Limitation on Out-of-State Litigation - Texas Business and Commerce Code § 272 This is a requirement of the TIPS Contract and is non-negotiable. Texas Business and Commerce Code § 272 prohibits a construction contract, or an agreement collateral to or affecting the construction contract, from containing a provision making the contract or agreement, or any conflict arising under the contract or agreement, subject to another state’s law, litigation in the courts of another state, or arbitration in another state. If included in Texas construction contracts, such provisions are voidable by a party obligated by the contract or agreement to perform the work. By submission of this proposal, Vendor acknowledges this law and if Vendor enters into a construction contract with a Texas TIPS Member under this procurement, Vendor certifies compliance.
Country and Territory Names The country and territory names (including their IDN variants, where applicable) contained in the following internationally recognized lists shall be withheld from registration or allocated to Registry Operator at All Levels: the short form (in English) of all country and territory names contained on the ISO 3166-1 list, as updated from time to time, including the European Union, which is exceptionally reserved on the ISO 3166-1 list, and its scope extended in August 1999 to any application needing to represent the name European Union <xxxx://xxx.xxx.xxx/iso/support/country_codes/iso_3166_code_lists/iso-3166-1_decoding_table.htm>; the United Nations Group of Experts on Geographical Names, Technical Reference Manual for the Standardization of Geographical Names, Part III Names of Countries of the World; and the list of United Nations member states in 6 official United Nations languages prepared by the Working Group on Country Names of the United Nations Conference on the Standardization of Geographical Names; provided, that the reservation of specific country and territory names (including their IDN variants according to the registry operator IDN registration policy, where applicable) may be released to the extent that Registry Operator reaches agreement with the applicable government(s). Registry Operator must not activate such names in the DNS; provided, that Registry Operator may propose the release of these reservations, subject to review by ICANN’s Governmental Advisory Committee and approval by ICANN. Upon conclusion of Registry Operator’s designation as operator of the registry for the TLD, all such names that remain withheld from registration or allocated to Registry Operator shall be transferred as specified by ICANN. Registry Operator may self-allocate and renew such names without use of an ICANN accredited registrar, which will not be considered Transactions for purposes of Section 6.1 of the Agreement.
Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.
DEVELOPMENT OR ASSISTANCE IN DEVELOPMENT OF SPECIFICATIONS REQUIREMENTS/ STATEMENTS OF WORK
Recognition of the U.S. Special Resolution Regimes (a) In the event that any Underwriter that is a Covered Entity becomes subject to a proceeding under a U.S. Special Resolution Regime, the transfer from such Underwriter of this Agreement, and any interest and obligation in or under this Agreement, will be effective to the same extent as the transfer would be effective under the U.S. Special Resolution Regime if this Agreement, and any such interest and obligation, were governed by the laws of the United States or a state of the United States. (b) In the event that any Underwriter that is a Covered Entity or a BHC Act Affiliate of such Underwriter becomes subject to a proceeding under a U.S. Special Resolution Regime, Default Rights under this Agreement that may be exercised against such Underwriter are permitted to be exercised to no greater extent than such Default Rights could be exercised under the U.S. Special Resolution Regime if this Agreement were governed by the laws of the United States or a state of the United States.
Gold Open Access Articles May be shared according to the author-selected end-user license and should contain a CrossMark logo, the end user license, and a DOI link to the formal publication on ScienceDirect. Please refer to Elsevier's posting policy for further information.
Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When CCI or its authorized agent owns the splitter, Line Splitting requires the following: a non- designed analog loop from the serving wire center to the network interface device (NID) at the end user’s location; a collocation cross connection connecting the loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The loop and port cannot be a loop and port combination (i.e. UNE-P), but must be individual stand-alone network elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog loop from the serving wire center to the network interface device (NID) at the end user’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port. 3.8.2 An unloaded 2-wire copper loop must serve the end user. The meet point for the Voice CLEC and the Data LEC is the point of termination on the MDF for the Data LEC's cable and pairs. 3.8.3 The foregoing procedures are applicable to migration to Line Splitting Service from a UNE-P arrangement, BellSouth Retail Voice Service, BellSouth High Frequency Spectrum (CO Based) Line Sharing. 3.8.4 For other migration scenarios to line splitting, BellSouth will work cooperatively with CLECs to develop methods and procedures to develop a process whereby a Voice CLEC and a Data LEC may provide services over the same loop.
Effective Date and Term of Agreement This Agreement is effective and binding on the Company and Employee as of the date hereof; provided, however, that, subject to Section 2(d), the provisions of Sections 3 and 4 shall become operative only upon the Change in Control Date.
Recognition of U.S. Special Resolution Regimes (a) In the event a Covered Party becomes subject to a proceeding under a U.S. Special Resolution Regime, the transfer of this Agreement (and any interest and obligation in or under, and any property securing, this Agreement) from such Covered Party will be effective to the same extent as the transfer would be effective under the U.S. Special Resolution Regime if this Agreement (and any interest and obligation in or under, and any property securing, this Agreement) were governed by the laws of the United States of America or a State of the United States of America. (b) In the event that a Covered Party or any BHC Affiliate of such Covered Party becomes subject to a proceeding under a U.S. Special Resolution Regime, any Default Right under this Agreement that may be exercised against such Covered Party is permitted to be exercised to no greater extent than such Default Right could be exercised under the U.S. Special Resolution Regime if this Agreement were governed by the laws of the United States of America or a State of the United States of America.
Agreement Term and Termination This agreement will remain in effect until the expiration or termination of Customer’s Subscription, whichever is earliest. Customer may terminate this agreement at any time by contacting its Reseller. The expiration or termination of this agreement will only terminate Customer’s right to place new orders for additional Products under this agreement.