B Working Conditions at School Buildings
B Working Conditions at School Buildings Sample Clauses
Related to B Working Conditions at School Buildings
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
Alterations, Additions, and Improvements Subject to the provisions of this Article IV, Lessee may make any alterations, additions, improvements or other changes to the Premises and the Relevant Assets as may be necessary or useful in connection with the operation of the Relevant Assets (collectively, the “Additional Improvements”). If such Additional Improvements require alterations, additions or improvements to the Premises or any of the Shared Access Facilities, Lessee shall notify Lessor in writing in advance and the parties shall negotiate in good faith any increase to the fees paid by Lessee under the Site Services Agreement by Lessee or otherwise provide for reimbursement of any material increase in cost (if any) to Lessor under the Site Services Agreement that results from any modifications to the Premises or the Shared Access Facilities necessary to accommodate the Additional Improvements, or as otherwise mutually agreed by the parties. Any alteration, addition, improvement or other change to the Premises, Relevant Assets or Additional Improvements (and, if agreed by Lessee and Lessor, to the Shared Access Facilities) by Lessee shall be made in a good and workmanlike manner and in accordance with all applicable Laws. The Relevant Assets and all Additional Improvements shall remain the property of Lessee and shall be removed by Lessee within one (1) year after termination of this Lease (provided that such can be removed by Lessee without unreasonable damage or harm to the Premises) or, at Lessee’s option exercisable by notice to Lessor, surrendered to Lessor upon the termination of this Lease. Lessee shall not have the right or power to create or permit any lien of any kind or character on the Premises by reason of repair or construction or other work. In the event any such lien is filed against the Premises, Lessee shall cause such lien to be discharged or bonded within thirty (30) days of the date of filing thereof.
WORKING CONDITIONS 9.01 Lunch periods shall be at mid-shift. 9.02 The Employer shall allow each employee two (2) breaks of ten (10) minutes each, but not more in a work shift. Time of breaks shall be mutually agreed upon. 9.03 Essential protective clothing including welder’s gloves, protective vests or leather jackets, noise abatement devices, and rainwear shall be supplied at no charge to the employee. In the event that an employee does not return the foregoing items supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any money owing to the employee. 9.04 Chemical or flush toilets shall be provided from the commencement of work on all jobs. Where the sewer or chemical toilets are not available, sanitary toilet facilities shall be provided as called for in local sanitary regulations. Toilet houses shall be painted, at least on the inside, and cleaned out daily. Toilet paper will be provided. 9.05 Where there is no running tap water available, drinking water in approved sanitary containers shall be provided. Paper cups will be supplied. Salt tablets shall be supplied during the summer months. 9.06 If requested by the Union or employee, the Employer will provide within three (3) calendar days, a termination slip which shall state the reason for the employee’s termination and whether or not he is eligible for rehire. 9.07 Adequate time will be allowed prior to quitting time for picking up tools. 9.08 A lock-up shall be provided for employees for drying clothes, and dressing room, as well as lunch room. The lock-up shall have tables, and benches with provision for drying clothes. Such lock-up shall have windows and venting with adequate lighting and provision for continuous heat twenty-four (24) hours a day. The Employer shall be responsible for having the lock-up cleaned out daily and kept cleared of building material and other construction paraphernalia. Additional shelters shall be provided for employees to eat their lunch as may be required. 9.09 In case of fire or burglary on property or premises provided by the Employer, the Employer shall protect the value of an employee’s work clothes up to a total of three hundred and fifty dollars ($350.00). The Employer shall also provide fire and burglary insurance for the employees required tools to a total value of the tools, tool for tool, make for make, provided an inventory of tools and clothing is filed with the Employer. The Employer shall supply the required forms and obtain the inventory from each employee. The employee shall receive a signed copy of the inventory from the Employer. Coverage will commence at the date of the filing of the inventory with the Employer. Where an employee fails to file an inventory his rights to submit a claim shall be waived. (a) All mechanics, welders, servicemen, tire servicemen, drill doctors, steel sharpeners, bodymen painters, and mechanics and welder apprentices who request coveralls shall have these supplied and cleaned by the Employer. There shall be one change a week available in the employee’s proper size. Employees are expected to take reasonable care of coveralls supplied. In the event that an employee does not return the coveralls supplied to him by the Employer, the Employer shall charge the cost of same to the employee and deduct this cost from any monies owing to the employee. When requested, coveralls shall be supplied on a temporary basis to employees who assist on work as described above, or where the Employer and the Union mutually agree that coveralls are required. (b) Employees entitled to receive coveralls as provided herein may obtain an additional change of coveralls in any one week providing the condition of the coveralls requires a change. The shop xxxxxxx shall use discretion in authorizing the additional change. (c) All shops shall provide adequate clean-up facilities. 9.11 The Employer shall pay the cost of obtaining operators’ licences other than those required under the Motor Vehicles Act for employees covered by this Agreement. 9.12 No employee will be permitted to use his own motor vehicle in a manner which is unfair to other members or against the best interest of the Union. 9.13 Each employee being terminated will be given one (1) hour’s notice of termination by the Employer or one (1) hour’s pay allowed in lieu thereof. Heavy duty mechanics and apprentice mechanics may utilize this hour to gather together their tools and put them in shape for their next job. 9.14 When a mechanic leaves the employ of the Employer, the Employer shall be required to pay cost of shipping mechanic’s tools. Tools shall be shipped within forty-eight (48) hours of his leaving his employment, subject to the same conditions as govern transportation. When an Operating Engineer elects to transport his own tools to and from the jobsite, the employee shall be paid the rate of two dollars and seventy-five cents ($2.75) per one hundred (100) pounds per one hundred (100) miles. (e.g. $2.75 x 528 pounds x 273 miles = $39.64). Where the Employer fails to comply with the above, the employee shall be deemed to be still on the payroll of the Employer and shall receive his usual wages and all other conditions of this Agreement until there is compliance with these provisions. 9.15 Where an employee is involved in an accident while on the job and as a result is unable to perform his work, he shall receive a full day’s pay for the day of the accident.
Unsafe Work Conditions No Employee shall be disciplined for refusal to work on a job which in the opinion of: (a) A member of a safety committee; or (b) A person designated by a safety committee; or (c) A safety officer after an on-site inspection and following discussion with a representative of the Employer, does not meet the standards established pursuant to the Workers' Compensation Act.
Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.
Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Building and Improvements Lessor shall obtain and keep in force during the term of this Lease a policy or policies in the name of Lessor, with loss payable to Lessor and to any Lender(s), insuring against loss or damage to the Premises. Such insurance shall be for full replacement cost, as the same shall exist from time to time, or the amount required by any Lender(s), but in no event more than the commercially reasonable and available insurable value thereof if, by reason of the unique nature or age of the improvements involved, such latter amount is less than full replacement cost. Lessee-Owned Alterations and Utility Installations, Trade Fixtures and Lessee's personal property shall be insured by Lessee pursuant to Paragraph 8.
ALTERATIONS AND IMPROVEMENTS Tenant shall make no alterations to the buildings or improvements on the Premises or construct any building or make any other improvements on the Premises without the prior written consent of Landlord. Any and all alterations, changes, and/or improvements built, constructed or placed on the Premises by Tenant shall, unless otherwise provided by written agreement between Landlord and Tenant, be and become the property of Landlord and remain on the Premises at the expiration or earlier termination of this Agreement.
