Secondary School Program Sample Clauses

Secondary School Program. The Middle School Program outlined below will also apply to the High School. a. Secondary school teachers shall not be required to teach more than two subjects nor more than three preparations at any one time on a continuing basis; provided, however, that for specific courses and for specific durations set forth in writing and signed by the (Co-) President(s) of the Association and the Superintendent or his/her assigned designee, the Association will agree to alter the limitations of this provision, when considered appropriate by agreement. (Note, a subject is interpreted as meaning a separate discipline such as the discipline of mathematics, science, social studies, business education, physical education, etc., respectively. A preparation is interpreted as meaning a particular level within a discipline such as Algebra I, Trigonometry, General Mathematics. etc., respectively. ) Further, the parties agree with the following: (1) Algebra l and Algebra I Part 1 are separate teaching preparations. (2) Collaborative or inclusion classes do not require separate teaching preparations.
Sample 1Sample 2
AutoNDA by SimpleDocs

Related to Secondary School Program

  • Secondary Schools In the middle and high schools, areas of certification shall be deemed to 21 be the areas for which the employee holds certification. No teacher assignment that would result 22 in a violation of state or federal law will be approved.

  • Secondary Systems The Developer and Connecting Transmission Owner shall each cooperate with the other in the inspection, maintenance, and testing of control or power circuits that operate below 600 volts, AC or DC, including, but not limited to, any hardware, control or protective devices, cables, conductors, electric raceways, secondary equipment panels, transducers, batteries, chargers, and voltage and current transformers that directly affect the operation of Developer or Connecting Transmission Owner’s facilities and equipment which may reasonably be expected to impact the other Party. The Developer and Connecting Transmission Owner shall each provide advance notice to the other Party, and to NYISO, before undertaking any work on such circuits, especially on electrical circuits involving circuit breaker trip and close contacts, current transformers, or potential transformers.

  • Quality Assurance Program An employee shall be entitled to leave of absence without loss of earnings from her or his regularly scheduled working hours for the purpose of writing examinations required by the College of Nurses of Ontario arising out of the Quality Assurance Program.

  • Pilot Programs The Employer may develop voluntary pilot programs to test the acceptability of various risk management programs. Incentives for participation in such programs may include limited short-term improvements to the benefits outlined in this Article. Implementation of such pilot programs is subject to the review and approval of the Joint Labor-Management Committee on Health Plans.

  • Program 3.01. The Borrower declares its commitment to the Program and its implementation. To this end, and further to Section 5.08 of the General Conditions: (a) the Borrower and the Bank shall from time to time, at the request of either party, exchange views on the Borrower’s macroeconomic policy framework and the progress achieved in carrying out the Program; (b) prior to each such exchange of views, the Borrower shall furnish to the Bank for its review and comment a report on the progress achieved in carrying out the Program, in such detail as the Bank shall reasonably request; and (c) without limitation upon the provisions of paragraphs (a) and (b) of this Section, the Borrower shall promptly inform the Bank of any situation that would have the effect of materially reversing the objectives of the Program or any action taken under the Program including any action specified in Section I of Schedule 1 to this Agreement.

  • Technology Research Analyst Job# 1810 General Characteristics

  • Training Program It is agreed that there shall be an Apprenticeship Training Program, the provisions of which are set forth in Exhibit "D", which is attached hereto and forms part of this Agreement.

  • Quality Control Program Engineer shall have a quality control program in place that ensures that all deliverable work is of high quality. Engineer shall submit a plan detailing its program to the Inspection Branch of the TxDOT Bridge Division for review and approval prior to beginning work. State may review or audit the programs.

  • Marketing Plans Contractor and the Exchange recognize that Enrollees and other health care consumers benefit from efforts relating to outreach activities designed to increase heath awareness and encourage enrollment. The parties shall share marketing plans on an annual basis and with respect to periodic updates of material changes. The marketing plans of each of the Exchange and Contractor shall include proposed marketing approaches and channels and shall provide samples of any planned marketing materials and related collateral as well as planned, and when completed, expenses for the marketing budget. The Contractor shall include this information for both the Exchange and the outside individual market. The Exchange shall treat all marketing information provided under this Section as confidential information and the obligation of the Exchange to maintain confidentiality of this information shall survive termination or expiration of this Agreement.

  • New Products You agree to comply with NASD Notice to Members 5-26 recommending best practices for reviewing new products.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!