TEXT MESSAGING WHILE DRIVING In accordance with Executive Order (EO) 13513, “Federal Leadership on Reducing Text Messaging While Driving,” any and all text messaging by Federal employees is banned: a) while driving a Government owned vehicle (GOV) or driving a privately owned vehicle (POV) while on official Government business; or b) using any electronic equipment supplied by the Government when driving any vehicle at any time. All cooperators, their employees, volunteers, and contractors are encouraged to adopt and enforce policies that ban text messaging when driving company owned, leased or rented vehicles, POVs or GOVs when driving while on official Government business or when performing any work for or on behalf of the Government.
Reducing Text Messaging While Driving Pursuant to Executive Order 13513, 74 FR 51225 (Oct. 6, 2009), Recipient should encourage its employees, subrecipients, and contractors to adopt and enforce policies that ban text messaging while driving, and Recipient should establish workplace safety policies to decrease accidents caused by distracted drivers.
Message Screening 7.4.4.4.1 BellSouth shall set message screening parameters so as to accept valid messages from MRC local or tandem switching systems destined to any signaling point within BellSouth’s SS7 network where the MRC switching system has a valid signaling relationship. 7.4.4.4.2 BellSouth shall set message screening parameters so as to pass valid messages from MRC local or tandem switching systems destined to any signaling point or network accessed through BellSouth’s SS7 network where the MRC switching system has a valid signaling relationship. 7.4.4.4.3 BellSouth shall set message screening parameters so as to accept and pass/send valid messages destined to and from MRC from any signaling point or network interconnected through BellSouth’s SS7 network where the MRC SCP has a valid signaling relationship.
CFR 200 328. Failure to submit such required Performance Reports may cause a delay or suspension of funding. 30 ILCS 705/1 et seq.
Jacket The term “jacket” refers to a single enclosed outer covering containing communications wires, fibers, or other communications media. As used in this Agreement, the term “jacket” refers to the outermost sheath or jacket of a cable.
Shift Rotation Routine shift rotation is not an approach to staffing endorsed by the Employer. Except for emergency situations where it may be necessary to provide safe patient care, shift rotation will not be utilized without mutual consent. If such an occasion should ever occur, volunteers will be sought first. If no one volunteers, the Employer will rotate shifts on an inverse seniority basis until the staff vacancies are filled.
International Shopping Goods estimated to cost less than $100,000 equivalent per contract may be procured under contracts awarded on the basis of international shopping procedures in accordance with the provisions of paragraphs 3.5 and 3.6 of the Guidelines.
National Shopping Goods estimated to cost less than $50,000 equivalent per contract, may be procured under contracts awarded on the basis of national shopping procedures in accordance with the provisions of paragraphs 3.5 and 3.6 of the Guidelines.
Weight The percent of the Base Price subject to adjustment based on an index change.
Size The nominal maximum size of aggregate shall be as large as possible within the limits specified but in no case greater than one-fourth of the minimum thickness of the member, provided at the concrete can be placed without difficulty so as to surround all reinforcement thoroughly and fill the corners of the form work. For most works, 20mm aggregate shall be used and where there is no restriction to the flow of concrete into sections, 40mm size (MSA) shall be used. For any heavily reinforced concrete members, the nominal maximum size of aggregate shall usually be restricted to 5mm less than the minimum cover to the reinforcement or 5mm less than the minimum clear distance between the main bars. Coarse aggregate shall of all aggregate particles of size greater than 4.75mm. The aggregate shall conform to IS: 383- 1970 clause 3.1,3.2 and 3.2.1 (Table-I) The nominal maximum size of coarse aggregate to be used shall be as per drawing/as determined by Engineer-in-charge.