Reliability Analysis Sample Clauses

Reliability Analysis. Consultant shall include a reliability discussion in the PDR. Typical reliability concerns include: failure concerns, preventative maintenance requirements, wear and life expectancy of components, repairs (frequency, costs, accessibility & ease), valves, time factors, surge protection, ventilation and temperature protection for electrical/control equipment, accessibility, rodent and insect protection, motors, controls, piping, accessibility, odors, and alternative
AutoNDA by SimpleDocs
Reliability Analysis. (CDRL 22g)
Reliability Analysis. Reliability analysis is an assessment of the degree of consistency between multiple measurements of a variable (Kastania & Xxxxxxx, 2011). The most commonly used measure of reliability is internal consistency (i.e., consistency among the variables in a summated scale). Reliabilty analysis was performed using the Cronbach's α reliability coefficient (Cronbach, 1951). The Cronbach’s α reliability coefficient measures the consistency among individual items in a single scale, i.e. how close related are a set of items as a group (Xxxxxx, 1998). For the questionnaires examined, it indicates how well the different items (questionnaire questions expecting a quantitative answer) complement each other in their measurement of different aspects of the same variable, i.e. reliability of service. As a rule of thumb, a value of 0.7 or higher is obtained on a substantial sample (Xxxxx, 1995). It is worth noting that the reliability coefficient depends on the number of users that completed the questionnaires in our case, and the number of questions which expect a quantitative answer (number of items). In Table 3.3.1, Cronbach α values range from 0.959 to 0.693. It is evident that the three tested Dicode Evaluation Framework questionnaires for each service show high internal consistency as indicated by high alpha coefficients, which exceed the recommended level of
Reliability Analysis. Upon Purchaser's request, Adaptec shall provide a time and materials estimate for the performance of reliability testing on Products supplied by

Related to Reliability Analysis

  • Quantitative Analysis Quantitative analysts develop and apply financial models designed to enable equity portfolio managers and fundamental analysts to screen potential and current investments, assess relative risk and enhance performance relative to benchmarks and peers. To the extent that such services are to be provided with respect to any Account which is a registered investment company, Categories 3, 4 and 5 above shall be treated as “investment advisory services” for purposes of Section 5(b) of the Agreement.”

  • Risk Analysis The Custodian will provide the Fund with a Risk Analysis with respect to Securities Depositories operating in the countries listed in Appendix B. If the Custodian is unable to provide a Risk Analysis with respect to a particular Securities Depository, it will notify the Fund. If a new Securities Depository commences operation in one of the Appendix B countries, the Custodian will provide the Fund with a Risk Analysis in a reasonably practicable time after such Securities Depository becomes operational. If a new country is added to Appendix B, the Custodian will provide the Fund with a Risk Analysis with respect to each Securities Depository in that country within a reasonably practicable time after the addition of the country to Appendix B.

  • Sampling and Analysis The Seller has sole responsibility for quality control of the coal and shall forward its “as loaded” quality to the Buyer as soon as possible. The sampling and analysis of the coal delivered hereunder shall be performed by Buyer and the results thereof shall be accepted and used for the quality and characteristics of the coal delivered under this Agreement. All analyses shall be made in Buyer’s laboratory at Buyer’s expense in accordance with ASTM standards where applicable, or using standards mutually acceptable to both parties. Samples for analyses shall be taken by any ASTM standards or standards mutually acceptable to both parties, and may be composited and shall be taken with a frequency and regularity sufficient to provide reasonably accurate representative samples of the deliveries made hereunder. Seller represents that it is familiar with Buyer’s sampling and analysis practices, and finds them to be acceptable. Buyer shall notify Seller in writing of any significant changes in Buyer’s sampling and analysis practices. Any such changes in Buyer’s sampling and analysis practices shall, except for ASTM or mutually agreeable changes in practices, provide for no less accuracy than the sampling and analysis practices existing at the time of the execution of this Agreement, unless the Parties otherwise mutually agree. (1) part shall be used for analysis by Buyer; one (l) part shall be used by Buyer as a check sample, if Buyer in its sole judgment determines it is necessary; one (1) part shall be retained by Buyer (LG&E) until the twenty-fifth (25th) of the month following the month of unloading (the “LG&E Disposal Date”) or Buyer (KU) until thirty (30) days after the sample is taken (the “KU Disposal Date”), the LG&E Disposal Date and the KU Disposal Date are collectively the “Disposal Date”), and shall be delivered to Seller for analysis if Seller so requests before the Disposal Date; and one part (“Referee Sample”) shall be retained by Buyer until the Disposal Date. Seller shall be given copies of all analyses made by Buyer by the tenth (10th) business day of the month following the month of unloading. Seller, on reasonable notice to Buyer shall have the right to have a representative present to observe the sampling and analyses performed by Buyer. Unless Seller requests a Referee Sample analysis before the Disposal Date, Buyer’s analysis shall be used to determine the quality of the coal delivered hereunder. The Monthly Weighted Averages shall be determined by utilizing the individual shipment analyses. If any dispute arises before the Disposal Date, the Referee Sample retained by Buyer shall be submitted for analysis to an independent commercial testing laboratory (“Independent Lab”) mutually chosen by Buyer and Seller. For each coal quality specification in question, a dispute shall be deemed not to exist and Buyer’s analysis shall prevail and the analysis of the Independent Lab shall be disregarded if the analysis of the Independent Lab differs from the analysis of Buyer by an amount equal to or less than: (i) 0.50% moisture (ii) 0.50% ash on a dry basis (iii) 100 Btu/lb. on a dry basis (iv) 0.10% sulfur on a dry basis. For each coal quality specification in question, if the analysis of the Independent Lab differs from the analysis of Buyer by an amount more than the amounts listed above, then the analysis of the Independent Lab shall prevail and Buyer’s analysis shall be disregarded. The cost of the analysis made by the Independent Lab shall be borne by Seller to the extent that Buyer’s analysis prevails and by Buyer to the extent that the analysis of the Independent Lab prevails.

  • Escrow Analysis If applicable, with respect to each Mortgage Loan, the Seller has within the last twelve months (unless such Mortgage was originated within such twelve month period) analyzed the required Escrow Payments for each Mortgage and adjusted the amount of such payments so that, assuming all required payments are timely made, any deficiency will be eliminated on or before the first anniversary of such analysis, or any overage will be refunded to the Mortgagor, in accordance with RESPA and any other applicable law;

  • Financial Viability and Regulatory Compliance 2.6.1 Contractor warrants and represents that its corporate entity is in good standing with all applicable federal, state, and local licensing authorities and that it possesses all requisite licenses to perform the services required by this contract. Contractor further warrants and represents that it owes no outstanding delinquent federal, state or local taxes or business assessments. 2.6.2 Contractor agrees to promptly disclose to the MPHA any IRS liens or licensure suspension or revocation that may adversely affect its capacity to perform the services outlined within this contract. The failure by Contractor to disclose such issue to the MPHA in writing within 5 days of such notification received will constitute a material breach of this contract. 2.6.3 Contractor further agrees to promptly disclose to the MPHA any change of more than 50% of its ownership and/or any declaration of bankruptcy that Contractor may undergo during the term(s) of this contract. The failure of Contractor to disclose any change of more than 50% of its ownership and/or its declaration of bankruptcy within 5 days of said actions shall constitute a material breach of this contract. 2.6.4 All disclosures made pursuant to this section of the contract shall be made in writing and submitted to MPHA within the time periods required herein.

  • Reliability Reliability targets (Mean Time Between Failures (MTBF)) are defined in the technical specifications as set out in the Contract. Notwithstanding any possible application of penalties relating to reliability defined in the Contract, Goods shall remain covered by the warranty defined in this Article 16 as long as the reliability commitments have not been reached.

  • Independent Analysis Each Party hereby confirms that its decision to execute this Agreement has been based upon its independent assessment of documents and information available to it, as it has deemed appropriate.

  • Research Analyst Independence The Company acknowledges that the Underwriters’ research analysts and research departments are required to be independent from their respective investment banking divisions and are subject to certain regulations and internal policies, and that such Underwriters’ research analysts may hold views and make statements or investment recommendations and/or publish research reports with respect to the Company and/or the offering that differ from the views of their respective investment banking divisions. The Company hereby waives and releases, to the fullest extent permitted by law, any claims that the Company may have against the Underwriters with respect to any conflict of interest that may arise from the fact that the views expressed by their independent research analysts and research departments may be different from or inconsistent with the views or advice communicated to the Company by such Underwriters’ investment banking divisions. The Company acknowledges that each of the Underwriters is a full service securities firm and as such from time to time, subject to applicable securities laws, may effect transactions for its own account or the account of its customers and hold long or short positions in debt or equity securities of the companies that may be the subject of the transactions contemplated by this Agreement.

  • Investment Analysis and Implementation In carrying out its obligations under Section 1 hereof, the Advisor shall: (a) supervise all aspects of the operations of the Funds; (b) obtain and evaluate pertinent information about significant developments and economic, statistical and financial data, domestic, foreign or otherwise, whether affecting the economy generally or the Funds, and whether concerning the individual issuers whose securities are included in the assets of the Funds or the activities in which such issuers engage, or with respect to securities which the Advisor considers desirable for inclusion in the Funds' assets; (c) determine which issuers and securities shall be represented in the Funds' investment portfolios and regularly report thereon to the Board of Trustees; (d) formulate and implement continuing programs for the purchases and sales of the securities of such issuers and regularly report thereon to the Board of Trustees; and (e) take, on behalf of the Trust and the Funds, all actions which appear to the Trust and the Funds necessary to carry into effect such purchase and sale programs and supervisory functions as aforesaid, including but not limited to the placing of orders for the purchase and sale of securities for the Funds.

  • Investment Analysis and Commentary The Subadviser will provide quarterly performance analysis and market commentary (the “Investment Report”) during the term of this Agreement. The Investment Reports are due within 10 days after the end of each quarter. In addition, interim Investment Reports shall be issued at such times as may be mutually agreed upon by the Adviser and Subadviser; provided however, that any such interim Investment Report will be due within 10 days of the end of the month in which such agreement is reached between the Adviser and Subadviser. The subject of each Investment Report shall be mutually agreed upon. The Adviser is freely able to publicly distribute the Investment Report.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!