Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
Bullying A. Workplace bullying is repeated abusive behavior that is threatening, humiliating, or intimidating. It may be direct or indirect, whether verbal, physical, or otherwise, by one or more persons against another or others, at the place of work and/or in the course of employment.
B. All Agency employees are expected to refrain from workplace bullying and adhere to a standard of conduct that is respectful and courteous to others.
C. Where appropriate, the affected employee should speak to the alleged bully or bullies to object to the behavior. Each employee is responsible for reporting any incidents to their supervisor or any other management official.
D. Upon receipt of a report of workplace bullying, Management will initiate an inquiry, address any inappropriate conduct, assist the affected employee, and act to prevent any retaliation by the bully or bullies. Management will not retaliate against any employee for reporting workplace bullying.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
CUTTING AND PATCHING The Contractor shall be responsible for cutting, fitting or patching required to complete the Work or to make its parts fit together properly.
Bullying and Harassment Neither DFMC nor you will engage in behaviour that is, or may be reasonably considered to be, intimidating, bullying or harassing or commit any act or behaviour which is offensive or abusive in connection with this Contract. If you are in breach of this clause, DFMC may suspend the collection of your milk for a period of 5 days or until such time as DFMC determines (acting reasonably) that the behaviour has been rectified.
TRAINING AND RELATED MATTERS The parties recognise that in order to increase the efficiency and productivity of the company a significant commitment to structured training and skill development is required. Accordingly the parties commit themselves to:
a) The parties to this Agreement recognise the importance of the apprenticeship system to the construction industry. It is agreed that every employer party to this Agreement who employs five (5) or more tradespersons in any one classification shall undertake to employ at least one (1) apprentice or make arrangements to host an apprentice from an agreed group apprenticeship scheme. Where an employer does not currently have an apprentice as per this provision, reasonable time shall be allowed to enable the employer to comply with this clause. Further, the parties are committed to a strong ratio of apprentices in the industry. Apprenticeship levels on a specific project may be discussed at the Project Pre-Commencement Conference (refer Clause 16).
b) Providing employees with the opportunity to acquire additional skills within relevant career path structures through appropriate structured training based on nationally endorsed (i.e. Construction Training Australia endorsed) competency standards and curriculum;
c) Actively encouraging employees to seek formal recognition of their skills (i.e. recognition of prior learning); and
d) Using training providers accredited and acceptable to the parties. The CFMEU, MBAV and other employer associations are legitimately engaged in providing training to industry and it is hereby agreed that all parties will properly recognise and accept the validity of nationally accredited training as provided by the other parties.
e) The parties will consult on the development of training programs which are consistent with the following: • Training provided will be consistent with the company’s business requirements, relevant to the work of the employees, consistent with the skills development of each employee and with applicable national competency standards. • Training may be taken either on or off the job with all reasonable steps being taken to conduct training in normal working hours. • If an approved training activity is undertaken during ordinary working hours, the employee/s concerned shall not suffer any loss of pay. • Approved training activities undertaken outside of ordinary hours will be paid at single time or will, at the employee’s option, be taken as time off in lieu of payment. Provided that the scheduling of time off must be consistent with the needs of the business and be by agreement with the company. • Training costs of courses approved by the company will be met by the company. • The company will not be asked to meet the costs of training undertaken by employees which was not approved by the company. • Leave of absence granted pursuant to this clause shall count as service for all purposes of the award and this agreement. • Accredited members of the union will be allowed up to 5 days per year, without loss of pay, to attend trade union educational courses conducted or approved by the union. (see appendix H)
f) The parties to this Agreement recognise the importance of the role that Apprentices/Trainees fulfill within the industry and, more importantly, a role that they will fulfill as trades persons following the conclusion of the indentures. To this end the Victorian Building Industry Consultative Committee will investigate ways of enhancing employment prospects for Apprentice/Trainees. In addition it is agreed that, where appropriate, employers will use their best endeavours to employ Apprentices/Trainees in order to ensure appropriate trade persons levels for the future.
Training and Professional Development 11.1 The Employer will develop and maintain an employee training and development plan and provide such plan to the Union upon request. Staff training is intended to provide an opportunity for classified staff employees for training sponsored by the University Training and Development and the UW Medical Centers Organizational Development and Training. Education/Professional Leave is intended to facilitate employee access to continuing education opportunities. Training and educational/professional leave may be used for the purpose of improving job performance, maintaining and increasing proficiency, preparing staff for greater responsibility, or increasing promotional opportunities within the framework of staff positions available at the University.
11.2 Any release time for training for employees accepted for such classes shall be in accordance with the Executive Order (currently No. 52) governing this matter. In the event that two or more employees request the same training period and supervision must limit the number of persons who may participate at one time due to work requirements, the selection will be made on a mutually agreeable basis within the department.
11.3 The training program is a proper subject for discussion by either departmental or University-wide Joint Union/Management Committees.
11.4 If the Employer requires an employee to receive training, reimbursement will be provided in accordance with the University travel rules. Employee attendance at Employer required training, either during or outside working hours, will be considered time worked and compensated in accordance with the provisions of this Agreement.
11.5 Employee attendance at training not required by the Employer and not covered by Executive Order 52, either on approved leave from or outside of working hours, will be voluntary and not considered time worked.
Anti-Money Laundering and Identity Theft Prevention Related Duties Subject to the terms and conditions set forth herein, the Trust hereby delegates to the Transfer Agent the Delegated Anti-Money Laundering Duties and, where applicable, the Delegated Identity Theft Prevention Duties that are set forth in the Trust’s Anti-Money Laundering (“AML”) Program and Identity Theft Prevention Program (“IDTPP”) as described below. The Transfer Agent agrees to perform the Delegated Anti-Money Laundering Duties and the Delegated Identity Theft Prevention Duties, with respect to ownership of shares in the Fund for which the Transfer Agent maintains the applicable information subject to and in accordance with the terms and conditions of the Contract.
Training and Orientation (a) No employee shall be required to work on any job or operate any piece of equipment until he/she has received proper training and instruction.
(b) The Employer shall provide sufficient and adequate training and/or orientation to any employee working in a new or unfamiliar work area or position.
Anti-Money Laundering and Red Flag Identity Theft Prevention Programs The Trust acknowledges that it has had an opportunity to review, consider and comment upon the written procedures provided by USBFS describing various tools used by USBFS which are designed to promote the detection and reporting of potential money laundering activity and identity theft by monitoring certain aspects of shareholder activity as well as written procedures for verifying a customer’s identity (collectively, the “Procedures”). Further, the Trust and USBFS have each determined that the Procedures, as part of the Trust’s overall Anti-Money Laundering Program and Red Flag Identity Theft Prevention Program, are reasonably designed to: (i) prevent each Fund from being used for money laundering or the financing of terrorist activities; (ii) prevent identity theft; and (iii) achieve compliance with the applicable provisions of the Bank Secrecy Act, Fair and Accurate Credit Transactions Act of 2003 and the USA Patriot Act of 2001 and the implementing regulations thereunder. Based on this determination, the Trust hereby instructs and directs USBFS to implement the Procedures on the Trust’s behalf, as such may be amended or revised from time to time. It is contemplated that these Procedures will be amended from time to time by the parties as additional regulations are adopted and/or regulatory guidance is provided relating to the Trust’s anti-money laundering and identity theft responsibilities. USBFS agrees to provide to the Trust:
(a) Prompt written notification of any transaction or combination of transactions that USBFS believes, based on the Procedures, evidence money laundering or identity theft activities in connection with the Trust or any Fund shareholder;
(b) Prompt written notification of any customer(s) that USBFS reasonably believes, based upon the Procedures, to be engaged in money laundering or identity theft activities, provided that the Trust agrees not to communicate this information to the customer;
(c) Any reports received by USBFS from any government agency or applicable industry self-regulatory organization pertaining to USBFS’ Anti-Money Laundering Program or the Red Flag Identity Theft Prevention Program on behalf of the Trust;
(d) Prompt written notification of any action taken in response to anti-money laundering violations or identity theft activity as described in (a), (b) or (c) immediately above; and
(e) Certified annual and quarterly reports of its monitoring and customer identification activities pursuant to the Procedures on behalf of the Trust. The Trust hereby directs, and USBFS acknowledges, that USBFS shall (i) permit federal regulators access to such information and records maintained by USBFS and relating to USBFS’ implementation of the Procedures, on behalf of the Trust, as they may request, and (ii) permit such federal regulators to inspect USBFS’ implementation of the Procedures on behalf of the Trust.
