User-centred design focus group activities Sample Clauses

User-centred design focus group activities. The user-centred design activities will be conducted with participants from Italy and the UK with similar characteristics to the DOREMI target users, and a reference group of older adults with normal cognitive function. There will be a group of around 8 people with MCI and normal cognition in both Italy and the UK (approximately 16 people in total). These users will form the DOREMI reference group and will be retained for all DOREMI user-centred design activities. The procedure for DOREMI user centred design activities is as below: Aim: To establish the needs, motivations and limitations of DOREMI participants and to generate ideas for game concepts. The ideas generated in these focus groups will be analysed by the research teams at DMU, SI4LIFE and Imaginary and used to shortlist a series of existing games to present to the same users in a second round of focus groups. Aim: To present a selection of existing games (chosen with the ideas generated by focus groups series 1 in mind) and discuss design characteristics in focus groups. Aim: To present prototype DOREMI games and interface based on information from the Idea Generation and Design stage focus groups. Gather user-feedback from interaction with the game Usability feedback from the focus groups will be analysed qualitatively. The cycle shown in Figure 10 will recommence. Usability problems will be addressed with further consideration of design issues, which will be incorporated into the prototype and user tested again with the same participants. Data will be analysed and the iterative process will continue until the users and the research team are satisfied with the quality, accessibility and functionality of the game.
Sample 1
AutoNDA by SimpleDocs

Related to User-centred design focus group activities

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Information Systems Acquisition Development and Maintenance a. Client Data – Client Data will only be used by State Street for the purposes specified in this Agreement.

  • Technical Support Services 2.1 The technical support services (the "Services"): Party A agrees to provide to Party B the relevant services requested by Party B, which are specified in Exhibit 1 attached hereto ("Exhibit 1").

  • Synchronization, Commissioning and Commercial Operation 4.1.1 The Power Producer shall give at least fifteen (15) days written notice to the SLDC / ALDC / DISCOM as the case may be, of the date on which it intends to synchronize the Power Project to the Grid System. 4.1.2 Subject to Article 4.1.1, the Power Project may be synchronized by the Power Producer to the Grid System when it meets all the connection conditions prescribed in the Grid Code and otherwise meets all other Indian legal requirements for synchronization to the Grid System. 4.1.3 The synchronization equipment and all necessary arrangements / equipment including Remote Terminal Unit (RTU) for scheduling of power generated from the Project and transmission of data to the concerned authority as per applicable regulation shall be installed by the Power Producer at its generation facility of the Power Project at its own cost. The Power Producer shall synchronize its system with the Grid System only after the approval of GETCO / SLDC / ALDC and GEDA. 4.1.4 The Power Producer shall immediately after each synchronization / tripping of generator, inform the sub-station of the Grid System to which the Power Project is electrically connected in accordance with applicable Grid Code. 4.1.5 The Power Producer shall commission the Project within SCOD. 4.1.6 The Power Producer shall be required to obtain Developer and/ or Transfer Permission, Key Plan drawing etc, if required, from GEDA. In cases of conversion of land from Agricultural to Non-Agriculture, the commissioning shall be taken up by GEDA only upon submission of N.A. permission by the Power Producer. 4.1.7 The Power Producer shall be required to follow the Forecasting and Scheduling procedures as per the Regulations issued by Hon’ble GERC from time to time. It is to clarify that in terms of GERC (Forecasting, Scheduling, Deviation Settlement and Related Matters of Solar and Wind Generation Sources) Regulations, 2019 the procedures for Forecasting, Scheduling & Deviation Settlment are applicable to all solar generators having combined installed capacity above 1 MW connected to the State Grid / Substation including those connected via pooling stations.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • Specific Activities Please give detailed information about the specific activities of the Project promoter and the Partner(s), with budget allocations 7.1 The main tasks of [name of the Project Promoter], referred to as the ‘Project Promoter’, are summarized as follows: Name Project activities Project budget 1 .... [mention the budget allocated to Project Promoter for the respective activity] EUR.... Activity 2 .... EUR... 7.2 The main input/responsibilities of [name of the Project Partner(s)], referred to as Partner 1, 2, etc., are summarized as follows: Name Project activities Project budget Partner 1... [briefly present the project activity implemented by Partner]. Activity 1 .... [mention the budget allocated to Partner 1 for the respective activity] EUR.... Activity 2 .... EUR... Name Project activities Project budget

  • COVID-19 Vaccine Passports Pursuant to Texas Health and Safety Code, Section 161.0085(c), Contractor certifies that it does not require its customers to provide any documentation certifying the customer’s COVID-19 vaccination or post-transmission recovery on entry to, to gain access to, or to receive service from the Contractor’s business. Contractor acknowledges that such a vaccine or recovery requirement would make Contractor ineligible for a state-funded contract.

  • Project Management Plan 3.2.1 Developer is responsible for all quality assurance and quality control activities necessary to manage the Work, including the Utility Adjustment Work. Developer shall undertake all aspects of quality assurance and quality control for the Project and Work in accordance with the approved Project Management Plan, Good Industry Practice and applicable Law. 3.2.2 Developer shall develop the Project Management Plan and its component parts, plans and other documentation in accordance with the requirements set forth in Section 1.5.2.5

  • Research Support (a) Having regard to the resources reasonably available for such purposes, the Operator will cooperate with AHS to provide such participation by its Staff as may be reasonable in relation to the carrying out of research within the Province. (b) The Operator agrees to promptly notify AHS in the event that it undertakes or agrees to participate in any form of clinical trial, research project, instrument use, or similar activity which in any way relates to the Services provided under this Agreement. The Operator shall, upon request, provide AHS with written evidence of Client disclosure and consent to research.

  • Verizon Operations Support Systems Verizon systems for pre- ordering, ordering, provisioning, maintenance and repair, and billing.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!