Voltage and Reactive Control Procedures Sample Clauses

Voltage and Reactive Control Procedures. The Power Producer shall operate the Facility with automatic voltage regulation equipment in service at all times, except for outages of the regulator for maintenance or equipment failure. Such operation will normally involve a prescribed voltage limited to +/- 1% of schedule. The Power Producer, at the option of the Company, shall operate the Facility either (i) according to a predefined voltage schedule provided by the Company or (ii) according to a reactive power schedule as provided by the Company, consistent with the Facility's generation capability and the Company's electrical system. From time to time, the Company may request alternate schedules consistent with the Facility's generation capability and the Company's electrical system. The Power Producer shall notify the Transmission Operator prior to performing all voltage regulator maintenance. The Power Producer shall notify the Company of the outage with as much lead time as possible. The Power Producer shall minimize the duration of regulator equipment outages. The Power Producer shall notify the Transmission Operator at least 30 minutes prior to removing the voltage regulator from service, or returning the voltage regulator to service. The Power Producer may be requested by the Company to deviate from prescribed voltage or reactive power schedules if, in the Company's sole judgment, conditions warrant such changes including, without limitation, operating the Facility in the leading, lagging, or unity power factor mode, but within the capability of the machine. The Power Producer shall operate automatic voltage regulation to a tolerance of +/- 1% of scheduled voltage, except for regulator maintenance outages or equipment failures, or conditions prevailing on the system and/or the Power System which necessitate other voltage levels. The Power Producer shall provide manual voltage regulation to maintain the prescribed voltage schedule or reactive power schedule during voltage regulator equipment outages. Momentary voltage fluctuations shall be permitted, provided that they neither disturb service provided by the Company or the Power Producer on their respective systems nor hinder the Company from maintaining proper voltage conditions on their respective systems.
AutoNDA by SimpleDocs
Voltage and Reactive Control Procedures. 1. The Power Producer shall operate the Facility with automatic voltage regulation equipment in service at all times, except for outages of the regulator for maintenance or equipment failure. Such operation will normally involve a prescribed voltage limited to +/- 1% of schedule. The Power Producer, at the option of the Company, shall operate the Facility either (i) according to a predefined voltage schedule provided by the Company or (ii) according to a reactive power schedule as provided by the Company, consistent with the Facility's generation capability and the Company's electrical system. From time to time, the Company may request alternate schedules consistent with the Facility's generation capability and the Company's electrical system.
Voltage and Reactive Control Procedures. The NUG Operator shall operate the NUG facility with automatic voltage regulation equipment in service at all times, except for outages of the regulator for maintenance or equipment failure.

Related to Voltage and Reactive Control Procedures

  • Quality Control Procedures The Seller shall have an internal quality control program that verifies, on a regular basis, the existence and accuracy of the legal documents, credit documents, property appraisals, and underwriting decisions. The program shall include evaluating and monitoring the overall quality of the Seller's loan production and the servicing activities of the Seller. The program is to ensure that the Mortgage Loans are originated and serviced in accordance with Accepted Servicing Standards and the Underwriting Guidelines; guard against dishonest, fraudulent, or negligent acts; and guard against errors and omissions by officers, employees, or other authorized persons.

  • Referral Procedures For Local Unions now having a job referral system as contained in their Collective Bargaining Agreement, the Contractor agrees to utilize such system and it shall be used exclusively by such Contractor, except as it may be modified by this Article. Referrals shall not be affected by obligations of Union membership or the lack thereof. Where airport security clearance requirements apply to work to be performed, the Contractor shall inform the Union’s hiring hall dispatcher of those requirements when requesting workers. For those Local Unions having a Book system as part of their Collective Bargaining Agreement, such system will be honored in regards to lay-off of workers from covered projects. Section 2. In the event that Local Unions are unable to fill any request for employees within the time specified by the local CBAs the Contractor may employ applicants from any other available source. The Contractor shall inform the Union of the name and social security number of any applicants hired from other sources and shall refer the applicant to the Local Union for dispatch to the Covered Project prior to the commencement of work, and make trust fund contributions for every hour worked. Section 3. There shall be no discrimination against any employee or applicant for employment because of his/her membership or non-membership in the Union or based upon race, creed, color, sex, age or national origin, or any other legally protected class of such employee or applicant. Section 4. No employee covered by this PLA shall be required to join any Union as a condition of being employed on the Covered Project; provided, however, that an employee who is a member of the referring Union at the time of the referral shall maintain that membership while employed under the PLA. All employees shall, however, be required to comply with the union security provision of the applicable Collective Bargaining Agreement, for the period during which they are performing on-site work, except as modified by this PLA. The Contractor agrees to deduct union dues or representation fees, whichever is applicable, from the pay of any employee who executes a voluntary authorization for such deductions and to remit the dues to the Union or Council. Initiation fees shall be waived for those employees who are not members of any signatory Union when they begin work on this Covered Project. The dues obligations of such employees shall be confined to that portion of union membership dues directly related to representation of workers in collective bargaining, and in enforcement of the Unions’ collective bargaining agreements. Nothing in this Section is intended to eliminate or affect the right of any employee to join the Union or the right of any union to collect full dues from its member. Section 5. The Parties agree that where a Contractor is not party to a current Collective Bargaining Agreement with the Union having jurisdiction over the affected work, the Contractor may request by name, and the Local will honor, referral of up to a maximum of five (5) persons per each contractor (“core” employees), provided that the Contractor first demonstrate that those persons possess the following qualifications: (1) Any license required by state or federal law for the Project work to be performed; (2) Have worked a total of at least one thousand two hundred (1,200) hours in the construction craft during the prior two (2) years; (3) Were on the Contractor’s active payroll for at least sixty (60) out of the ninety (90) calendar days prior to the contract award; (4) Have the ability to perform the work safely. The Contractor may elect to hire its first “core” employee to be a xxxxxxx. After the Contractor hires his first core employee, the Union will refer to such Contractor one journeyman employee from the hiring hall out-of-work list for the affected trade or craft, then refer one of such Contractor’s “core” employees as a journeyman, and shall alternate one core employee and one employee from the out-of-work list, until such Contractor’s crew requirements are met or until such Contractor has hired five (5) “core” employees, whichever occurs first. Thereafter, all additional employees in the affected trade or craft shall be hired exclusively from the hiring hall out-of-work list(s). For the duration of the Contractor’s work the ratio of “core” employees to hiring hall referrals shall be maintained and when the Contractor’s workforce is reduced, employees shall be reduced in the same ratio as was applied in the initial hiring. All employees, core and union, shall be dispatched from the appropriate union. Trust benefits shall be paid on all employees, core and union. Section 6. Upon referral or dispatch from a Union, “turnaround” or refusal of any worker by the Contractors, requires written explanation from the Contractor that shall be communicated through the Prime Contractor to the Port and affected Union within 48 hours. Section 7. Individual seniority will not be recognized or applied to employees working on the Project. This provision will not interfere with or supersede the use by individual Contractors of “call lists” maintained by such Contractor pursuant to addenda to the local Collective Bargaining Agreement between such Contractor and a Union signatory to this PLA. Section 8. The selection of craft foremen and/or general foremen and the number of such foremen and/or general foremen required shall be entirely the responsibility of the Contractor. Craft foremen shall be designated working foremen at the request of the Contractor. Craft workers covered by this PLA will, in the normal day- to-day operations, take their direction and supervision from their xxxxxxx.

  • Change Control Procedures (a) No changes or additions may be made to any Work Order without the written agreement of LAUSD as evidenced by a duly executed Change Order. (b) Contractor will not take an action or make a decision which may have a material effect on LAUSD or which adversely affects the function or performance of, or decreases the resource efficiency of, the Services, including implementing changes in technology or equipment and software configuration, without first obtaining LAUSD’s written approval, which approval LAUSD may withhold in its sole discretion as respects any change which may have an adverse effect on LAUSD or the Services.

  • Switching System Hierarchy and Trunking Requirements For purposes of routing PNG traffic to Verizon, the subtending arrangements between Verizon Tandem Switches and Verizon End Office Switches shall be the same as the Tandem/End Office subtending arrangements Verizon maintains for the routing of its own or other carriers’ traffic (i.e., traffic will be routed to the appropriate Verizon Tandem subtended by the terminating End Office serving the Verizon Customer). For purposes of routing Verizon traffic to PNG, the subtending arrangements between PNG Tandem Switches and PNG End Office Switches shall be the same as the Tandem/End Office subtending arrangements that PNG maintains for the routing of its own or other carriers’ traffic.

  • Safety Procedures The Contractor shall: (a) comply with all applicable safety regulations according to Attachment H; (b) take care for the safety of all persons entitled to be on the Site; (c) use reasonable efforts to keep the Site and Works clear of unnecessary obstruction so as to avoid danger to these persons; (d) provide fencing, lighting, guarding and watching of the Works until completion and taking over under clause 10 [Employer's Taking Over]; and (e) provide any Temporary Works (including roadways, footways, guards and fences) which may be necessary, because of the execution of the Works, for the use and protection of the public and of owners and occupiers of adjacent land.

  • Standard Operating Procedures Standard Operating Procedures shall not contravene the Canada Labour Code, the Canadian Human Rights Code, or the Collective Agreement, and an allegation of such contravention is subject to the grievance procedure.

  • Hiring Procedures Nothing contained in this Article 4 shall impair any of the rights of the Employer to hire new or additional employees to meet the employment needs of the Employer, in accordance with the terms and provisions of this collective bargaining Agreement or to meet the obligations of the Employer under Article 2, Section H of this Agreement or to take affirmative steps to comply with any requirements under any applicable Federal or State law prohibiting discrimination in employment.

  • Procedures for Providing NP Through Full NXX Code Migration Where a Party has activated an entire NXX for a single Customer, or activated at least eighty percent (80%) of an NXX for a single Customer, with the remaining numbers in that NXX either reserved for future use by that Customer or otherwise unused, if such Customer chooses to receive Telephone Exchange Service from the other Party, the first Party shall cooperate with the second Party to have the entire NXX reassigned in the LERG (and associated industry databases, routing tables, etc.) to an End Office operated by the second Party. Such transfer will be accomplished with appropriate coordination between the Parties and subject to appropriate industry lead times for movements of NXXs from one switch to another. Neither Party shall charge the other in connection with this coordinated transfer.

  • Medical Procedures 21.01 The Board shall distribute a copy of its Operating Procedures for administration of prescribed medication to pupils in schools and Procedures for health support services to each Teacher. 21.02 In accordance with Operating Procedure Special Education Services 8, a Teacher may refuse without prejudice a request to administer medications except in life-threatening situations.

  • Important Information About Procedures for Opening a New Account To help the government fight the funding of terrorism and money laundering activities, Federal law requires all financial organizations to obtain, verify, and record information that identifies each person who opens an account. What this means for you: When you open an account, you are required to provide your name, residential address, date of birth, and identification number. We may require other information that will allow us to identify you.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!