Recognition of Pest or Disease Free Areas and Areas of Low Pest Sample Clauses

Recognition of Pest or Disease Free Areas and Areas of Low Pest or Disease Prevalence 1. Each Party shall ensure that its sanitary or phytosanitary measures are adapted to the sanitary or phytosanitary characteristics of the areas of origin and destination of the good, whether the whole territory of a Party, part of the territory of a Party or all or parts of the territories of several Parties. 2. In evaluating the sanitary or phytosanitary characteristics of an area, the Parties shall take into account, inter alia, the level of prevalence of specific diseases or pests, the existence of eradication or control programs, and criteria or guidelines developed by competent international organizations agreed upon by the Parties. 3. The Parties shall recognize the concepts of pest or disease free areas and areas of low pest or disease prevalence. The determination of such areas shall be based on factors such as geographical location, ecosystems, epidemiological surveillance and the effectiveness of sanitary or phytosanitary controls. 4. The Party that declares an area of its territory free of a specific pest or disease shall demonstrate with scientific information to another Party such condition and provide assurance that it will be maintained as such, based on the protection measures adopted by the authorities responsible for sanitary and phytosanitary services. 5. The Party interested in obtaining the recognition of a pest or disease free area shall make the request and provide the corresponding scientific and technical information to another Party. 6. The Party receiving the request for recognition referred to in paragraph 5 shall decide within a period agreed with the requesting Party, and may carry out verifications in the territory of the latter for inspection, tests and other procedures. In case of non-acceptance, it shall indicate in writing the technical basis for its decision. 7. The Parties shall establish agreements on specific requirements, compliance with which will allow a good produced in an area of low pest or disease prevalence to be imported if it achieves the required level of protection.
AutoNDA by SimpleDocs

Related to Recognition of Pest or Disease Free Areas and Areas of Low Pest

  • Use of Basement and Service Areas The basement(s) and service areas, if any, as located within the

  • Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.

  • Union Activity on Premises and/or Access to Premises The Union agrees that neither it, nor its officers, agents, representatives and members will engage in the solicitation of members, holding of meetings or any other Union activities on Hospital premises or on Hospital time without the prior approval of the Hospital, except as specifically provided for in this Agreement. Such approval will not be unreasonably denied.

  • Use of Service Areas The service areas, as located within the Project, shall be ear- marked for purposes such as parking spaces and services including but not limited to electric sub-station, transformer, DG set rooms, underground water tanks, Pump rooms, maintenance and service rooms, firefighting pumps and equipment etc. and other permitted uses as per sanctioned plans. The Allottee shall not be permitted to use the services areas in any manner whatsoever, other than those earmarked as parking spaces and the same shall be reserved for use by the Association for rendering maintenance services.

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • Service Areas HHSC authorizes the MA Dual SNP to add the MA Product to Texas service areas that are not identified in Attachment C, Proposed MA Product Service Areas, provided it receives prior CMS approval and complies with the notice requirements specified in this Agreement.

  • Premises Parking and Common Areas 2.1 Letting Lessor hereby leases to Lessee, and Lessee hereby leases from Lessor, the Premises, for the term, at the rental, and upon all of the terms covenants and conditions set forth in this Lease. Unless otherwise provided herein, any statement of square footage set forth in this Lease, or that may have been used in calculating rental and/or Common Area Operating Expenses, is an approximation which Lessor and Lessee agree is reasonable and the rental and Lessee's Share (as defined in Paragraph 1.6(b)) based thereon is not subject to revision whether or not the actual square footage is more or less.

  • Access to Work Locations Reasonable access to employee work locations shall be granted officers of the Association and their officially designated representatives for the purpose of processing grievances or contacting members of the Association concerning business within the scope of representation. Such officers or representatives shall not enter any work location without the consent of the City Manager. Access shall be restricted so as not to interfere with the normal operations of the department or with established safety or security requirements. Solicitation of membership and activities concerned with the internal management of the Association, such as collecting dues, holding membership meetings, campaigning for office, conducting elections and distributing literature, shall not be conducted during working hours.

  • Parking Areas Landlord and Tenant agree that Landlord will not be responsible for any loss, theft or damage to vehicles, or the contents thereof, parked or left in the parking areas of the Premises and Tenant shall install at least one sign in the parking areas so advising its employees, visitors or invitees who may use such parking areas. Except as otherwise provided in this Section 3.5, parking areas shall be used for parking by vehicles no larger than full-size passenger automobiles or pick-up trucks, herein called "Permitted Size Vehicles." Vehicles other than Permitted Size Vehicles shall be parked and loaded or unloaded as directed by Landlord in the Rules and Regulations. Tenant shall not permit or allow any vehicles that belong to or are controlled by Tenant or Tenant's employees, suppliers, shippers, customers, contractors or invitees to be loaded, unloaded or parked in areas other than those designated by Landlord for such activities. Tenant agrees not to use or permit its employees, visitors or invitees to use the parking areas for overnight storage of vehicles, except for trucks on the Premises in the process of loading or unloading, and except for semi-tractors and trailers parked in the areas shown on the Site Plan as "Tenant's Designated Truck Parking". Tenant covenants and agrees that it shall not permit any of its employees, agents, contractors, vendors or shippers to park trucks, automobiles, trailers or other vehicles on any of the public streets in the general vicinity of the Premises or the industrial or business park in which the Premises are located. If Tenant permits or allows any of the prohibited activities described above for a period of five (5) business days after written notice from Landlord, then Landlord shall have the right, without further notice, in addition to such other rights and remedies that it may have, to remove or tow away the vehicle involved at Landlord's risk and expense. All responsibility for damage and theft to vehicles and their contents is assumed by the parties owning the same, including, respectively, Tenant or Tenant's partners, trustees, officers, directors, shareholders, members, invitees, or any of Tenant's assignees, subtenants or assignees' or subtenants' agents, employees, contractors, customers, suppliers, servants, guests, or independent contractors (collectively, "Tenant Parties"). Tenant shall repair or cause to be repaired, at Tenant's sole cost and expense, any and all damage, ordinary wear and tear excepted, to any portion of the Property caused by the use by Tenant Parties of the driveway or parking areas within the Property. Landlord shall not be liable to Tenant by reason of any moratorium, initiative, referendum, statute, regulation or other governmental action which could in any manner prevent or limit the parking rights of Tenant hereunder. Any governmental charges or surcharges or other monetary obligations imposed relative to Parking rights with respect to the Building shall be considered assessments and shall be Payable by Tenant as set forth in Paragraph 4.1; as of the Commencement Date, Landlord represents there are no such charges or surcharges imposed on the Premises.

  • GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!