Test Set-up. Using the test set-up as shown in figure 1 (see also appendix 1, paragraph 1.4.3.5.) and the procedure below, the efficiency of converters can be tested by means of an ozonator. Figure 1 Schematic of NO2 converter efficiency device Annex 4 - Appendix 2
Test Set-up. 1. First test run shall start on Wednesday, April 21, 2004 at 13:00 and shall end on Friday, April 23, 2004 at 13:00.
Test Set-up. 1. First test run for the full Facility case shall start on a Wednesday at 13:00 and shall end on the first Friday thereafter at 13:00. Each of the one CT operation portion of the Test run shall start on a Saturday at 13:00 and end 4-hours later. In general the second 4-hour run would be on the following Saturday or a subsequent Saturday as soon as the HECO system can accommodate such portion of the Test.
Test Set-up. The Initial System will be used to perform this emissions test. The system will be set up with an emissions sample port at the Power Oxidizer system exit. Figure 1 presents the location sampling port for the emissions. The port will include a tube that will be inserted to the depth of the flow to ensure the sample will be extracted from the main system flow. The emissions will be sampled in one location and will not traverse the flow path as is the standard with exhaust flow measurement methods. Traversing in this location is not possible due to the pressure boundary.
