RECOGNITION 1. For the purposes of the fulfillment, in whole or in part, of its standards or criteria for the authorization, licensing or certification of services suppliers, and subject to the requirements of paragraph 3, a Party may recognize the education or experience obtained, requirements met, or licences or certifications granted in the other Party or a non-Party. Such recognition, which may be achieved through harmonization or otherwise, may be based upon an agreement or arrangement with the other Party or a non-Party concerned or may be accorded autonomously. 2. A Party that is a party to an agreement or arrangement of the type referred to in paragraph 1, whether existing or future, shall afford adequate opportunity for the other Party, if the other Party is interested, to negotiate its accession to such an agreement or arrangement or to negotiate comparable ones with it. Where a Party accords recognition autonomously, it shall afford adequate opportunity for the other Party to demonstrate that education, experience, licences or certifications obtained or requirements met in that other Party's territory should be recognized. 3. A Party shall not accord recognition in a manner which would constitute a means of discrimination between countries in the application of its standards or criteria for the authorization, licensing or certification of services suppliers, or a disguised restriction on trade in services. 4. Each Party should encourage the relevant bodies in its respective territory to conduct future negotiations for developing mutually acceptable standards and criteria for licensing, temporary licensing and certification of professional services suppliers.
Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.
Services FASC agrees to provide to the Adviser the services indicated in Exhibit A to this Agreement (the “Services”).
Modification This Agreement shall not be changed, modified, terminated, or discharged, in whole or in part, except by an instrument in writing signed by both parties hereto, or their respective successors or assignees.
Changes This Agreement may not be modified or amended except pursuant to an instrument in writing signed by the Company and the Investor.
Integration The Company shall not sell, offer for sale or solicit offers to buy or otherwise negotiate in respect of any security (as defined in Section 2 of the Securities Act) that would be integrated with the offer or sale of the Securities for purposes of the rules and regulations of any Trading Market such that it would require shareholder approval prior to the closing of such other transaction unless shareholder approval is obtained before the closing of such subsequent transaction.
Audit Notwithstanding any other audit requirement, H-GAC reserves the right to conduct or cause to be conducted an independent audit of any transaction under this Agreement, such audit may be performed by the H-GAC local government audit staff, a certified public accountant firm, or other auditors designated by H-GAC and will be conducted in accordance with applicable professional standards and practices. The Contractor understands and agrees that the Contractor shall be liable to the H-GAC for any findings that result in monetary obligations to H-GAC.
Subcontracting 6.1 The Grantee is responsible for the performance of its obligations under this Agreement, including in relation to any tasks undertaken by subcontractors.
Additional Services Registry Operator shall be entitled to provide the Registry Services described in clauses (a) and (b) of the first paragraph of Section 2.1 in the Specification 6 attached hereto (“Specification 6”) and such other Registry Services set forth on Exhibit A (collectively, the “Approved Services”). If Registry Operator desires to provide any Registry Service that is not an Approved Service or is a material modification to an Approved Service (each, an “Additional Service”), Registry Operator shall submit a request for approval of such Additional Service pursuant to the Registry Services Evaluation Policy at xxxx://xxx.xxxxx.xxx/en/registries/rsep/rsep.html, as such policy may be amended from time to time in accordance with the bylaws of ICANN (as amended from time to time, the “ICANN Bylaws”) applicable to Consensus Policies (the “RSEP”). Registry Operator may offer Additional Services only with the written approval of ICANN, and, upon any such approval, such Additional Services shall be deemed Registry Services under this Agreement. In its reasonable discretion, ICANN may require an amendment to this Agreement reflecting the provision of any Additional Service which is approved pursuant to the RSEP, which amendment shall be in a form reasonably acceptable to the parties.
Disclosure Except with respect to the material terms and conditions of the transactions contemplated by the Transaction Documents, the Company confirms that neither it nor any other Person acting on its behalf has provided any of the Purchasers or their agents or counsel with any information that it believes constitutes or might constitute material, non-public information which is not otherwise disclosed in the Prospectus Supplement. The Company understands and confirms that the Purchasers will rely on the foregoing representation in effecting transactions in securities of the Company. All of the disclosure furnished by or on behalf of the Company to the Purchasers regarding the Company and its Subsidiaries, their respective businesses and the transactions contemplated hereby, including the Disclosure Schedules to this Agreement, is true and correct and does not contain any untrue statement of a material fact or omit to state any material fact necessary in order to make the statements made therein, in the light of the circumstances under which they were made, not misleading. The press releases disseminated by the Company during the twelve months preceding the date of this Agreement taken as a whole do not contain any untrue statement of a material fact or omit to state a material fact required to be stated therein or necessary in order to make the statements therein, in the light of the circumstances under which they were made and when made, not misleading. The Company acknowledges and agrees that no Purchaser makes or has made any representations or warranties with respect to the transactions contemplated hereby other than those specifically set forth in Section 3.2 hereof.
