Reading of Meter Equipment Sample Clauses

Reading of Meter Equipment. We shall:
Sample 1Sample 2Sample 3See All (4)
AutoNDA by SimpleDocs
Reading of Meter Equipment. Xxxxxx Energy shall: (a) base a Customer’s Bill on a reading of the Meter Equipment at the Supply Address; and (b) ensure that a reading of the Meter Equipment at the Supply Address is obtained as frequently as required to meet its obligations under the Customer Service Code and, in any event, shall cause the Network Operator to read the Meter Equipment at least once in any 12 months. 8 ESTIMATED ACCOUNTS Where Xxxxxx Energy is unable to base a Bill on a reading of the Meter Equipment at the Supply Address because: (a) access is denied as a result of action required by the Customer, a third party, weather conditions, an industrial dispute or other reasons beyond Xxxxxx Energy’s control; (b) the Customer is vacating the Supply Address and requires a final Bill immediately; (c) access is denied for safety reasons;
Sample 1
Reading of Meter Equipment. Except where the Premises are subject to an unmetered tariff or a prepayment meter is installed and subject to the ability to use a customer reading and the inability to read under the Customer Services Code, Kleenheat shall:
Sample 1
Reading of Meter Equipment. Xxxxxx Energy shall:
Sample 1

Related to Reading of Meter Equipment

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • Metering The Interconnection Customer shall be responsible for the Connecting Transmission Owner’s reasonable and necessary cost for the purchase, installation, operation, maintenance, testing, repair, and replacement of metering and data acquisition equipment specified in Attachments 2 and 3 of this Agreement. The Interconnection Customer’s metering (and data acquisition, as required) equipment shall conform to applicable industry rules and Operating Requirements.

  • Reporting of Metered Data and Parameters 7.2.1 The grid connected Solar PV power plants will install necessary equipment for regular monitoring of solar irradiance (including GHI, DHI and solar radiation in the module plane), ambient air temperature, wind speed and other weather parameters and simultaneously for monitoring of the electric power (both DC and AC) generated from the Project.

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!