Using Cyclone for Renesas Board Sample Clauses

Using Cyclone for Renesas Board. Power and Pin 8 (for 14-Pin connector), or Pin 1 (for 10-Pin connector) The target power supply is not needed. Pin 8 of the Cyclone for Renesas 14- pin debug connector provides the appropriate voltage for corresponding Renesas targets. Pin 1 of the Cyclone for Renesas 10-pin debug connector provides the appropriate voltage for corresponding Renesas targets. The Power Out xxxx of the Cyclone for Renesas connector is not needed. Figure 3-16 shows the connections. Figure 3-16: Via Cyclone for Renesas Board Power and Pin 8 of Cyclone for Renesas 14-Pin Debug Connector -or- Pin 1 of Cyclone for Renesas 10-Pin Debug Connector Jumpers 1, 2, and 3 are enabled as shown in Figure 3-16. Figure 3-17: Jumper Settings for Target Power Connection via Cyclone for Renesas Board Power and Pin 8 (14-pin connector) or Pin 1 (10-pin connector) of Cyclone for Renesas Debug Connector
AutoNDA by SimpleDocs

Related to Using Cyclone for Renesas Board

  • Determinations and Actions by the Board of Directors All actions, calculations and determinations (including all omissions with respect to the foregoing) which are done or made by the Board of Directors in good faith pursuant to this Agreement, shall not subject the Board of Directors to any liability to the holders of the Rights.

  • Purpose of the Committee In order to xxxxxx better relations between the parties, the purpose of the Committee shall be to discuss matters of mutual concern including matters pertaining to the improvement of quality health care and safe nursing practice. The Committee shall have the power to make recommendations to the Union and to the Employer.

  • Scope of the Committee The Committee shall not have the power to bind the Union or its members, or the Employer to any decision or conclusion reached in discussion. The Committee shall not have jurisdiction over any matter contained in this Collective Agreement, including its administration or renegotiation. The Committee shall not supersede the activities of any other committee of the Union or of the Employer.

  • International Olympic Committee; International Red Cross and Red Crescent Movement As instructed from time to time by ICANN, the names (including their IDN variants, where applicable) relating to the International Olympic Committee, International Red Cross and Red Crescent Movement listed at xxxx://xxx.xxxxx.xxx/en/resources/registries/reserved shall be withheld from registration or allocated to Registry Operator at the second level within the TLD. Additional International Olympic Committee, International Red Cross and Red Crescent Movement names (including their IDN variants) may be added to the list upon ten (10) calendar days notice from ICANN to Registry Operator. Such names may not be activated in the DNS, and may not be released for registration to any person or entity other than Registry Operator. Upon conclusion of Registry Operator’s designation as operator of the registry for the TLD, all such names withheld from registration or allocated to Registry Operator shall be transferred as specified by ICANN. Registry Operator may self-­‐allocate and renew such names without use of an ICANN accredited registrar, which will not be considered Transactions for purposes of Section 6.1 of the Agreement.

  • Nurse Representatives & Grievance Committee (a) The Hospital agrees to recognize Association representatives to be elected or appointed from amongst nurses in the bargaining unit for the purpose of dealing with Association business as provided in this Collective Agreement. The number of representatives and the areas which they represent are set out in the Appendix of Local Provisions.

  • Procedures of the Joint Committee 1. For the proper implementation of this Agreement, the Joint Committee shall meet at an appropriate level whenever necessary upon request but at least once a year. Either Party may request a meeting be held.

  • PROCEDURE FOR GRIEVANCES AFFECTING A GROUP OF EMPLOYEES The Union may elect to file a grievance on behalf of two or more employees. The facts and issues of the grievance must be the same.

  • – UNION COMMITTEES AND REPRESENTATIVES 6.01 The Employer will recognize the following:

  • Contract Negotiation Meetings 14.09 When operational requirements permit, the Employer will grant leave without pay to an employee for the purpose of attending contract negotiation meetings on behalf of the Alliance. Preparatory Contract Negotiation Meetings

  • Technical Advisory Committee (TAC The goal of this subtask is to create an advisory committee for this Agreement. The TAC should be composed of diverse professionals. The composition will vary depending on interest, availability, and need. TAC members will serve at the CAM’s discretion. The purpose of the TAC is to: • Provide guidance in project direction. The guidance may include scope and methodologies, timing, and coordination with other projects. The guidance may be based on: o Technical area expertise; o Knowledge of market applications; or o Linkages between the agreement work and other past, present, or future projects (both public and private sectors) that TAC members are aware of in a particular area. • Review products and provide recommendations for needed product adjustments, refinements, or enhancements. • Evaluate the tangible benefits of the project to the state of California, and provide recommendations as needed to enhance the benefits. • Provide recommendations regarding information dissemination, market pathways, or commercialization strategies relevant to the project products. The TAC may be composed of qualified professionals spanning the following types of disciplines: • Researchers knowledgeable about the project subject matter; • Members of trades that will apply the results of the project (e.g., designers, engineers, architects, contractors, and trade representatives); • Public interest market transformation implementers; • Product developers relevant to the project; • U.S. Department of Energy research managers, or experts from other federal or state agencies relevant to the project; • Public interest environmental groups; • Utility representatives; • Air district staff; and • Members of relevant technical society committees. The Recipient shall: • Prepare a List of Potential TAC Members that includes the names, companies, physical and electronic addresses, and phone numbers of potential members. The list will be discussed at the Kick-off meeting, and a schedule for recruiting members and holding the first TAC meeting will be developed. • Recruit TAC members. Ensure that each individual understands member obligations and the TAC meeting schedule developed in subtask 1.11. • Prepare a List of TAC Members once all TAC members have committed to serving on the TAC. • Submit Documentation of TAC Member Commitment (such as Letters of Acceptance) from each TAC member. Products: • List of Potential TAC Members • List of TAC Members • Documentation of TAC Member Commitment

Time is Money Join Law Insider Premium to draft better contracts faster.