Relationship of Cba to Laws Rules Policies
Relationship of Cba to Laws Rules Policies Sample Clauses
Related to Relationship of Cba to Laws Rules Policies
Rules and Procedures (a) The Benefit Society By-Laws will be amended to provide for a 6th Director with three Directors appointed by the Unions and three Directors appointed by the Corporation.
Provisions for Covered Entity to Inform Business Associate of Privacy Practices and Restrictions (a) Covered Entity shall notify Business Associate of any limitation(s) in the notice of privacy practices of Covered Entity under 45 CFR 164.520, to the extent that such limitation may affect Business Associate’s use or disclosure of protected health information.
Rules and Policies In addition to the terms and conditions contained herein, players acknowledge and agree that players shall be bound by and comply with all rules, regulations and policies established by SGM. SGM reserves the right in its sole and absolute discretion to amend, modify or cancel any of its rules, regulations and policies and/or adopt additional rules, regulations or policies. Any violation of the rules, regulations and policies by a member may result in the termination of the players contact, in SGM’s sole and absolute discretion.
Compliance with Laws and Rules You agree to comply with all state and federal laws, rules, and regulations applicable to you and to your use of the Services (the “Laws”), including the operating rules of all systems used to provide Services to you (the “Rules”), and to provide evidence reasonably satisfactory to us of the same if requested by us. You agree not to use the Service for any illegal purpose, including but not limited to illegal Internet gambling. Without limitation, you agree and acknowledge that the Services may not be used by you in violation of the laws of the United States, including sanction laws administered by the Office of Foreign Asset Controls. You acknowledge and agree that the software you use to access Services may be subject to restrictions and controls imposed by the Export Administration Act and the Export Administration Regulations. You agree and certify that neither the software nor any direct product thereof is being or will be used by you for any purpose prohibited by these Acts. Additionally, each Account and the Services will be subject to and governed by the following: • The terms or instructions appearing on a screen when using a Service; • Our Deposit Agreement, and our rules, procedures, and policies; • Applicable provisions of the rules of the National Automated Clearing House Association (NACHA) for bill payments facilitated through the ACH; • Applicable state and federal laws, rules, and regulations; and • The rules of other funds transfer systems when used in connection with a Service. Nothing in this Agreement relieves you of any obligation you may have under the Laws or the Rules, and this Agreement is deemed modified to the extent necessary to allow or require you to comply with the same. You will implement and maintain procedures, including retention of legal or compliance services, to ensure that you are able to comply with all current and future Laws and Rules, including any changes to them. We are not obligated to provide information, updates or notice of or regarding the Laws or the Rules, even if we are aware of the same and of the potential for material impact on you and your use of the Services, and your indemnification and other obligations to us are not relieved or reduced by our not providing the same to you. If we do provide information, updates or notices of or regarding the Laws or the Rules to you, we are not responsible for the accuracy of the same and may discontinue doing so at any time.
Compliance with Laws, Rules and Regulations Tenant, at its sole cost and expense, shall comply with all laws, ordinances, orders, rules and regulations of state, federal, municipal, or other agencies or bodies having jurisdiction over use, condition, and occupancy of the Leased Premises. Tenant must use and maintain the Leased Premises in a clean, careful, safe, and proper manner and in compliance with all Applicable Laws, including Applicable Laws pertaining to health, safety, disabled persons, and the environment; provided, however, that Tenant shall not be required to make any structural changes or repairs to the Leased Premises unless the need for such structural changes or repairs is caused by Tenant, its agents, employees, invitees, or others for whom Tenant is responsible pursuant to the terms and provisions of this Lease. Notwithstanding anything to the contrary contained elsewhere in this section, it is expressly agreed and understood that Tenant’s obligation to comply with all Applicable Laws does not apply to any violations of Applicable Laws that (a) were in effect and (b) were being violated or with which the Leased Premises was not in compliance immediately prior to the time Tenant accepted the Leased Premises, including without limitation any existing environmental contamination. Tenant will comply with the rules and regulations of the Leased Premises adopted by Landlord in its reasonable discretion. All such rules and regulations and changes and amendments thereto will be sent by Landlord to Tenant in writing and shall thereafter be carried out and observed by Tenant.
Policy and Procedures If the resident leaves the facility due to hospitalization or a therapeutic leave, the facility shall not be obligated to hold the resident’s bed available until his or her return, unless prior arrangements have been made for a bed hold pursuant to the facility’s “Bed Reservation Policy and Procedure” and pursuant to applicable law. In the absence of a bed hold, the resident is not guaranteed readmission unless the resident is eligible for Medicaid and requires the services provided by the facility. However, the resident may be placed in any appropriate bed in a semi-private room in the facility at the time of his or her return from hospitalization or therapeutic leave provided a bed is available and the resident’s admission is appropriate and meets the readmission requirements of the facility.
Compliance with Federal and State Work Authorization and Immigration Laws The Contractor and all subcontractors, suppliers and consultants must comply with all federal and state work authorization and immigration laws, and must certify compliance using the form set forth in Section 7 (“Georgia Security and Immigration Compliance Act Affidavits”). The required certificates must be filed with the Owner and copied maintained by the Contractor as of the beginning date of this contract and each subcontract, supplier contract, or consultant contract, and upon final payment to the subcontractor or consultant. State officials, including officials of the Georgia Department of Audits and Accounts, officials of the Owner, retain the right to inspect and audit the Project Site and employment records of the Contractor, subcontractors and consultants without notice during normal working hours until Final Completion, and as otherwise specified by law and by Rules and Regulations of the Georgia Department of Audits and Accounts.
Rules of Competition Concerning Undertakings 1. The following are incompatible with the proper functioning of this Agreement in so far as they may affect trade between the Parties:
CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.
Safeguarding requirements and procedures (1) The Contractor shall apply the following basic safeguarding requirements and procedures to protect covered contractor information systems. Requirements and procedures for basic safeguarding of covered contractor information systems shall include, at a minimum, the following security controls:
