESSEE shall maintain sufficient heat to prevent freezing of pipes or other damage. Any increase in air conditioning equipment or electrical capacity, or any installation and/or maintenance of equipment which is necessitated by some specific aspect of LESSEE's use of the leased premises shall be at LESSEE's expense. All maintenance provided by LESSOR shall be during LESSOR's normal business hours.
MAINTENANCE OF CONCESSION PREMISES A. Concessionaire shall preserve and maintain the Concession Premises in good and clean condition, reasonable wear and tear excepted. Concessionaire is solely responsible for the maintenance and cleanliness of the Concession Premises.
Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.
Installation, Inspection, and Maintenance The Contractor is responsible for installation and maintenance of the BMPs as a part of its Bid. The Design Professional shall obtain the services of a qualified testing laboratory to inspect the BMPs in accordance with the permits, the costs of such inspections to be borne by the Owner. In the event of Abnormal Weather Conditions or force majeure, the Contractor shall be compensated for re-installation of BMPs at established Unit Prices.
MAINTENANCE OF THE BUILDING /APARTMENT / PROJECT The Promoter shall be responsible to provide and maintain essential services in the Project till the taking over of the maintenance of the project by the Association upon the issuance of the completion certificate of the Project. The cost of such maintenance has been included in the Total Extras and Deposits as mentioned in clause 1.2.
Construction and Maintenance There are on-going maintenance, renovation and construction projects taking place in and around the residences. The work typically takes place during regular business hours, but may begin earlier or extend into evenings or weekends. On-going construction or renovation projects will continue through midterm and final exam periods. The University will take measures to ensure that prudent construction practices are followed, but there may be noise, dust and temporary interruption of some services. Residents may be required to temporarily or permanently relocate to facilitate construction or renovation to their residence area. There will be no compensation or reduction to your residence fees due to disruption and/or relocation.
Maintenance of Improvements All improvements on the property, including, but not limited to, buildings, trees or other improvements now on the premises, or hereafter made or placed thereon, shall be a part of the security for the performance of this contract and shall not be removed therefrom. Purchaser shall not commit, or suffer any other person to commit, any waste or damage to said premises or the appurtenances and shall keep the premises and all improvements in as good condition as they are now.
Facility Maintenance Seller shall perform, or cause to be performed, all scheduled and unscheduled maintenance required on the Facilities in order to meet the Warranty Specifications and Performance Standards. In that regard, Seller’s responsibilities hereunder shall include, without limitation, promptly correcting any Bloom System or BOF malfunctions, either by (i) recalibrating or resetting the malfunctioning Bloom System or BOF, or (ii) subject to Section 5.7(b), repairing or replacing Bloom System or BOF components which are defective, damaged, worn or otherwise in need of repair or replacement.
Site Maintenance The authorized area shall be maintained in a neat, clean, and safe condition, free of any solid waste, debris, or litter, except as specifically authorized herein.
