Taxonomy of COSIGN physical resources features Sample Clauses

Taxonomy of COSIGN physical resources features. ‌ The following technologies are conceived to build a flexible, scalable and cost efficient DCN architecture in COSIGN: SDM-based Fibres Multi-core fibre Multi-element fibre Others: e.g., Hollow Core Photonic Bandgap fibre Total inter reflection Mirror Outputs Inputs Vertical Couplers Optical Fast Switch (ns) Optical cross-point switch TOR with midboard optics QSFP+ SFP+ PCI Express Optical NIC Large scale optical switch DirectLIght beam-steering switch Optical ToR: AWG, AWGR, BV-WSS, Fibre Switch Figure 2 Devices to be employed in COSIGN DCN architecture • High Radix optically enabled Ethernet switches using mid-board optics to allow reduced cost, power consumption and increased front panel bandwidth density. • High spatial dimensioning and low latency optical fibre: the use of spatial division multiplexing fibres (e.g., multi-core fibre (MCF)) will reduce cabling complexity and allow dynamic build of logical networks on top of the installed physical infrastructure. In addition, improved end-to-end data latency can be achieved by replacing standard single mode fibres (SMFs) with hollow core photonic band-gap fibres (PBGFs). • Highly-scalable core switching nodes: A flattened software defined meshed network topology is preferred for interconnecting ToR switches based on large port count and low loss free space 3D-beam steering optical switches. In this way, cluster switches can be eliminated by reducing east-west communication delays to reduce physical reconfiguration requirements. Optical circuit switch will also support port and matrix partitioning (hardware virtualization) to assist SDN based virtualization and slice isolation. • Fast optical switch (OXS): fast optical switches with highly modular scalability will be investigated for optical packet and TDM switch in a synchronous intra-rack mesh network. This will double or quadruple the current scale. A novel modular scaling scheme is introduced. The PM MCF interface has never been implemented on optical switches before. It is likely that chip packaging costs will be reduced substantially by using this type of interface, as well as reducing the insertion loss significantly below those of the edge coupling modules. • Optical NIC: NIC communicates with server through PCI-E interface (read/write data from/to RAM and disk) and could send out the data through optical interface (e.g., SFP+ and QSFP+) in various way (e.g., TDM and Ethernet).
AutoNDA by SimpleDocs

Related to Taxonomy of COSIGN physical resources features

  • Training a. The employer, in consultation with the local, shall be responsible for developing and implementing an ongoing harassment and sexual harassment awareness program for all employees. Where a program currently exists and meets the criteria listed in this agreement, such a program shall be deemed to satisfy the provisions of this article. This awareness program shall initially be for all employees and shall be scheduled at least once annually for all new employees to attend.

  • Securities Law Information The Participant acknowledges that he or she is permitted to sell the Shares acquired under the Plan through the designated broker appointed by the Company, provided the sale of the Shares takes place outside of Canada through facilities of a stock exchange on which the Shares are listed (i.e., the NYSE).

  • Safety Where an employee is prevented from working at the employee’s particular function as a result of unsafe conditions caused by the inclement weather, the employee may be transferred to other work in the employee’s classification on site, until the unsafe conditions are rectified. Where such alternative is not available and until the unsafe conditions are rectified, the employee shall remain on site. The employee shall be paid for such time without reduction of the employees’ inclement weather entitlement.

  • Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.

  • HEALTH AND SAFETY C8.1 The Contractor shall promptly notify the Authority of any health and safety hazards which may arise in connection with the performance of the Contract. The Authority shall promptly notify the Contractor of any health and safety hazards which may exist or arise at the Authority’s Premises and which may affect the Contractor in the performance of the Contract.

  • Reporting Requirements The Company, during the period when the Prospectus is required to be delivered under the 1933 Act or the 1934 Act, will file all documents required to be filed with the Commission pursuant to the 1934 Act within the time periods required by the 1934 Act and the 1934 Act Regulations.

  • BACKGROUND 1.1. The “Work” is the research article, review article, letter, clinical trial study, report, article, or other copyright work, as identified in the Copyright Letter and further detailed in Schedule 1: Details of the Work (including such form of the copyright work submitted to Xxxxxxx Science for publication pursuant to clause 4, below), but excluding (except where context otherwise requires) any diagrams, figures or illustration specifically identified to Xxxxxxx Science pursuant to clause 3.2, below.

  • Exchange Control Information Exchange control reporting is required for cash transactions exceeding AUD10,000 and for international fund transfers. If an Australian bank is assisting with the transaction, the bank will file the report on your behalf.

  • Reports The Depositary shall make available for inspection by Owners at its Office any reports and communications, including any proxy solicitation material, received from the Company which are both (a) received by the Depositary as the holder of the Deposited Securities and (b) made generally available to the holders of those Deposited Securities by the Company. The Company shall furnish reports and communications, including any proxy soliciting material to which this Section applies, to the Depositary in English, to the extent those materials are required to be translated into English pursuant to any regulations of the Commission.

  • Access to Information Such Purchaser acknowledges that it has had the opportunity to review the Transaction Documents (including all exhibits and schedules thereto) and the SEC Reports and has been afforded, (i) the opportunity to ask such questions as it has deemed necessary of, and to receive answers from, representatives of the Company concerning the terms and conditions of the offering of the Securities and the merits and risks of investing in the Securities; (ii) access to information about the Company and its financial condition, results of operations, business, properties, management and prospects sufficient to enable it to evaluate its investment; and (iii) the opportunity to obtain such additional information that the Company possesses or can acquire without unreasonable effort or expense that is necessary to make an informed investment decision with respect to the investment. Such Purchaser acknowledges and agrees that neither the Placement Agent nor any Affiliate of the Placement Agent has provided such Purchaser with any information or advice with respect to the Securities nor is such information or advice necessary or desired. Neither the Placement Agent nor any Affiliate has made or makes any representation as to the Company or the quality of the Securities and the Placement Agent and any Affiliate may have acquired non-public information with respect to the Company which such Purchaser agrees need not be provided to it. In connection with the issuance of the Securities to such Purchaser, neither the Placement Agent nor any of its Affiliates has acted as a financial advisor or fiduciary to such Purchaser.

Time is Money Join Law Insider Premium to draft better contracts faster.