Posting and Filling of Vacancies 8.1(1) When a permanent vacancy occurs within a classification covered by this agreement, which the Employer intends to fill, after the Employer applies the internal job transfer bidding procedure and the ultimate vacancy is thereby identified, such vacancy shall be advertised for ten (10) calendar days provided that nothing herein shall prevent the Employer from advertising such vacancy throughout its system or outside during the ten (10) day period. Probationary employees may, at the sole discretion of the Employer, be considered for another position outside their classification after the signing date of this agreement. The Company reserves the sole and absolute right to carry out any applicable interviewing or testing that is necessary in its opinion. All test processes will be approved by qualified Human Resources staff. An employee will only be allowed to take one test failure for each different job classification bid every four (4) months. Current employees applying for positions which involve increased driving responsibilities must meet corporate driving standards and provide with application a current driving abstract. The opinion of the Employer shall not be exercised in an arbitrary or discriminatory manner. 8.1(2) Internal Job Transfer Bidding Procedure 8.1(3) This internal job transfer bidding procedure is within a given classification as follows: 8.1(4) All employees within each classification, when requested, must submit a “standing application” to transfer to any existing alternate home base or location, shift, shift hours, days off (in order of preference), to transfer from part-time to full-time status, or to indicate that they wish no change, whichever is applicable to each individual within their current classification. 8.1(5) A copy of such standing application submitted will be furnished to the employee. Since a standing application will remain valid indefinitely until it results in action or is replaced by the employee, it is the responsibility of the employee to ensure that a standing application always reflects the employee’s current preferences. 8.1(6) (i) When a permanent classification position vacancy is to be filled, all standing applications will immediately be reviewed with the intention of awarding transfers (including any “resultant” transfers) in order of classification seniority in the following sequence, where applicable: (a) transfer of a full-time employee from one home base or location to another or as referred to above; (b) transfer of an employee from part-time to full- time status; (c) transfer of part-time employees from one home base or location to another or as referred to above; and (d) transfer of full-time employees to part-time.
Filling of Vacancies The Employer will continue with the current practice regarding job postings. Notices of position vacancies which occur within the bargaining unit which cannot be filled by a qualified surplus employee shall be posted on the District’s website using the on-line application system. Upon written request, all job postings will be distributed to the concerned affiliate local union. The Employer shall not fill any vacancy with a substitute employee for longer than fifty (50) work days except that this fifty (50) work days, shall become sixty (60) work days for the months of May, June, July and August; provided however, this sixty (60) work day period shall not in any event extend beyond October 31 of any year. This section shall apply to all employees covered by this Agreement unless modified in the attached appendices. Section 5.3.1 In order to become eligible for consideration of a position vacancy, an employee shall submit a completed position application form to the district Human Resource Office within the designated open period. Section 5.3.2 Employees interviewed and not selected for a position in the bargaining classifications contained herein shall be notified of their non-selection prior to the selectee’s first day of work in the position for which they had applied. Section 5.3.3 The employee with the earliest seniority date who is fully qualified to perform the work involved and who has fulfilled the requirements as set forth in Section 5.3.1, shall fill the vacant position when ability and performance are substantially equal to those who sought the vacancy by complying with those same requirements. Where it can be clearly substantiated that either a junior employee who has applied or an employment applicant possesses a greater ability and prior work performance record, the Employer may then fill the position with such person in which case the Employer shall set forth to the person and the union in writing upon written request from a senior eligible applicant, the reasons why that senior person was not placed into the position vacancy. Such factors as poor attendance and poor work performance shall be considered by the Employer in administering this section. This section shall apply to all employees covered by this Agreement unless modified in the attached appendices. Section 5.3.3.1 When an incumbent employee is promoted or assumes a new position; the employee may be placed on trial for thirty (30) workdays until the employee proves themselves capable of handling the new position. Before the completion of the thirty (30) day period, either the employee or the administrator may determine that the assignment is not acceptable. If such determination is made, the employee shall return to the position held immediately prior to the assumption of the new position except as may be modified in attached appendices. Section 5.3.3.2 Should, in accordance with Section 5.3.3.1, an employee return or be returned to the position they previously held, the employee who is displaced will be placed back into their former position. If the former position was as a substitute, the displaced employee will be placed back as a substitute. Employees subject to such change in placement/assignment will be given at least ten (10) days’ notice prior to the effective date of the change. Section 5.3.4 When two (2) employees subject to this Agreement are moved as the result of one initial posted vacancy, subsequent vacancies which may occur, shall be filled at the discretion of the Employer; provided, however, all custodial lead positions shall be subject to the position application procedures set forth herein.
CUTTING AND PATCHING OF WORK 4.14.1 The Contractor shall be responsible for all cutting, fitting or patching that may be required to complete the Work or to make its several parts fit together properly. 4.14.2 The Contractor shall not damage or endanger any portion of the Work or the work of the State or any separate contractors by cutting, patching or otherwise altering any work, or by excavation. The Contractor shall not cut or otherwise alter the work of the State or any separate contractor except with the written consent of the State and of such separate contractor. The Contractor shall not unreasonably withhold from the State or any separate contractor his consent to cutting or otherwise altering the Work.
Ordering Process 6.4.1 CLEC, or CLEC's agent, shall act as the single point of contact for its End User Customers' service needs, including without limitation, sales, service design, order taking, Provisioning, change orders, training, maintenance, trouble reports, repair, post-sale servicing, Billing, collection and inquiry. CLEC's End User Customers contacting Qwest in error will be instructed to contact CLEC; and Qwest's End User Customers contacting CLEC in error will be instructed to contact Qwest. In responding to calls, neither Party shall make disparaging remarks about each other. To the extent the correct provider can be determined, misdirected calls received by either Party will be referred to the proper provider of local Exchange Service; however, nothing in this Agreement shall be deemed to prohibit Qwest or CLEC from discussing its products and services with CLEC's or Qwest's End User Customers who call the other Party seeking such information. 6.4.2 CLEC shall transmit to Qwest all information necessary for the ordering (Billing, Directory Listing and other information), installation, repair, maintenance and post-installation servicing according to Qwest's standard procedures, as described in the Qwest Product Catalog (PCAT) available on Qwest's public web site located at xxxx://xxx.xxxxx.xxx/wholesale/pcat. Information shall be provided using Qwest's designated Local Service Request (LSR) format which may include the LSR, End User Customer and resale forms. 6.4.3 Qwest will use the same performance standards and criteria for installation, Provisioning, maintenance, and repair of services provided to CLEC for resale under this Agreement as Qwest provides to itself, its Affiliates, its subsidiaries, other Resellers, and Qwest retail End User Customers. The installation, Provisioning, maintenance, and repair processes for CLEC's resale service requests are detailed in the Access to OSS Section of this Agreement, and are applicable whether CLEC's resale service requests are submitted via Operational Support System or by facsimile. 6.4.4 CLEC is responsible for providing to Qwest complete and accurate End User Customer Directory Listing information including initial and updated information for Directory Assistance Service, white pages directories, and E911/911 Emergency Services. The Ancillary Services Section of this Agreement contains complete terms and conditions for Directory Listings for Directory Assistance Services, white pages directories, and E911/911 Emergency Services. 6.4.5 If Qwest's retail End User Customer, or the End User Customer's New Service Provider orders the discontinuance of the End User Customer's existing Qwest service in anticipation of the End User Customer moving to a New Service Provider, Qwest will render its closing xxxx to the End User Customer, discontinuing Billing as of the date of the discontinuance of Qwest's service to the End User Customer. If the Current Service Provider, or if the End User Customer's New Service Provider orders the discontinuance of existing resold service from the Current Service Provider, Qwest will xxxx the Current Service Provider for service through the date the End User Customer receives resold service from the Current Service Provider. Qwest will notify CLEC by Operational Support System interface, facsimile, or by other agreed-upon processes when an End User Customer moves from the Current Service Provider to a New Service Provider. Qwest will not provide the Current Service Provider with the name of the New Service Provider selected by the End User Customer. 6.4.6 CLEC shall provide Qwest and Qwest shall provide CLEC with points of contact for order entry, problem resolution and repair of the resold services. These points of contact will be identified for both CLEC and Qwest in the event special attention is required on a service request. 6.4.7 Prior to placing orders on behalf of the End User Customer, CLEC shall be responsible for obtaining and having in its possession Proof of Authorization (POA), as set forth in the POA Section of this Agreement. 6.4.8 Due Date intervals for CLEC's resale service requests are established when service requests are received by Qwest through Operational Support Systems or by facsimile. Intervals provided to CLEC shall be equivalent to intervals provided by Qwest to itself, its Affiliates, its subsidiaries, other Resellers, and to Qwest's retail End User Customers.
Offering Process In connection with the Offering, each of the Co-Managers will: a. Familiarize itself to the extent it deems appropriate with the business, operations, financial condition and prospects of the Client, including the artwork to be beneficially owned by the Client and information relating to the acquisition of the artwork by Client and its affiliates; b. Review to its satisfaction the final offering circular filed with the United States Securities and Exchange Commission (“SEC”) pursuant to Rule 253(g) (the “Offering Circular”) and such other documents to be used by such Co-Manager (the “Offering Materials”) in connection with the offering of the Securities; and c. Review to its satisfaction the active and planned operational practices and procedures of the Client in the conduct of the Offering and assist the Client to meet certain applicable rules and regulations promulgated by, and guidance issued by, the SEC and Financial Industry Regulatory Authority, Inc. (“FINRA”). If each of the Co-Managers is satisfied with the results of its due diligence of Client, each Co-Manager Adviser will then be authorized to: a. Identify and contact possible high net-worth, ultra-high net-worth, and institutional investors, which might have an interest in receiving the Offering Materials and evaluating participation in the Offering; b. Engage in conversations with potential investors that express an interest in learning more about the Offering (and similar transactions) via the Masterworks Platform and were directed to the Co-Manager by the Masterworks Platform, which is controlled by an affiliate of the Client; c. Use the Offering Circular (and any other Offering Materials approved by the Client and such Co-Manager) for solicitation purposes, which the Client will distribute via the Masterworks Platform to each potential investor concurrently with or in advance of any oral communication by a registered representative with such potential investor; d. Attend meetings with Client and potential investors, and assist the Client in responding to due diligence requests from potential investors; e. Ensure to its satisfaction that Anti-Money Laundering (“AML”) procedures are implemented for all potential investors in the Offering; f. Ensure to its satisfaction that suitability assessments are conducted for all potential investors with which such Co-Manager has any communications; and g. Generally assist the Client in its sale of securities to those potential investors accepted by Client in the Offering.
Scheduling of Work Subcontractor shall provide Contractor with scheduling information and a proposed schedule for performance of the Subcontract Work consistent with the Progress Schedule and in a form acceptable to Contractor. Subcontractor shall comply with the Progress Schedule including, but not specifically limited to, commencement, duration, and sequencing of activities. Contractor shall reasonably cooperate with the Subcontractor in scheduling the Subcontract Work and shall attempt, as reasonably possible, to avoid conflicts or interference with the Subcontract Work.
Sealing and Marking of Bids The bidder shall seal the original and each copy of the bid in separate envelopes duly marking the envelopes “ORIGINAL” and “COPY”. The envelopes shall then be sealed in an outer separate envelope.
Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.
Innovative Scheduling Schedules which are inconsistent with the Collective Agreement provisions may be developed in order to improve quality of working life, support continuity of resident care, ensure adequate staffing resources, and support cost-efficiency. The parties agree that such innovative schedules may be determined locally by the Home and the Union subject to the following principles: (a) Such schedules shall be established by mutual agreement of the Home and the Union; (b) These schedules may pertain to full-time and/or part-time employees; (c) The introduction of such schedules and trial periods, if any, shall be determined by the local parties. Such schedules may be discontinued by either party with notice as determined through local negotiations; (d) Upon written agreement of the Home and the Union, the parties may agree to amend collective agreement provisions to accommodate any innovative unit schedules; (e) It is understood and agreed that these arrangements are based on individual circumstances and each agreement is made on a without prejudice or precedent basis. (f) It is understood and agreed that these arrangements can be utilized for temporary job postings for seasonal coverage (e.g. weekend workers, etc.).
Vendor Encouraging Members to bypass TIPS agreement Encouraging entities to purchase directly from the Vendor or through another agreement, when the Member has requested using the TIPS cooperative Agreement or price, and thereby bypassing the TIPS Agreement is a violation of the terms and conditions of this Agreement and will result in removal of the Vendor from the TIPS Program.