Measurements Units set out in SI (metric) are the governing units for the purposes of this Contract. Units set out in Imperial measurement in parentheses beside their SI (metric) equivalent are for reference only and in the event of a conflict between SI (metric) and Imperial measurement herein, SI (metric) shall prevail.
Interim Measures Notwithstanding any requirements for alternative dispute resolution procedures as set forth in Articles 18(B), any party to the Dispute may apply to a court for interim measures (i) prior to the constitution of the arbitral tribunal (and thereafter as necessary to enforce the arbitral tribunal’s rulings); or (ii) in the absence of the jurisdiction of the arbitral tribunal to rule on interim measures in a given jurisdiction. The Parties agree that seeking and obtaining such interim measures shall not waive the right to arbitration. The arbitrators (or in an emergency the presiding arbitrator acting alone in the event one or more of the other arbitrators is unable to be involved in a timely fashion) may grant interim measures including injunctions, attachments and conservation orders in appropriate circumstances, which measures may be immediately enforced by court order. Hearings on requests for interim measures may be held in person, by telephone, by video conference or by other means that permit the parties to the Dispute to present evidence and arguments.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
Safety Measures Awarded vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Awarded vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage.
Temperature Measurement Temperature will be measured by the nearest automatic Melbourne Bureau of Meteorology Monitoring Station for example (but not limited to): Melbourne, Moorabbin, Dunns Hill, Melbourne Airport, Frankston, and Point Xxxxxx. At the commencement of each project, the onsite management and employee representatives shall agree which is to be the applicable automatic weather monitoring station.
Classifications 32.1 The Classification levels for Employees engaged under this agreement shall be read in accordance with the Award unless specifically amended by the terms of this Agreement. Classification levels, relativities, pay rates and other details are contained in APPENDIX 1.
32.2 An Employee not already engaged as CW4 (marker/setter) shall be paid an all-purpose allowance of 5% of his/her applicable hourly rate when performing this work.
32.3 Where any Employee on any day performs two or more classes of work to which different rates of pay are applicable, the Employee shall be paid at the higher hourly rate for the day if the Employee is required to work at that class of work for two (2) hours or more, and if for less than two (2) hours during any one (1) day the Employee will be paid the higher rate for the time so worked.
32.4 Where an Employee is elected by Employees of the Employer as a HSR and agrees to undertake the required training to fulfil the role, the Employee will be classified as the higher of CW4, or the Employee's usual classification. In addition, a HSR is entitled to an all-purpose hourly allowance for the life of this agreement as per the table at Appendix 2 – Health and Safety Representatives Allowance.
(a) For clarity, an Employee is only entitled to one all-purpose hourly allowance pursuant to clauses 32.4 and 32.5.
Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers.
5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem.
5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.
Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.
Corrective Measures If the Participating Generator fails to meet or maintain the requirements set forth in this Agreement and/or the CAISO Tariff, the CAISO shall be permitted to take any of the measures, contained or referenced in the CAISO Tariff, which the CAISO deems to be necessary to correct the situation.
General Measures (a) Evidence of family violence may be required and can be in the form an agreed document issued by the Police Service, a Court, a registered health practitioner, a Family Violence Support Service, district nurse, maternal and child health nurse or Lawyer. A signed statutory declaration can also be offered as evidence.
(b) All personal information concerning family violence will be kept confidential in line with the Employer’s policies and relevant legislation. No information will be kept on an Employee’s personnel file without their express written permission.
(c) No adverse action will be taken against an Employee if their attendance or performance at work suffers as a result of experiencing family violence.
(d) The Employer will identify contact/s within the workplace who will be trained in family violence and associated privacy issues. The Employer will advertise the name of any Family Violence contacts within the workplace.
(e) An Employee experiencing family violence may raise the issue with their immediate supervisor, Family Violence contacts, union delegate or nominated Human Resources contact. The immediate supervisor may seek advice from Human Resources if the Employee chooses not to see the Human Resources or Family Violence contact.
(f) Where requested by an Employee, the Human Resources contact will liaise with the Employee’s manager on the Employee’s behalf, and will make a recommendation on the most appropriate form of support to provide in accordance with clause 64.5 and clause 64.6.
(g) The Employer will develop guidelines to supplement this clause and which details the appropriate action to be taken in the event that an Employee reports family violence.
