Seismic Safety The Recipient agrees to comply with the Earthquake Hazards Reduction Act of 1977, as amended, 42 U.S.C. § 7701, et seq., and U.S. DOT regulations, “Seismic Safety,” 49 CFR Part 41, specifically, 49 C.F.R. § 41.
CONTRACT WORK HOURS AND SAFETY STANDARDS As per the Contract Work Hours and Safety Standards Act (40 U.S.C. 3701-3708), where applicable, all Customer Purchase Orders in excess of ,000 that involve the employment of mechanics or laborers must include a provision for compliance with 40 U.S.C. 3702 and 3704, as supplemented by Department of Labor regulations (29 CFR Part 5). Under 40 U.S.C. 3702 of the Act, each contractor must be required to compute the wages of every mechanic and laborer on the basis of a standard work week of 40 hours. Work in excess of the standard work week is permissible provided that the worker is compensated at a rate of not less than one and a half times the basic rate of pay for all hours worked in excess of 40 hours in the work week. The requirements of 40 U.S.C. 3704 are applicable to construction work and provide that no laborer or mechanic must be required to work in surroundings or under working conditions which are unsanitary, hazardous or dangerous. These requirements do not apply to the purchases of supplies or materials or articles ordinarily available on the open market, or contracts for transportation or transmission of intelligence.
Review and Procedure Limitations The Asset Representations Reviewer will have no obligation (i) to determine whether a Delinquency Trigger has occurred, (ii) to determine whether the required percentage of Noteholders has voted to direct a Review, (iii) to determine which Receivables are subject to a Review, (iv) to obtain or confirm the validity of the Review Materials, (v) to obtain missing or insufficient Review Materials (except to the extent set forth in Section 3.04), or (vi) to take any action or cause any other party to take any action under any of the Basic Documents to enforce any remedies for breaches of any Eligible Representations. The Asset Representations Reviewer will only be required to perform the Tests provided in Exhibit A and will have no obligation to perform additional testing procedures on any ARR Receivables or to consider any additional information provided by any party. The Asset Representations Reviewer will have no obligation to provide reporting or information in addition to that described in Section 3.07. However, the Asset Representations Reviewer may review and report on additional information that it determines in good faith to be material to its performance under this ARR Agreement and may re-perform a Review with respect to an ARR Receivable as contemplated by Section 3.09. The Issuing Entity expressly agrees that the Asset Representations Reviewer is not advising the Issuing Entity or any Noteholder or any investor or future investor concerning the suitability of the Notes or any investment strategy. The Issuing Entity expressly acknowledges and agrees that the Asset Representations Reviewer is not an expert in accounting, tax, regulatory, or legal matters, and that the Asset Representations Reviewer is not providing legal advice as to any matter.
Child Safety BCHS values children from all backgrounds and is committed to making our community a safe, nurturing and welcoming place for children to grow and develop. We are committed to making sure ALL children reach their individual potential.
Contract Work Hours and Safety Standards Act The following clauses apply to any Federal-aid construction contract in an amount in excess of $100,000 and subject to the overtime provisions of the Contract Work Hours and Safety Standards Act. These clauses shall be inserted in addition to the clauses required by 29 CFR 5.5(a) or 29 CFR 4.6. As used in this paragraph, the terms laborers and mechanics include watchmen and guards.
Human and Financial Resources to Implement Safeguards Requirements The Borrower shall make available necessary budgetary and human resources to fully implement the EMP and the RP.
Contractor Changes The Contractor shall notify DAS in writing no later than ten (10) Days from the effective date of any change in:
a. its certificate of incorporation or other organizational document;
b. more than a controlling interest in the ownership of the Contractor; or
c. the individual(s) in charge of the Performance. This change shall not relieve the Contractor of any responsibility for the accuracy and completeness of the Performance. DAS, after receiving written notice by the Contractor of any such change, may require such agreements, releases and other instruments evidencing, to DAS’s satisfaction, that any individuals retiring or otherwise separating from the Contractor have been compensated in full or that provision has been made for compensation in full, for all work performed under terms of the Contract. The Contractor shall deliver such documents to DAS in accordance with the terms of DAS’s written request. DAS may also require, and the Contractor shall deliver, a financial statement showing that solvency of the Contractor is maintained. The death of any Contractor Party, as applicable, shall not release the Contractor from the obligation to Perform under the Contract; the surviving Contractor Parties, as appropriate, must continue to Perform under the Contract until Performance is fully completed.
Technical Objections to Grievances It is the intent of both Parties of this Agreement that no grievance shall be defeated merely because of a technical error, other than time limitations in processing the grievance through the grievance procedure. To this end, an arbitration board shall have the power to allow all necessary amendments to the grievance and the power to waive formal procedural irregularities in the processing of a grievance, in order to determine the real matter in dispute and to render a decision according to equitable principles and the justice of the case.
Technical Specifications The Technical Specifications furnished on the CD are intended to establish the standards for quality, performance and technical requirements for all labor, workmanship, material, methods and equipment necessary to complete the Work. When specifications and drawings are provided or referenced by the County, these are to be considered part of the Scope of Work, and to be specifically documented in the Detailed Scope of Work. For convenience, the County supplied specifications, if any, and the Technical Specifications furnished on the CD.
Benchmarks for Measuring Accessibility For the purposes of this Agreement, the accessibility of online content and functionality will be measured according to the W3C’s Web Content Accessibility Guidelines (WCAG) 2.0 Level AA and the Web Accessibility Initiative Accessible Rich Internet Applications Suite (WAI-ARIA) 1.0 for web content, which are incorporated by reference.
