RATED ORDERS Sample Clauses

RATED ORDERS. If a Defense Priority Allocation System (DPAS) rating appears on this Order, the Seller shall comply with all of the requirements of 15 CFR Part 700. Buyer has the following working days to accept/reject the Order: DO-rated 15 days, DX-rated 10 days. If the Order is to be rejected a response detailing the reasons for the rejection must be provided in writing physically (not electronic).
Sample 1
AutoNDA by SimpleDocs
RATED ORDERS. If an Order indicates that a DoD rating is in effect, then the Order supports Xxxxx’s work directly with or under a Prime Contract with the U.S. Government and Order is certified for national defense use. Applicable priority rating defaults to “DO,” unless otherwise stated on the face of the Order. This is a rated Order certified for national defense use. Seller is required to follow the requirements of the defense priorities and allocation system regulation (15 CFR Part 700) and all other applicable regulations for obtaining controlled Products and other Products and Services needed to fill the Order.
Sample 1Sample 2
RATED ORDERS. If a Defense Priority and Allocation System (DPAS) rating appears on this order, the Seller shall comply with all the requirements of 15 CFR Part 700. A person must accept or reject a rated order in writing within ten (10) working days after receipt of a DO rated order and five (5) working days after receipt of a DX rated order.
Sample 1Sample 2
RATED ORDERS. 12.1 Partner understands that Boeing may issue purchase orders in support of a Government program which may require expeditious treatment in accordance with the provisions of the Defense Priorities and Allocations Systems (DPAS) Regulation (15 CFR Part 700).
Sample 1
RATED ORDERS. If the Order contains a Defense Priorities and Allocations System (“DPAS”) rating, this Agreement is a “rated order” certified for national defense, emergency preparedness, and energy program use, and Seller shall follow all the requirements of the Defense Priorities and Allocation System Regulation (15 C.F.R. Part 700). In such case, Seller shall provide unqualified written acceptance or rejection to SemiDice’s authorized representative within 15 working days after receipt of a DO-rated order and within 10 working days after receipt of a DX-rated order. RATED ORDERS TAKE PRECEDENCE OVER ALL NON-RATED ORDERS AND ALL COMMERCIAL ORDERS YOU MAY HAVE.
Sample 1
RATED ORDERS. A rated order is a prime contract, a subcontract, or a purchase order in support of an approved program issued in accordance with the provisions of Defense Priorities Allocation System (DPAS), DFARS 252.211-15. DX - highest national defense urgency All DX rated orders have equal priority and take preference over DO and unrated orders (based on shipping schedule) DO – critical to national defense All DO rated orders have equal priority and take preference over unrated orders (based on shipping schedule) Acknowledgement is required. All Purchase Orders shall be acknowledged by the Seller within 10 calendar days after receipt.
Sample 1

Related to RATED ORDERS

  • Field Orders B. The documents listed in Paragraph 9.01.A are attached to this Agreement (except as expressly noted otherwise above).

  • Proceed Order The Proceed Order is a written notice from the Owner that includes a specified date (i.e. the Proceed Order Date) upon which the Contractor is authorized to commence physical work on the Site. Unless the Proceed Order states otherwise, the Proceed Order Date shall be the date upon which the Proceed Order is actually signed and dated by the Owner’s authorized representative. A Proceed Order is a condition precedent to the execution of any Work on the site by the Contractor. The Proceed Order was formerly referred to as the “Notice to Proceed.”

  • Field Order A written order issued by Engineer which requires minor changes in the Work but does not change the Construction Contract Price or the Construction Contract Times.

  • REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.

  • Medicaid-Funded Hours Worked Effective July 1, 2021, the Employer shall contribute the Retirement Rate or eighty cents ($0.80), whichever is higher, to the Retirement Trust for each Medicaid-Funded Hour worked by all home care workers covered by this Agreement with seven-hundred and one (701) or more cumulative career hours and fifty cents ($0.50) for each hour worked by all home care workers covered by this Agreement with less than seven-hundred one (701) cumulative career hours. Medicaid- Funded Hour(s) worked shall be defined as all hours worked by all employees covered by this Agreement in the Employer's in-home care program that are paid by Medicaid, excluding vacation hours, paid-time off hours, and training hours.

  • Relations Board Orders No more than one, final unappealable finding of contempt of court by a federal court has been issued against Contractor within the immediately preceding two-year period because of Contractor's failure to comply with an order of a federal court requiring Contractor to comply with an order of the National Labor Relations Board. Contractor swears under penalty of perjury that this representation is true.

  • INTEGRATED CONTRACT This Agreement represents the full and complete understanding of every kind or nature whatsoever between the parties hereto, and all preliminary negotiations and agreements of whatsoever kind or nature are merged herein. No verbal agreement or implied covenant shall be held to vary the provisions hereof. Any modification of this Agreement will be effective only by written execution signed by both City and Consultant.

  • Non-Medicaid-Funded Hours Worked Effective July 1, 2021, the Employer shall contribute the Healthcare Rate or three dollars and seventy-nine cents ($3.79), whichever is higher to the Trust for each Non-Medicaid- Funded hour worked. Non-Medicaid-Funded Hour(s) worked shall be defined as all hours worked by all employees covered by this Agreement in the Employer's in‐home care program that are paid by a payor other than Medicaid, excluding vacation hours, paid-time off, and training hours. Effective July 1 2022, the Employer shall contribute the Healthcare rate or three dollars and ninety-eight cents ($3.98), whichever is higher, to the Trust for each Non-Medicaid-Funded Hour worked. Contributions required by Section 21.2 shall be paid periodically as required by the Trust.

  • Integrated Digital Loop Carriers The feeder portion of some loops may be provide by means of Integrated Digital Loop Carrier (IDLC). IDLC provides a fiber optic cable transmission path that travels directly into BellSouth’s central office local switch. Where BellSouth uses IDLC ,if technically feasible and capacity does exist, BST will provide Al-Call with a Designed DS0 UVL by using alternative provisioning techniques including but not limited to such as “hairpinning” and DAC grooming. Alternative provisioning techniques will be provided at no additional cost to Al-Call . Hairpinning involves providing a DS0 signal from an IDLC-served loop to Al-Call ’s collocation equipment by using a dedicated pathway that traverses BellSouth’s central office switch. BellSouth will provide such DS0 signal to Al-Call by establishing a copper cross connect between the BellSouth switch and Al-Call ’s collocation equipment.

  • EODUF Packing Specifications 7.3.1 The data will be packed using ATIS EMI records. A pack will contain a minimum of one (1) message record or a maximum of ninety-nine thousand nine hundred and ninety-nine (99,999) message records plus a pack header record and a pack trailer record. One transmission can contain a maximum of ninety-nine (99) packs and a minimum of one (1) pack.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!